Inside the switch is a small magnet. As the switch is moved forward the magnet slides over and activates a reed switch mounted on the circuit board inside the flashlight. When the reed switch is activated (or closed) energy in the capacitor flows through the LED. This design feature has several advantages over conventional mechanical switches used in other flashlights.

It calculates your mf for the two switches and determine your attacking weapon tab (one with lower mf), versus your mf weapon tab (one with higher mf). If your higher mf weapon switch is ALSO your attacking weapon switch then I strongly suggest turning off weapon switch altogether or get rid of anything on the other weapon switch, otherwise it will mess things up.

Nearly every computer has a keyboard, monitor and mouse. When using a Daxten KVM switch, a single keyboard, monitor, and mouse is used to switch between several attached computers. Your keyboard, monitor and mouse are connected to the Daxten switch, which is connected via a cable(s) to each computer. Daxen KVM switches will fully emulate the mouse and keyboard connections for each computer, even when that computer is not selected. Consequently, switching is seamless and trouble-free.

Yes. Both the switch and receptacle perform their intended functions whether the batteries are fully charges or exhausted. There is no common parts between the main AC power functions and the lighting function.

The Hellhound switch lifts the cathode from ground, limiting the conductivity of the output tubes. It is based on a variable wattage control patented by Dennis Kager (see above). The switch on the current line of amps limits the drive signal to the output stage. This is a new circuit design also by Kager.

The switch is read when the interface unit is powered-up, so all you have to do if you want to run the interface with a different software package is a) select the program number you want, b) unplug the power connection and wait a few seconds, and c) plug the power back in.

For safety purpose, the scooter uses a speed changing switch. When released it will always return to the off position. Turn the speed changing switch towards your body to raise the speed of the scooter and turn it against your body to lower the speed.

The pressure switch communicates with the tank and the pump. The pressure switch monitors the pressure inside the tank and activates and de-activates the pump when cut-in and cut-out pressures are reached inside the tank.

If you turn the nukeALERT on in a quiet radiation area and then walk by higher-levels of natural radiation, the nukeALERT will detect the increase in natural radiation background. High-level natural radiation can be found near some large rocks, or in some buildings that use stone (like granite), or near some ceramics that use powdered stone. Increased elevation also increases natural radiation (large increases such as mountains).

Warning: Some of these questions are about installation. You should consult a qualified electrician familiar with all the local codes and ordinances when working with electricity.

Zanfel works safely into the dermal layer of your skin, binds to the urushiol oil, and, when rinsed off, takes the oil with it down the drain.