Environmentally and as a product Glow Wire is safe, although for common sense reasons we would advise keeping loose Glow Wire and Inverters away from young children. They may bite into the Glow Wire when it is switched on - getting a shock.

Glow Wire is basically a copper wire with a phosphorous powder coating protected by an outer PVC layer. The wire operates on "AC" (Alternating Current) this is supplied by an Inverter. When an oscillating voltage (50-130V [rms] AC @50-5000Hz - low current) is applied to the wire the phosphorous reacts by giving off an electroluminescent glow.

Yes we can sell Glow Wire seperately, but it will not work without an inverter. We sell Glow Wire for £8 per meter (less if ordered in quantity). We can supply Glow Wire in continuous rolls of up to 250 meters.

Glow wire has a "Half Life" which means it will not go out suddenly. After around 3,000- 4,000 hours (indoors) of being illuminated it will gradually glow less. It has been known to last a lot longer. The wire can be replaced without changing the inverter.

Yes. You don't have to be a Rocket Scientist to install Glow Wire. The Glow Wire is supplied at the length required and ready to fit. For those of you that would like to experiment and customise the Glow Wire for a particular application, i.e join several colours of Glow Wire to each other or reconnect offcuts, some soldering may be required. You can find instructions for this by following this link: Connecting Instructions

A small matchbox size inverter (12v) will power up to 8 meters of Glow Wire, either as one length or seperate lengths wired to the inverter in parallel. Larger inverters are available to power longer lengths of Glow Wire. We can provide inverters that will power up to 1000 meters of Glow Wire!

Yes it can be reconnected by following the step shown in the connecting section of this website. Different colours can also be connected together and ran from the same inverter.

All chemiluminescent glow products sold by The GlowSpace are very safe when used in a responsible manner. As mentioned above, all of the liquid chemicals are stored safely inside a durable plastic outer casing. You should never intentionally rupture the plastic casing of a glow product, because if it has been activated, it will contain small pieces of broken glass that could be harmful. However, if the liquid chemicals do leak out for any reason, they are considered non-toxic and non-flammable.

Yes. All our chemical glow light sticks and products come in a sealed plastic case. Even if the outer casing of the glow stick is somehow punctured or broken open, the chemical contents are non-toxic and non-flammable. But please never contact the liquid with eyes or ingesting the fluid because irritation will result. There is also the possibility of an allergic reaction. Please keep in mind that under normal use you will never come into contact with the fluid inside the glow light stick.

Yes. We use the same type of glow sticks you can buy around Halloween. The fluids used in the chemical reaction are mildly toxic, but under normal abuse the outer casings of the sticks will not break. We've yet to see one do this, after long months of serious whappage. If used on a soft surface such as grass, there should be virtually no risk of breakage. And kids love them! Back to top

Aluminum is a fine conductor of electricity, and generally is not unsafe. However, every point of connection of the wire can be a potential fire hazard if not connected properly. Typically, it is not practical or necessary to replace aluminum wiring in a house. However, we recommend that properly installed UL listed devices be put in at every switch, receptacle, light fixture, etc.

Get a Hatori SB-8, it really sounds great! Other options are Weston Genesis Pro pipe and the KSJ speed 30 tuned muffler Another possibility is that if your struts have worn through on the bottom like mine, then the skids might be loose enough to vibrate against the set screws. Also the screws that screw the tail boom support rods to the horizontal fin are just a little long. Use a dremel cut-off wheel to take off the last 1/16"-1/8" from the screw.

The wire is 39 inches (1 meter) long and per MIL-W-16878 (TFE insulation). One is red, plus (+) voltage and one is black (ground).

There are two types of relays that are commonly used in 12-volt automotive applications: Single-pole Double Throw (SPDT) relays, which have 5 pins, and Single Pole, Single Throw (SPST) relays, which have 4 pins. Depending on the application, you can use either of these; for remote turn-on leads (see Section 5.11), an SPST relay is fine, SPDT relays are often used in alarm installations. Make sure that you get a 12-volt relay - this specifies the voltage required to make the relay "switch.

A wire at Remit2India Money Transfers allows you to transfer money from your existing bank account to India in 48 hours. Remit2India Money Transfers also gives you a unique tracking number for your transaction allowing you to track your remittance online at any point of time.

Yes, we use the same international wire transfer service as all major banks. Our business is ensuring safe, secure, guaranteed and traceable delivery of funds. Each wire transfer is subject to a number of verification procedures to ensure accuracy. All transfer are executed based on client instructions only.

A polished surface is really a surface so that is so smooth, it is shiny. Naturally, the surface is a microscopic mountain range, with the light reflecting into itself. Buffing smoothes that surface to the point the light reflects back, the ‘glow’ is derived from thousands of fine directional buff lines reflecting light back that is just slightly scattered, this gives fine polished metals that ‘illumination’.