Your cabinet should have a model number and rating plate on the back, if there is no rating plate the cabinet will need to have the impedance measured by an engineer. We do not recommend using the cabinet until the impedance has been checked as it could damage both your amplifier and cabinet if either is used incorrectly. If your cabinet has a rating plate the impedance of the cabinet must match the impedance of the amplifier you are connecting it to.

Check your Speakon plug, it should be wired for +1 (positive) and +2 (negative) on the amp end. The cabinet end should be wired in the standard fashion, which is +1 (positive) and -1 (negative). Be sure to depress the stereo/mono-bridge button

A measure of the impediment to the flow of alternating current, measured in "ohms" at a given frequency...

The Cabinet consists of the Prime Minister and senior Ministers, and decides on all major government policy matters.

Controls are set to maintain a temperature of 38°F (3°C) to 40°F (4°C) for refrigerators and -5°F (-21°C) to 0°F (-17°C) for freezers.

Remove door from cabinet by opening 90° and lifting off of hinge base. Carefully pry cover from hinge barrels. Remove hinge barrels from door, turn them upside down and replace on door. Remove hinge base on cabinet. Rotate cam 180o. Insert cam into hinge base. Install hinge base on cabinet using existing hardware. Remove lock strike on cabinet. Reinstall at new location with existing hardware. Plug existing holes with the hardware provided. Mount door on cabinet.

Yes. All dual channel Crown amplifiers can be treated as if they are two separate "mono" amplifiers (One channel completely independent of the other) For example: A Macro-Tech 1202 can function with a single eight-ohm speaker on channel one and four eight-ohm speakers (a two-ohm load) on channel two. A Com-Tech 410 can function with one or two eight-ohm speakers on one channel and the other channel switched to 70-volt operation.

Impedance is the load connecting to the speaker socket on the amplifier or combo to give maximum power transference. This must match the stated impedance value on the amplifier or combo to ensure no damage can be caused to the speaker or amplifier.

Since an AC potential is applied to the cell, there will probably be a phase shift between the applied AC potential and the AC current response. Therefore, the impedance can be represented using a vector diagram displaying the in-phase (Z') and out-of-phase (Z") impedances, the total impedance, and the phase angle. Since complex number terminology is also used when analyzing impedance spectra, the in-phase and out-of-phase impedances are often referred to as real and imaginary impedances.

Regular dusting should suffice. If you must use a wax, a liquid polish is best only if used sparingly. Spray-on waxes are not recommended. Please keep in mind that the cabinet is real wood so it will darken over time.

Our current speaker cabinets are 1x12", 2x12" and 4x12" for guitar and 1x15", 4x10" and 8x10" for bass. We have made various cabinets over the years with varying amounts of speakers, if you could supply a model number we will then do our best to identify your cabinet for you.

If you notice damage to your cabinet when it arrives, you must notify the shipping company immediately. You have the option of refusing delivery if there is obvious damage when the cabinet arrives. If damage is hidden (i.e. packaging materials do not appear damaged), however, you have 15 days to file a freight claim with the company that delivered your cabinet. Be sure to file a claim and have the bill of lading information available when contacting the shipper.

After the main alarm has been activated - there is a secondary beep that will signal approximately every ten (10) seconds. The secondary beep signifies that the cabinet has been opened and that the alarm system needs to be reset. Additionally, we recommend that you inspect you AED to ensure function and use. The RescueCase is equipped with a "Low Battery Detection" mean for the 9 volt battery.

Yes provided the instructions are followed. It will take a few hours and requires two people to do it. The cabinet is fastened to the wall with screws, however lifting and mounting the Plasma TV requires two people because of the weight - if you prefer, we can arrange for our specialists to install the plasma TV screen and cabinet at an additional cost. All cabinets are supplied with a 2 year guarantee against manufacturer defects. Fires are covered by a 12 month warranty.

The filing cabinet is a place for Advanced Labs members to store bookmarks to items on the site. These bookmarks are stored in folders on the ComPADRE site so that they can be accessed whenever the member is logged into any of the ComPADRE collections. Lists that result from searching can also be stored in the Filing Cabinet.

File cabinet is a space occupied by AccountExact or ClientExact on your hard disk drive for saving all your memorized reports. In addition, it also save returns prepared for sales tax and state payroll forms, if you choose option for that.

Yes, you may bring your own cabinet to the GenTech floor. In certain situations GenTech may recommend the purchase of caged squared footage if nonstandard cages are to be used. No, due to fire and safety restrictions GenTech requires access to all colocated items located within the building.