Obviously oil and grease are the enemies of adhesion. If they are not permanently removed the strip will not adhere to those areas, and, with the movement of the traffic, it will move, often taking with it other pieces nearby. Particular attention should be paid to places where buses and lorries are likely to stop and spill drops of oil from the engine (e.g. at traffic lights).

If the stain is one or two pavers, replacing them with new pavers is the easiest way. Depending on the paver, some can be flipped over rather than replaced. For our recommendation on the right cleaner to use for your particular application, contact us. See similar questions...

I use a homemade brew that works very well, and is inexpensive. It removes grease and cleans up without streaks. K2R is a very good oil-soaker; used after a fuel tank incident in fuselages, it does a good job. However, California has just -expanded- the list of illegal chemicals to keep us safe from ourselves.. I haven't seen any at Albertson's for close to a year. K2R can be found in Wal-Mart. See similar questions...

The OzzyMat will trap the large solid particles and the rest will be rinsed through the OzzyMat and into the fluid reservoir in the base of the SmartWasher. The Ozzies in the reservoir will eat away at the hydrocarbons, breaking them down into carbon dioxide (which is dispersed into the atmosphere as a gas) and water (which goes back into solution and eventually evaporates). This combination of the OzzyMat and Ozzy leaves you with nothing but clean solution to work with. See similar questions...

Yes, once the floor or any surface is sealed the surface can be impervious (not allowing entrance or passage) to many chemicals including: salt, petrochemicals, UV radiation, and water. This makes decorative concrete flooring an excellent choice for any interior or exterior especially driveways and garage floors. Of course you don't want to leave any spills on the surface for a long period of time. See similar questions...

Oil and grease stains can be difficult to remove completely because they penetrate the concrete surface rapidly. If an oil spill occurs, stop it spreading by encircling with sand, dirt or sawdust. Soak up as much surface oil or grease as possible with an absorbent cloth or powder. Cover residue stain with a poultice made of 1 part lime to 2 parts mineral turpentine. Spread a 5mm layer of the paste over the stained area ensuring a margin of 50 to 100mm around edges. See similar questions...

Techni-Seal's Dirt and Grease Cleaner is recommended by manufacturers. There are also other similar products that will work too. See similar questions...

Once activated, Ozzy and his friends are constantly eating. The rate at which the hydrocarbons will be remediated is approximately 80% every 7 days, assuming the system is operating optimally (fluid temperature between 100 and 110 degrees F, OzzyMat changed monthly). Oil and grease analyses performed on used SmartWasher fluid consistently average around 1400 parts per million (versus used non-bioremediating aqueous cleaners that average 20,000 parts per million or more). See similar questions...

Stains can be removed from concrete with dry or mechanical methods, or by wet methods using chemical or water. Common dry methods include sandblasting, flame cleaning and shotblasting, grinding, scabbing, planing and scouring. Steel-wire brushes should be used with care because they can leave metal particles on the surface that later may rust and stain the concrete. Wet methods involve the application of water or specific chemicals according to the nature of the stain. See similar questions...

More often than not, YES! Let the stained item soak in a solution of Stain Solver liquid overnight. If the stain is still there, increase the concentration and try it again. Continue to increase the concentration until you succeed or fail. Remember, you have NOTHING to loose. Until such time as the stain is removed from the garment, it is headed for the rag pile. See similar questions...

Stains are simply different molecules. If you break apart a molecule you change its nature and it no longer produces color or a stain. The Stain Solver oxygen ion actually attacks and blasts apart stain molecules. Soaps simply try to "lift" stain molecules out of a fabric and transport them to your drainpipe. Most soaps can't lift all of the stain from a fabric. See similar questions...

Simple Solution Stain and Odor Remover works on both new and old stains and odors; removing all types of organic stains and odors including ones caused by urine, feces, blood, dirt and grass. Simple Solution is also wonderful at removing other types of household stains such as stains from coffee, juice, red wine, sodas, and chocolate. See similar questions...

We remove most of the stains. Sometimes, there are some stains that cause discoloration of the carpet. In this case we are unable to remove the stain. See similar questions...

While our pre-moistened hand wipes are excellent for on-the-spot cleaning of grease, oil, and grime, they are not intended to be applied to the face. We recommend that they be used for the clean-up of hands and other non-porous surfaces instead. See similar questions...

DEPENDS ON THE NATURE OF THE STAIN There are two types of stains - those that are in the intermolecular spaces or voids of plasatics . and those that become part of the actual polymeric material of the plastic or other material to be cleaned (essentially "dying" the material) Dealing with the first example, rust clearly is water-related and produces stains in gelcoat or vinyl only in so far as it penetrates the pores and voids. See similar questions...

Red wine stains are easiest to remove if they are still wet. If you can't deal with the problem immediately, lay a wet towel over the carpet area or put the affected clothing to soak until you can treat it. The following methods work almost all of the time: Wine Away Red Wine Stain Remover - This is by far the most effective product we have found. See similar questions...

SaniHandles® are made of a durable, long lasting super hard plastic which will withstand any type of cleaning products, as well as plain soap and water. See similar questions...

Yes. Stains often penetrate deep into the pours of the stone and we can remove them with a customized poultice solution designed to remove the specific type of stain. See similar questions...

Our process is not a wash or stain remover, it is a odor remover and sanitizer. It kills all bacteria and fungus that's living in your equipment, and removes the most nasty odors. Washing equipment is not a good idea because it breaks down the fibres and accelerates rust on metal. You can wash your outer garments in your washing machine, those are normally what gets stained. See similar questions...