If there are no gas or solar heaters installed, an above-ground pool will typically need no more than 1 hp (3/4 hp can easily be used with less than 10,000 gallons of pool water.) An In-ground pool without spa or heater up to 25,000 gallons can easily be run with 1 hp. Depending on filter size, 1 1/2 hp is very standard.

We are pleased to introduce our new AGDI-02 deck inserts for wooden decks. This new deck insert will enable you to use either the stainless steel volleyball sets or the aluminum volleyball sets with your pool. The AGDI-02 is made of aluminum so that it will never rust. After your new deck insert is installed, you will simply drop the pole into the receiver and string your net across the pool. Caps are not available with the AGDI-02.

Yes. As soon as there is any water being placed into the pool during the construction, a fence is needed around the pool.

That depends on the size of the house , what pump will be needed and whether the property is a newly build or older property. For a four bedroom newly built house with good insulation, a 11 Kwp will need about 300m of ground loop.

Above ground swimming pools with a capacity of less than 5,000 gallons would not require a permit. This would include most pools less than 16 feet in diameter. (You will need to check with Planning and Zoning if a certificate is required.)

The 5 bedroom home is approximately 15' wide X 28' long. The 3 bedroom home is approximately 12' wide X 23' long. Pools have a shallow end 3'2" +/- deep and a deep end 5'6" +/- deep.

Running water doesn't significantly effect algae. The gravel and plants in a natural stream act as a biological filter, and streams usually are not stocked heavily with fish. You need a pump if you want a waterfall or fountain or other moving water feature. It is quite possible to have a clean, clear pond without water running in it. However, if you heavily stock your pond with fish, and have few plants, you will need a pump and filter to maintain reasonable water quality.

Both Ground Source and Air source heat pumps can be linked into existing heating and hot water systems and will work well and efficiently. However they work even better well with underfloor heating.

Two to three feet is ideal.. Any more than that and you run a bigger risk of the pool caving in. You always want to make sure the water level is higher than the dirt. If the pool is to far into the ground and the ground around it gets to wet it could easily cave in. It is also a good idea to wait at least two years after the pool is installed before draining it. This give the dirt around it plenty of time to pack. Even then the pool should be drained and refilled in a day or two.

There are times when a top rail or upright get damaged and the rest of the pool is still in good shape. To replace these parts you could start by checking all the local pool stores and see if anyone in your area handles parts for that model. You could check with the manufacturers web site and see if they could be of any help.

No. We can, however, install a rink OVER your in-ground pool. Custom Ice has a special staging system that is designed to cover your in-ground pool and then we install our rink materials on this platform. We only recommend this if you do not have

We believe we have the strongest pool on the market and our patented braceless support system ensures easy self-installation.

All pools are fitted with a Hydrostatic valve in the floor this balances the outside pressure against the inside pressure of the pool which prevents the pool from lifting. If the pool is installed to manufacturer's requirements as set out in the install manual, it would be very uncommon.

Pool and community gate entry device policies vary from community to community. You will need to contact the Tri-City office by calling the TCPM office at 480-844-2224. I am planning to leave town for a few weeks. The last time I left town a pipe ruptured in my unit and flooded my home as well as my down stairs neighbor. No one contacted me to let me know. How can I avoid this in the future.

The slot should be cut 1 1/2" down from the center of the ridge on both sides. This is the same if you have trusses or a 2X ridge board. Cutting the slot larger will not increase the ventilation and may cause problems with the installation of the ridge vent. If you have a wide ridge beam the vent will have to be split. Either view our variation details or call 800-837-8368.

It is 10 meters/33 feet per 8 meters/26 feet. Its depth goes from 80 cm/2.6 feet to 1.60 cm/5.30 feet.

Our lap pool is approximately 35 feet long and 19 feet wide. It was designed for wheel chair accessibility and with the safety of children in mind. The resort next door, The Placencia has the largest pool in the country, and offer access to our guests with the purchase of a beverage or a meal.

A heat pump allows you to heat your pool or spa economically. Depending on energy costs, an AquaCal heat pump can save you up to 80% over propane gas, 50% to 70% over natural gas, and over 600% against electrical resistance heaters found on most spas. This is the reason why thousands of customers choose a heat pump to heat their pool, rather than alternative types of heaters.

Anything but grass. Grass will grow under the pool and up through the liner or up the wall between liner and pool, or up the inside of the uprights creating great habitat for bugs and wasps. I prefer some type of rock landscape and it is best to use plastic under it because the water splashing out of the pool makes any vegetation grow very quickly. Plants should only be container type plants. They are easy to move when changing liners and they don't grow roots under the pool.