If you are using the wood flooring plans that we have provided, we recommend that you create a rock or sand hearth to put your stove on. To install your stove on the hearth, follow manufacturer’s instructions and local building codes. Each dome is equipped with a metal stove flashing. The piping will run from your stove through the flashing and above your dome. All of the piping that is used in association with the stove should be double walled pipe.

Yes, as long as the height difference between the two installations is at least 25 cm. You are allowed to install two stoves to the same chimney if the height difference is min. 25 cm. However, do never install a stove to a chimney where a gas furnace already is installed. Use separate flue pipe stacks for each appliance. See similar questions...

The flue pipe from the stove to the chimney must be as short as possible to avoid cooling down the smoke. If the smoke does not have the right temperature, it may cause poor draft conditions and smoke inconveniences. Only one elbow ought to be connected to the stove as the smoke will face too much resistance. We have not been able to measure any difference in the draft conditions between a stove fitted with a top flue exit instead of a rear flue exit. See similar questions...

No. Since the pellets are so efficient, the stoves do not need a chimney. All you need to do is vent them outdoors with a 4” pipe through an outside wall. So, choose the room you congregate in, place the stove in that room, and enjoy the ease and warmth of pellet heat! You’ll also enjoy watching the flames—and the fact that there is very little ash to clean. See similar questions...

No, we do not recommend doing this. If you changed from wood to gas, it would not only void the warranty of the gas log set, but you run the risk of damaging gas components in the log set itself and your home. See similar questions...

This depends a little on what level of inspection you want (see question #2), but most visits take 45 and 90 minutes. See similar questions...

It is always advised to use a HETAS approved installtion engineer. If is however the person carrying out the installtion is not on the approved list you will have to seek authority from your local 'Building Control' office. They will come out and inspect the installation. There will be a charge for this service. See similar questions...

Yes, as long as the local building requirements are followed. The clearance distances to combustible materials are to be kept. It may be a good idea to ask the chimney sweep for advice. See similar questions...

The initial installation should take 10 miutes or less. After that, it takes only a minute to put up or take down. See similar questions...

Departments should plan for wireless network service installation as they do for standard wired network service and telephone service installation. Each installation requires completion of a Network Service Request for a wireless site survey. The site survey with your department or college, will determine the number, and placement of wireless network access points within the coverage area. See similar questions...

Yes, a permit is required to install a wood or pellet burning stove. Currently, we charge $25.00 for fireplaces, wood or pellet stoves. (See 1997 UMC 112.1) See similar questions...

Factory built fireplaces or stoves capable of burning wood or wood pellets may be installed in manufactured homes provided they comply with the following State of Nevada requirements: quot;The fireplace or stove is approved or listed for use in a manufactured home or mobile home" quot;A fireplace or stove does not take the place of the normal heating unit or furnace of the manufactured home or mobile home. See similar questions...

per the space and size of the product , it is provided with two hooks for hanging it on the wall. The company provided with two screws for the Kitchen Hood. See similar questions...

Burning of wood is required to meet certain EPA emission standards that a coal burning appliance does not handle. It is not a safety issue, in fact, until 1990 we sold the coal burning appliances of today as wood or coal. But, when the EPA Clean Air Act of 1990 was enacted we had to start marketing them has coal only. The wood models either had to have a catalytic combuster added or adjust the firebox to meet a 35:1 air to fuel ratio. See similar questions...

Generally allow one day for replacing a heating and air conditioning system. Installing a brand new central heating and cooling system, including ductwork , may take two days. Be aware that reputable contractors will refuse to install a new air conditioning system or heat pump system when it is raining. This is due to the fact that when moisture gets inside refrigerant lines it can be very damaging and can cause reliability and maintenance issues. [ back to top ] See similar questions...

Please make sure the flue is open before starting fire. NEVER remove hot ashes or partially burned loges. Please leave the ashes in the fireplace even if you are sure they are cold. It's easier to build a fire with a bed of ashes. If it becomes absolutely necessary to remove the cold ashes, use a metal container only. (Anything flammable, such as a paper bag or cardboard box, even if you are positive the ashes are cold, is extremely dangerous. See similar questions...

Unfortunately, no. You will need a wood pellet stove but if you don’t already have one, the savings you will realize in heating your home will more than pay for the stove. Some companies do offer converters which may be placed in fireplace inserts. Please check with your local hardware store or on the web to see if this option will work for you. See similar questions...

Yes you absolutely can from a technical standpoint. The building can have anything normal installed into it. Legally, we cannot answer that. You would need to check with your local fire department etc.Many places now require the Ultra low emission wood stoves and some areas no longer allow wood stoves. We cannot comment on that because we don't know your area, but yes a wood stove can be installed. See similar questions...

No, this unit will not exhaust properly vented into a chimney. It must have its own three or four inch pell vent piping throughout its entire installation. See similar questions...