Moisture barrier performance cannot be guaranteed where there are seams, much like in vinyl products today. Recommend appropriate seating designs which minimize seams where continuous moisture barrier performance is critical to the customer.

Replacement of your moisture barrier is required . During the tear-off process your old barrier usually gets torn and oftentimes your old barrier was not installed correctly. We can not warranty your job without replacing your moisture barrier. A new moisture barrier is critical to a good siding job.

A vast amount of water can be trapped by concrete floors below ground. Since the soil adjacent to the concrete can bring humidity to the floor, it is important to avoid direct contact between the laminate flooring and the concrete floor.

Most of our countertops will have a seam if over 7’8’’ long. (However, we have poured monolithic pieces up to13’ 6” long for double vanities). Seam tolerances are 1/8" wide and filled with clear silicone sealant. If visual continuity is an issue, we can move the seam to a less conspicuous spot, but we prefer to think of seams as a design opportunity, to be incorporated into the piece as a subtle feature, rather than something to hide.

Stone is shipped to us in slab form. These slabs range in size, the longest being approximately 10 feet. When laying out each job we take great care to minimize the number of seams while trying to balance the economical use of the raw material. Different stones will show seams differently. Generally darker stones show seams less than lighter stones. Stones with small, intricate patterns show seams less than stones with larger, more obvious patterns or veining.

This is a matter of personal taste and preference. I tend to like my tobaccos a little on the dry side, with about 11-12% moisture content, but others like their tobaccos much wetter. Tobacco is packaged in order to assure optimal keeping and aging qualities. The moisture content in the tin can be anywhere from 12-18% for natural tobaccos, and as high as 28-40% for some very heavily cased aromatics. This may not be optimal for smoking.

Radiant Barrier is a material that is a poor re-transmitter of infrared waves (radiant energy). By definition, this re-transmission characteristic (emissivity) must be at or below 10%. The emissivity of Reflectix? products is approximately 3%. Therefore, when a Radiant Barrier is installed in a residential attic, it "blocks" 90% + of the radiant energy that is being radiated by the hot roofing materials.

If the compliance process begun by the TCC does not result in resolving the problem, and if the officials of the foreign country cannot be convinced to act positively, then the U.S. government may examine whether we should turn toward active enforcement of our trade rights. Agreements such as the WTO and NAFTA provide for enforceable dispute settlement.

Yes. Water flows through fractures (or cleats) in the coal seam and if the cleat system is well developed and has enough water to pump and produce an economically viable and feasible water supply, the seam can be an aquifer. Coal seams are the most regionally continuous geologic unit in the Powder River Basin and have aquifer characteristics equal to or better than sandstones, so are frequently targeted for water-well completions.

No. Special attention has been paid to the design of the garments. For infants the seams are on the outside of the garment and the clothing for children and adults use very small seams with over-locked stitching to prevent any raw edges coming into contact with the skin.

Moisture includes water, organics, flavorings and other substances that are released by heat when following the standard method for moisture analysis.

Mu is the English spelling of the Greek letter μ. It can be pronounced "mew" or "moo," with "mew" being the more common. It is commonly used to represent a ratio in rotorcraft engineering, sometimes called the rotor tip advance ratio. To put it about as simply as it can be put into words, the μ ratio is the ratio of the forward speed of the aircraft to the rotor tip speed relative to the aircraft.

Savings of up to 15% off your air conditioning usage are typical. This can be a larger number if you have ducts mounted in your attic space.

Ventilation is not required, but it is extremely helpful when addressing convective heat transfer. If an attic system has a mass insulation, (such as fiberglass), a Radiant Barrier and a ridge vent, it has addressed all three types of heat flow; conductive, convective and radiant.