Yes, when proper installation methods are followed. Exterior applications require special precautions and installation methods. Do not install floor tile on exterior walls unless the product specifically recommends this application.

Wall tiles (because they are not intended to be load bearing) are typically thinner, lighter and softer than floor tiles. Wall tile glazes are not designed to handle the abrasive forces from foot traffic. Increasingly, floor tiles are being applied to walls and this is no problem so long as the walls are strong enough to support their weight and proper ceramic tile installation methods are used. However, it is not usual to recommend using wall tiles in floor applications.

Most of our safes come with pre-drilled holes which will allow you to easily bolt it to the wall or the floor. HOWEVER, most fire proof safes can not have holes is the safe as that would reduce the fire protection. To bolt these safes in we suggest using a silicon-based glue to glue them to the floor.

A level, structural slab is sufficient. If the slope of a floor is more than 1/4 “ over the four feet of space the VSEP will sit on, we would recommend a level “housekeeping slab” be poured on top of the grade.

We believe that these two types of dwellings would have been lived in simultaneously, that they date to the same period of inhabitance. There may have been some variance due to seasons. The village on the canyon floor would have been ideal for summer inhabitance. It was closer to Frijoles creek and the crops that would have existed on the canyon floor.

AutoTize LLC will print your graphics to unlimited sizes on any Interior/Exterior Window, Wall or Floor . We seam the panels together to produce bigger than life size images (window & building wraps, wall murals, etc.). Single panels can be printed up to 16 feet by 165 feet. Our Window, Wall & Floor Murals can be used for a wide variety of applications such as Visual Merchandising for buildings, billboards, indoor banners, signage, posters and tradeshows.

Make sure surface to be covered is clean, dry and free of dirt or other foreign matter. Unsealed wall surfaces must be sealed with a good grade of sealer. Check areas to be covered for squareness. If a non-square wall is to be covered, it is best to run a plumb line to establish a true vertical reference point. In areas of high humidity, such as below grade or where moisture is always present, exterior walls should be waterproofed and insulated.

A couple of years ago, I went to replace a vinyl floor in a basement level bathroom of my house. As I lifted up the old flooring I found the mastic was white with a fibrous look to it. Because my house was built over 20 years ago, I was... We tend to think of our homes as our havens--safe places to go in order to retreat from the assault of modern life. For the most part this is true. But there is a hidden danger lurking in the seemingly tranquil and protective confines of our houses,..

No. The components are well secured in a rugged plastic casing that can stand most such rough events.

There is no wait. Because there’s no glue to dry, consumers can walk, or move furniture back on the floor immediately after installation.

Pergo Installation Straps are used to secure a large number of plank or tile rows during installation of floors that require glue. They utilize a mechanical ratchet to draw the planks together. We recommend using Pergo Installation Straps for the entire floor to ensure uniformly tight plank joints and to increase the overall speed of installation. Straps are not necessary with glueless floors or with pre-applied glue floors.

This depends on the type of floor you want, where you want it and the type of subfloor it will be installed on. The basic installation methods are nail-down, stapled, glue-down and “floating,” (installation without nails, staples or glue). It’s best to talk to your Wood Flooring International dealer for advice on the right method for you.

You can use primer to prepare a sub-floor for vinyl tile. It aids in preparing the floor for the adhesive. We recommend Jasco Primer. NEVER USE A SEALER! TrafficMaster Pro Basement Proofer is a type of primer that acts like a sealer, but allows adhesion of the tile to concrete floors. Most importantly, it helps prevent moisture from getting between tiles and the sub-floor.

Answer: Both. The panels fit flush against the wall and stand on two (2) legs with 2" levelers. Once the panel is leveled, the top of the panel is fastened to the wall studs with 3 - 4 screws.

Tile Installation over Cracks - I am building a house in Florida, and the slab is a year old, and its cracked. Before I install the ceramic tile, should I use any kind of underlayment to prevent the tile from cracking, and if yes, what kind? Can I use roof paper as an underlayment? I will appreciate your answer, thank you! Old Thin-set Removal - The first floor of my house is currently comprised of carpet in the living areas and tile in the kitchen and major hallways.

a. Yes, by simply buying a new wall or floor covering and putting it over top of the existing one. Unlike furniture, wall or floor coverings cannot be removed from a room. To buy a new wall or floor covering, click on 'Walls and Floors' in the W Shop. You will see wallpapers, paint and floor coverings, most of which match 'themed' lines of furniture. To see what the room might look like, be sure to use the preview button. The new wall or floor coverings will cover the old ones.

Yes, floor tiles are generally thicker and endure more traffic and weight. Wall tiles are thinner and have a glazed surface.

Structural strength and resistance to abrasion. We will help you choose the perfect tile to use for your space. One example - we wouldn't advise Mexican hand-painted tiles for a shower, on account of the wider grouting required.