UMass Dartmouth provides wireless service in designated areas on the main campus. These areas include the cafeterias, large lecture halls, common areas, etc. For a full description of all the locations where wireless is available, please go to http://www.umassd.edu/cits/wireless/accesspointmap.pdf. UMass Dartmouth does not condone or promote the use of personal access points in the dormitories. Rogue access points may not be secure and could allow unwanted access to the campus network.

Please refer to the Physical Network Access policy. In general, it is not recommended that you extend the network wirelessly or by other means. If you would like to have wireless in your area, please contact UITS Network Engineering. Wireless networks should be open to community members and service should be consistent across the campus. Yes. UConn wireless requires you to register your session at the UConn Wireless login page before you can start a wireless session.

Wireless networking is enabled by default and will function in most environments without additional configuration. All of the features of the wireless networking can be configured using the SBG1000's built-in HTML user interface. Motorola recommends that you modify the ESSID (Extended Service Set Identifier) and enable WEP (Wired Equivalent Privacy) to secure your wireless network. The following procedure will assist you with the basic configuration for your wireless network.

No, you can also connect up to 16 PSP systems in the vicinity directly through ad-hoc mode for gameplay without any additional hardware. PSP Blender game downloads fully support multi player options.

It is possible to connect to the Service from any WiFi Internet connection. However, if the wireless access point in your office is behind a firewall or if other network policies are imposed on the office network environment, this may affect your Internet connectivity and prevent connection to the Service.

No. Wireless access points, switches, and routers are not allowed on ResNet. This is because of the way IP addresses (the way your machine is identified on the network) are assigned. Wireless can easily be used by other people you do not intend to be using your access point - allowing them to decrease your bandwith as well as possibly harm your computer.

Yes, it is possible as long as you are able to get connected to an Internet connection which does not block SIP or VoIP traffic. Please note that the supported modems are the mio Box and 2Wire 2700HG.

The strictly legal answer is NO. According to FCC Part 15 Section 15.204 "Only the wireless antenna with which an intentional radiator is authorized may be used with the intentional radiator". Those people in countries other than the US will need to consult their own regulations. If you are not sure if the antenna that you plan to use is certified with the radio system, ask the radio or antenna manufacturer/vendor.

Wireless networking is a technology that allows computers to communicate using standard network protocols without the use of any cables or phone lines.

KwiFiManager - a task bar utility for KDE that mimics the ORiNOCO client utility. Works with wireless tools. Physical Connections: This will depend largely on the mode in which the Access Point is being used. In its most basic function, Access Point mode, the AP must be plugged into a known good outlet, and connected via straight-through patch cable to a switch. Logging into AP: The settings for the AP will most likely be accessible via a web-based interface.

A wireless access point is a hub that allows computers to connect to each other wirelessly. A wireless access point is often connected to a router through an ethernet (hardwired) connection.

The primary benefit of Auto-Negotiation is the automatic connection of the highest performance technology available without any intervention from a user, manager, or management software. If Auto-Negotiation exists at only one end of a twisted-pair link, it finds that the Link device does not support the auto-Negotiation mechanism. Instead of exchanging configuration information, it examines the signal it is receiving. If Auto-Negotiation discovers that the signal it is receiving.

There are a number of Wi-Fi phones that support SIP, like the UTStar phones and the Nokia E series which provide SIP and GSM. These can be set up to use your access point. They can also search for other access points, so you can take them with you when you travel and make calls from any available access points.

Unsecured wireless access points are a prime way for hackers to get into the campus network. If you must have a wireless network in your apartment, please configure your access point so that it only allows known computers to use it. This should be a configurable option on most access points that allows connections by the unique network MAC address.

Directional antennas should be used for point-to-point wireless transmission. The type of directional antenna depends upon the power output, cable type and length, height, distance, data rate and terrain. We recommend the use of a range table to estimate the wireless antenna types. Whichever wireless antenna you choose, make sure that it is FCC certified with your radio!

Sometimes there is no difference; sometimes there is a big difference. There is no official definition of what a gateway is. Many manufacturers call their wired broadband modem/router connections gateways. However, in general, a wireless gateway is an access point with NAT routing and DHCP server. An access point is a wireless gateway without NAT routing and DHCP server.

Do customers have to have a phone line in addition to the satellite connection? No. WildBlue offers an efficient 2-way broadband connection that requires no phone lines.