YELLOW CHARGING LIGHT.......... Pulses while PULSE POWERTM is charging the battery and simultaneously eliminating "memory effect" (voltage depression). Yellow Charging Light also illuminates each time a pulse charge is performed during maintenance mode (once every 15 - 45 seconds depending on battery profile).

If the Low Battery light comes on you should either switch to using the wall adapter or change to a fresh nine volt battery. This yellow light is set to come on when the battery power drops to 5 volts. You should not attempt to make remedies with the yellow light on, it will not make proper remedies when the light is on. When replacing the battery be cautious. See similar questions...

GREEN READY LIGHT.......... flashes when the PULSE POWERTM charging cycle is complete and has entered the maintenance mode. Battery is ready for use. Battery can be removed and used now or anytime during the charge cycle without ever damaging the battery. If you leave your battery in the charger, the yellow charging light blinks on periodically to let you know that your battery's charge is being maintained at the proper level. See similar questions...

ORANGE OVERHEAT LIGHT..........Illuminates if PULSE POWERTM determines that internal temperature exceeds a safe level and terminates charging cycle. Battery may be charged and can be immediately used. If left on the charger, charger will transfer to maintenance mode when safely cooled. See similar questions...

RED DEFECTIVE LIGHT..........Illuminates if your battery is defective by PULSE POWERTM's patented microprocessor. PULSE POWERTM may be able to recover a defective battery. Retry 4 or 5 times by removing and replacing battery. Should Red Defective Light continue to light, battery can no longer be charged and should be disposed of properly. PLEASE REMEMBER....NEVER THROW YOUR OLD BATTERIES IN THE GARBAGE - RETURN BATTERIES TO WHERE YOU BOUGHT THEM. See similar questions...

The Omron Instant Ear Thermometer will display this indicator after the On-Measure Button is pushed if the thermometer's own temperature is too cold or too hot to operate. The operating range is 50 to 104 degrees Fahrenheit. Put the thermometer in a room within the operating range. Wait 30 minutes and take the measurement again. See similar questions...

gt;. "Status" indicator shows RED when the charger is ready and "Charger" indicator shows flashing Green when waiting for battery pack. gt;. "Charger" indicator show RED and GREEN alternatively when battery pack has more than 90% charged. See similar questions...

When the battery is running low, the light will begin by flashing slowly. At this point you can still use the doppler for some time. As the battery becomes too low, the light begins blinking more rapidly and will eventually shut the doppler off. The doppler unit requires regular 9 volt batteries that can easily be replaced by removing the small panel in the back of the doppler. See similar questions...

During a false alarm, and for 16 hours after a false alarm, PeaceMaker's indicator light and built-in beeper will flash/beep to inform you that PeaceMaker silenced your siren, and the reason for the silencing. See similar questions...

When used in a signal with solid red/yellow/green arrows, means that permissive (yield to oncoming traffic) left turns are allowed - used when the through signals turn red to allow oncoming traffic to have both a through green and lagging protected green left arrow in order to prevent a "yellow trap", in which left-turning cars already in the intersection are not able to cross oncoming lanes to clear the intersection. http://projects.kittelson. See similar questions...

In the United States, this is found mostly in the Boston, MA area. It means that an all-pedestrian phase is in effect, and no cars are going thru the intersection. It was implemented before pedestrian signals came into use. If you are driving and see this, stop. Photos of this phase in use are at http://www.massroads.com/gallery.php?page=red_and_yellow . In some European countries, red-yellow precedes green and often coincides with the yellow phase for cross traffic. See similar questions...

Long answer - If you were to add such a device, there are three ways to do so. First, a simple timer could be used that would keep track of the length of time the unit has operated and turn on a light after a given length of time. Several companies that provide such a light do it this way. It is the least complicated and least costly method. Unfortunately, it really does not measure anything that tells that the filter needs to be replaced. See similar questions...

Means that the crossroad has a flashing red, but that the signal goes into normal operation if a car triggers a sensor on the crossroad by waiting a given amount of time. Flashing green/red resumes soon after. (These have likely been removed from the state.) Same as DE's, but only found at crosswalks, and triggered by a button pushed by pedestrians. May be located at a side road or crossroad with a stop sign so the cross traffic can take advantage of the red time on the main road. See similar questions...

The following are the common signs that you are not getting enough bright light in the beneficial wavelengths: See similar questions...

The Display Resolution Indicator, turned on or off in the Window Preferences, shows at the bottom of the viewer window the resolution of the currently loaded panorama. The text at the left indicates the type of VR it is - "cubic, equirect, cylinder" - followed by the dimensions. For example, "cubic: 6 x 768 x 768" indicates there are six cube faces, each having a cube face size of 768 pixels. See similar questions...

The first letter of the match code is the Match Success Indicator. This shows how well Batch was able to match the input address. Results could not be returned for the input address. This might happen if the formatting process truncates the output address. This means that Batch could either find no data in the input address or too insignificant an amount of data to return an address. See similar questions...

That's your current energy. All alien abilities cost energy, and if you don't have enough energy to perform an ability, you can't do it. The only way to get energy back is to wait while it slowly replenishes. The adrenaline upgrade will speed your energy recovery rate, as will standing near a movement chamber. See similar questions...

The posting system in Massachusetts was developed with input from MALCP. It has become a model system for the country. The yellow flag means that a pesticide was applied to a piece of property. Yellow signs must be posted for certain biological controls. Sign posting is meant to serve as a notice of a pesticide application. Each pesticide product has a label which clearly indicates how soon a person may return to activity on a lawn. See similar questions...

Yellow Ledbetter, that now famous B-side, is written by Mike (can you hear the Jimi Hendrix tribute?), Jeff, and Eddie. It can be found on the JEREMY maxi-single and the live version can be found on the DAUGHTER single. This is another song that people ask what its meaning is and what the heck the lyrics are. NO ONE but the band really knows what the meaning of this song is or what the title refers to. See similar questions...

The symbol means that the collector is "willing to part with" the artwork. If you are interested in acquiring it, you should send a message to the collector. If you want to activate the "willing to part with" option on some of your artworks, you can do that through your member area, under 'view your collection'. Just check the tick box to activate or deactivate this symbol. See similar questions...