Cement Concrete & Aggregates Australia
Concrete surface dusting is typically caused by finishing the concrete surface too early, while bleed water is still rising to the surface. Thus working bleed water back into the concrete weakens the concrete surface resulting in dusting of the harden concrete. Generally, repairing dusting floors is difficult, however, if the problem is not severe, the surface can be repaired by applying a chemical surface hardener.
Frequently Asked Questions - RadonSeal
Power troweling provides a nice-looking, smooth finish on concrete floors. It creates a "hard cap" (crust) on the surface. But when overdone, the surface becomes shiny and the crust may be very thick (1/8" instead of 1/32"), which may lead to problems. (Uncured lumps pushed into the surface while still plastic will become stress points that may cause spider web cracking later. The thick hard cap may spall as the concrete underneath cures and shrinks.
Roy Burch Concrete - Countertop FAQ
Answer: No. Cast concrete is not a substitute for a cutting board. If you are interested in introducing a cutting surface into the kitchen design we recommend a removable Poplar cutting board molded into the counter.
A floor sanding specialist husband and wife team working in ...
It can be but I am a professional working in your house and I always respect that. The machines have effective vacuums on them; I empty the dust bags a lot, if there are wardrobes or cupboards I mask up the gaps, in a hall I’ll put a sheet up around the stairwell to stop dust spreading. I also sweep up a lot and vacuum as well as having windows open which draws out the dust.
Frequently Asked Questions at A Better Crawl Space Inc., Ser...
We can add depth to the areas needing support and add rebar to strengthen the concrete for the additional load. Metal screw jacks are often used for support posts.
Thermonet Undefloor Heating FAQ
Yes, we recommend that you check that the floor is insulated to ensure the system is efficient to run and you reduce potential heat loss.
This is the concrete hearth built into the floor so that if burning coals spill over onto the floor they do not cause a fire hazard.
FAQ Frequently asked questions Hardwood Floors, Timber Floor...
Yes you can lay timber over concrete. If the concrete slab is less than five years old, we can apply a membrane between the slab and the timber so as the moisture from the slab doesn't damage the timber.
quot;Suppliers Can be Central to Your Business Success" from the ConcreteSherpa. Adobe Reader required.
Design Flooring Centre, A division of Tiles & More - Welcome...
If the floor is cracked it is advisable to use an anti-fracture membrane, otherwise cracks may transmit through the tile. Also as stated in question #2 you cannot tile over a painted concrete floor.
MS Hardwood ,Orange County Hardwood Installer,California MS ...
Yes, using a suitable underlay and a surface vapour barrier on top of the concrete. This is not to be confused with the damp proof membrane in the concrete. You must have both.
AeroGo : Home
The smoothness of the surface has a major influence on the air requirements. The rougher the surface, the more air will be required to maintain the air film. On a rough, sandpaper-type surface increased friction can cause more wear on the air bearing material.
Bellstone, Australia, NSW,Wholesale suppliers, Welsh Slate, ...
Some projects are suited to uneven surfaces whilst others require a smooth finish which is achieved by using stone that has been honed. Naturally split material is very popular for use in areas where a non-slip surface is required. It is especially popular on outside areas such as patios, steps, pool surrounds and driveway applications. There are processes that can be applied to the surface of the material to give it a more uniform and luxurious appearance such as honing.
Thorough debate ensued over the fate of last year’s debris, and in the end it was scrapped. Our faith in concrete naturally decreased, as even duck tape failed to keep it together. Perhaps this year, we shall keep it simple and avoid similar disaster. However, that would make the RA’s job far too easy, and butts were made for sitting anyway.
Frequently Asked Questions
Concrete is a commonly requested material. To be honest, we don't know much about gluing to concrete. You could check with some building sites. Cement is the adhesive that holds concrete together. It will take some research on our part but we are thinking about doing concrete. A very cool and specialized glue! It does its job then you can roll it into ball and ... well, have a ball with it. The glue that is used for "tip ins" (magazine jargon) is referred to as a Peel and Stick glue.
Windsor Plywood - Winnipeg - 551 Century & 3176 Main
The squeak is probably in the subfloor over a floor joist. Best way is to run screws into the subfloor through the joint nearest the squeak. If this is awkward, first screw a 2 x 2 to the side of the joint tight to the subfloor, then screw up through the 2 x 2 into the subfloor.
Pergo Finishing Putty can be used to repair small chips and dents that have penetrated the laminate layer of your floor. It is easy to use and is color-coordinated to Pergo laminate flooring. If the area to be repaired is larger than a 1/4 of an inch, we recommend replacing the plank. Individual planks can be replaced if necessary, and since we use no dye lots and the floor does not fade, the planks will match perfectly.
Cement & Concrete FAQs (Frequently Asked Questions) | Po...
Many materials have no effect on concrete. However, there are some aggressive materials, such as most acids, that can have a deteriorating effect on concrete. The first line of defense against chemical attack is to use quality concrete with maximum chemical resistance, followed by the application of protective treatments to keep corrosive substances from contacting the concrete.
Ready Mixed Concrete Co. - FAQ
Surface deterioration is usually referred to as scaling. Scaling is a local flaking or peeling of the finished, hardened concrete surface, resulting primarily from multiple freeze-thaw cycles. The condition can be aggravated by the presence of deicing materials such as salt. Any product that is intended to melt ice and snow can contribute to scaling. Even products labeled "Safe for Concrete" can contribute to scaling.