With the standard basic plan, you can only connect one computer to the modem. Please contact us for more information on needed equipment and install charges for multi computer environments.

Probably. Any wireless receiver supporting the industry standard 802.11b or 802.11g protocols should work. However, in rare cases, we have found wireless receivers which had compatibility issues with the computer upon which it was installed.

Currently wireless access is restricted to UW-Whitewater faculty, staff, and students only; no guest access is available.

Previously, we suggested that people use Mac modem cables; however, it has come to our attention that there is no one standard Mac modem cable. Since correct modem operation on a NeXT depends upon a correctly wired modem cable, buying a Mac cable is not a good idea. Some Mac cables do not allow dial-in and no Mac cable allows the use of hardware flow control. For these reasons, we are recommending that only cables that meet NeXT specifications be used.

Your computer must have a wireless network card installed. Computer manufacturers typically indicate this by saying their equipment is WiFi enabled, or that they support 802.11b or 802.11g wireless networks. On a Macintosh computer this is often referred to as an airport card.

See the Instructional, Communication & Information Technology Wireless information Web page. This page has a link to information about what you need to do to connect to wireless access, as well as links to other information about the campus wireless access project.

Unlike DSL or Cable Modem, our service does not depend on telephone or cable TV infrastructure. This enables Phoenix Internet to reach many neighborhoods where DSL and Cable Modem are unable or unwilling to go. Our service plans offer performance comparable to DSL and Cable Modem, but with some important differences. Superior customer service because we are a local company and can be at your location within hours if necessary.

A cell phone wireless modem is an accessory used to connect a cell phone or other portable device such as a PDA or laptop to the internet without annoying wires to make a "hard" connection point.

No. The Navini modem is specifically designed for the Navini wireless network as implemented by Unwired.

Regional Bell Operating Companies are sometimes tariffed and will only allow (with perfect telephone line conditions) 53K. Tariffs are established by the FCC and by state Public Utility Commissions. Because analog lines are a little noisy (static), your modem will automatically slow down to accommodate for noise. It is normal for 56K modems to connect between 39 - 51K. This is still very good performance.

This is a common question because many things can cause this. First off, it is important to remember that while 56K is the theoretical limit a modem can connect on a normal analog phone line, NO modem ever connects at 56K. About the best a modem could ever achieve is 53K and a modem that connects at 40K or better in most cases is doing pretty well. Causes of slower connection speeds include: Unconditioned or poor quality phone lines.

First, the highest connection the FCC allows over standard phone lines is 53.3k. This is the fastest connect rate you can get. If your are connecting in the 40k-50k range, this is considered good for most dial up connections. If you connect at a rate less than you would like, your modems 56k protocol may not be compatible with ours. We support the fastest and most common protocols across most of our network, 56k Flex, v.90 and v.92. You can attempt to update your modem drivers.

With the standard plan, you can only connect one computer to the modem. See the terms and conditions page for information and costs to setup a proxy server.

If you connect a new device to the cable modem, such as a router or new computer, the modem must be reset. First, reset the modem by removing the power cord then plugging it back in, then reboot your computer or router.

We don't have arbitrary limits. NCF's resources are yours to use. We don't put limits on how long you can stay connected, how much disk space your email or website can use, etc ... as long as there are resources available for others to use as well. For example, dial-up access is unlimited as long as there are modems available for others; if all the modems become busy, NCF's modem sharing system gives priority to people with less connect time that day.

When connecting the WinGate machine to the Internet through a Cable Modem, you first need to be sure to have two Network Interface Card's (NIC's) installed in that computer. One connected directly to your Cable Mode and the other connected directly to your internal network. ( You should not try connecting the Cable Modem directly to your network hub as this will cause severe security issues.

For additional information on the OpenVMS Ask The Wizard (ATW) area and for a pointer to the available ATW Wizard.zip archive, please see Section 3.8. The following sections contain information on OpenVMS and IP networking, as well as IP printing topics.

The DSL modem is an external device that connects to your computer's network interface card (NIC) via a standard 10BaseT cable. Yes, but CCI Net will not provide network technical support. CCI Net will only provide technical support for the DSL line and the primary PC on which it was installed.

Each GSM device can have one way to connect. In any case, GSM modems are connected to the computer's serial port. Each mobile phone usually has a kit to connect to the computer. Read the documentation for your mobile phone or contact your service provider.

a. The modem connects to the computer with an Ethernet cable. The modems can be connected directly to a router, wired or wireless so you can share your system with the rest of the family.