You should certainly protect your deck from unnecessary moisture intrusion and the harmful effects of the sun's ultra-violet rays. Use of a penetrating stain, containing water repellant ingredients in most cases will protect your deck best. The pigment in the stain will absorb the ultra-violet rays from the sun and protect the wood fibers from degradation. In most cases a stain will need maintenance every 2-4 years while clear sealers require maintenance every 1-2 years.

I prefer to use a large brush or a mop. You want to get large amounts of Stain Solver liquid on the deck surface. Hand pump sprayers often apply too little solution to the surface. If you must use a sprayer, make sure the product has dissolved completely or you will clog the nozzle! Also, be sure you spray on lots of liquid. See similar questions...

Ans: The insulating additive will help keep the deck cooler while providing a slightly slip resistant surface. See similar questions...

On a horizontal surface, Penofin may be expected to perform for an average of 9-18 months and 3-5 years on a vertical surface. The time will vary depending on the percentage of sunlight, weather, etc... Yes. All Penofin wood finish colors contain the same ingredients, just different amounts of colored pigments. However, you will not be able to make the surface lighter by applying a lighter shade. As always, you should test a small area before use. See similar questions...

No, "New Wood Defender" is recommended on pressure treated wood, as well as Cedar and Redwood during the first year of weathering. Wood Defender is a latex based product used to stabilize new exterior wood. This product is treated with fungicide to prevent the growth of mildew. See similar questions...

Even though the lumber may be kiln-dried before treatment, using water-borne preservatives restores moisture to the wood. Too much moisture in the wood may prevent the stain or paint from penetrating the wood sufficiently. It is best to test the wood by painting or staining a scrap piece to see if it applies properly. If not, wait until it does. A water repellent should be applied annually. Do not use latex paints. Semi-transparent, oil-based stains work best. See similar questions...

A film forming coating is a product that does not penetrate into the wood completely. A product that does not penetrate can result in premature peeling and or flaking. All of our wood deck stains will penetrate into the wood when applied properly. See similar questions...

Crystal Clear sealers will not filter out UV rays for very long or at all. A transparent tinted sealer acts like sunglasses for your wood, filtering the UV rays and prolonging discoloration. You can use a clear sealer but it will gray very quickly. See similar questions...

Pressure treated wood will not rot, but it will cup, warp, split and splinter if it is not sealed so water will not absorb and then evaporate in a number of cycles See similar questions...

The product does not require traditional timber treatments or any other kind of treatment BUT it will of course require normal cleaning with a pressure washer or hose/brush with a weak bleach solution or proprietary deck cleaning product to remove surface debris. See similar questions...

Typically, all wood fence should not be stained or painted until a minimum of 60 days after installation. We recommend you check with your local paint store for the proper method of application. See similar questions...

Answer: The insulating additive will help keep the deck cooler while providing a slightly slip resistant surface. See similar questions...

The available historical evidence shows that Eichler used stains, not paint, on his homes, inside and out. One can speculate that, at least for the vertical-grooved siding, stains were employed so that the grooves stayed crisp and clean (the edges weren't softened by the paint), and some of the grain of the wood showed through (redwood siding was used throughout the 1950s). It is also possible that Eichler used stains because labor and materials costs were lower than for paint. See similar questions...

Jennings joinery prefers to paint or stain prior to glazing and assembly to properly seal the product. Also when using 6.38 Laminated glass (which is thicker than normal glass), if the inside rebate is not painted or stained prior to glazing then after the product is glazed the unsealed surface behind the glass edge is visible and un protected. Also after the bi-folds have been installed it is very difficult to coat the top and bottom of the doors to seal then correctly. See similar questions...

When you're looking for a painted-kind-of-look to match you home exterior, or when the deck has been totally neglected, solid stains hide and conceal any cosmetic imperfections that the lumber may have. See similar questions...

The answer depends on several factors. Strong, light hemlock makes a superb painting surface. Cedar, an excellent stain grade wood and is highly resistant to rot and insects. Mahogany's tight, smooth grain surface is very weather-resistant and also an excellent stain grade wood. See similar questions...

That will probably seal them in. It may solve your problem, but will give a pebbly appearance to your paint job. Each repainting will seal in the artillery fungus even more. There are no fungicides legally registered (by EPA) against the artillery fungus. Bleach, if it worked, would be very temporary, as it leaches out with each rain. We tested 14 different fungicides in the laboratory, but have to take the experiment to the field. See similar questions...

All of our products are high end. Certain products will do better then others depending on your particular environment or type of wood that you have. If you came to our store looking for a certain brand name then we would suggest sticking with that. Please email us if you have any questions and we will be more then happy to suggest a certain brand depending on your situation. See similar questions...

That's an opinion call, but if you do, you will have to do it again every year. We recommend letting it grey naturally and washing it 2 or 3 times/year with Sunlight dishwashing soap to keep it clean and pollution-free. See similar questions...

Creative Wood Products has their own private label stain called Deck Gold. Deck Gold is an oil based semi-transparent sealer and stain in one. It is a unique blend of resin, pigment oil, mildewcide and UV protectors that penetrate deeply into the wood to protect and preserve it. Deck Gold can be used on all types of wood except Redwood. We also carry Superdeck Products, Superdeck is a natural oil, transparent stain designed to maintain the beauty of your wood. See similar questions...