Use Sticker-Off! Decal Adhesive Remover. Just spray it on the adhesive, allow a few minutes for the product to penetrate and then wipe away with a clean, soft cloth.

Most bedding retail stores will assist with the disposal of old bedding as a value-added store service. Ask about this type of service before you purchase!

Yes, most definitely. Mattresses that are old will have much higher levels of dust mites and droppings, dead skin, fungal spores, bacteria and germs. Our process is extremely effective and will make them clean and fresh again.

Unlike other online mattress retailers, we'll remove your old mattress at no cost to you. Because of sanitation requirements we do have to reserve the right to refuse to take an old mattress that is heavily soiled. Unfortunately, we cannot take futons, sofa beds or bed frames.

You should never place a new mattress upon an old sprung base. Although it may look in good condition, the internal springs will have worn in the same predominant sleeping areas as the previous old mattress. Which means the new mattress will sink and follow the contours of the worn areas. This will not only permanently damage the new mattress, but also give you an uncomfortable sleeping unit.

More often than not, YES! Let the stained item soak in a solution of Stain Solver liquid overnight. If the stain is still there, increase the concentration and try it again. Continue to increase the concentration until you succeed or fail. Remember, you have NOTHING to loose. Until such time as the stain is removed from the garment, it is headed for the rag pile.

The best thing to do is probably bag it up and take it to a landfill. At least it’s organic and will rot away. Make sure you don’t put the infested mulch somewhere where you could be held responsible for someone else’s artillery fungus problem. This is out of my field, but it has been suggested that the infested mulch could be put in a yard waste-composting facility. But you really need to ask this question to a “compost expert.

What do you do when the perfect mattress doesn't provide the same support that it once did? You try to find the same one, or the closest thing to it. Mattress lines are always evolving and tend to change every year or two. This means it might be hard to find the exact same mattress. However, by determining your preferred comfort level, you can find one that feels just like it.

Old beds turn up in the oddest places – in the bottom of lakes, by the side of the road, in the classified ads of the newspaper. Clearly, people don't know what to do with old mattresses! It estimated that nearly 70% of old beds stay in circulation, handed down like heirlooms to children and other family members. This is especially harmful for children, whose active, developing bodies require the support of a good quality mattress.

Children should have a comfortable, supportive mattress to get the deep restorative sleep their bodies need to grow. If your old sleep set was uncomfortable and lacked support, then it probably won't help your kids get a good night's sleep either. No! Sealy Posturepedic sleep sets offer correct support regardless of comfort level or price. Whether your Sealy Posturepedic is soft or hard, it will give you the same correct back support you need.

We have found that a new mattress, if used on a regular basis, would benefit from a cleaning after about 6 months use.

Removal of existing appliances can be done at a charge of ?10 per appliance, however this must be agreed with electricshop at the time of ordering and appliances must be disconnected ready for transporting beforehand. Please note: this service can be offered only when deliveries are made by electricshop staff and not third party couriers or some manufacturers.

Yes! The new cover will not stick or fit properly if applied over an old covering, even if the original is in good condition. In fact, you'll spend more time removing the old cover and cleaning up the camera than you will putting on the new cover. The ease of stripping the old cover varies, but in general the older the cover, the more effort needed to remove it. Most cameras made since the mid-70's can be stripped off quickly; almost as if you were removing tape.

In order to get a perfect fit, we recommend that the old tops be removed prior to templating. Not removing the old tops can result in gaps between the stone and the wall and backsplashes that don't fit properly. Also, since Formica-type tops hide cabinets that are not level, your installation could be delayed significantly if this is discovered on the day of installation.

Yes we can, the cost is ?20.00 per hour to remove the hardboard. We put the rubbish at the front of the house.

No, unfortunately we cannot remove old beds, because Silentnight do not have the infrastructure to deal with the disposal of old items. However, most good councils offer a furniture removal service that will arrange disposal of such items.

This is a service limited to certain manufacturers. Please contact us on 0800 028 0513 for details. Back to top

It’s not always necessary to remove the old veneer but it should be intact, not bubbled or cracked, and firmly attached, if you are even considering veneering over it. If you are forced to remove old veneer, a heat gun and a putty knife are essential tools. You must first apply heat to the edge of the veneer to loosen the glue. Then start with the putty knife under the edge and lift as you go. This process can be slow and the veneer will likely come off in small chunks.

Removing old decals is a job all to its own. There is no easy simple way to remove decals. It always takes time and effort. After decal material is removed, adhesive residue usually remains. Any decals that do not have clear coat paint will be easier to remove. Use a heat gun to loosen the decal and begin to lift the decals. Not too much heat to burn the paint, and use extreme caution with plastic parts. Heat guns are hot enough to melt plastic.

It's a matter of temperament, if you want the leaves on the stem or not, some species look "wrong" with old leaves others look "wrong" with out leaves.