If we compare oil, natural gas and electricity we see that natural gas is clearly the cheapest of the three at today's fuel prices. For a detailed look at heating costs for various fuels visit our fuel cost comparisons.

Wood fuel is one of the most appropriate renewable energy technologies for heating the home. In a domestic property the two fuels to consider are logs or pellets. Woodchips are not generally suitable for use in a domestic property because of the ancillary equipment needed. See similar questions...

We believe it makes sense to use American-made fuel products, especially given the daily increases in oil prices and our dependency on foreign countries for fuel. Pellets are extremely cost effective and are also better for the environment. See similar questions...

The previous are just a few questions firefighters consider when resources are limited. In the Wildland Fire Season that begins in May and lasts until approximately October, for vegetation fires within the WUI Zones, we respond with two engines and one Battalion Chief. Firefighters recognize the importance in delivering as many resources as early in the fire as possible to minimize its potential of damaging property and threatening lives. See similar questions...

Of course; visit the 'Fuel Heating and GT Cooling' tab of the [GT Inputs] topic, and select 'User-defined' for the fuel heating model. You'll be able to specify the desired fuel temperature and direct which hot fluid stream will be tapped to provide heat to the fuel. For further clarification, click <F1> for HELP while in that display. The results will be displayed in a table near the top of the "Gas Turbine" text output. See similar questions...

If you plan to use a wood stove, fireplace, or space heater, be extremely careful. Follow the manufacturer's instructions as well as the advance home safety measures on page 4 and remember these safety tips: Ensure adequate ventilation by opening an interior door or slightly opening a window if you must use a kerosene heater. Use fireplaces, wood stoves, and other combustion heaters only if they are properly vented to the outside and do not leak flue gas into the indoor air space. See similar questions...

The first step is to locate a hobby shop in your area (use the dealer locator and enter your U.S. zip code), and to ask the local shop to refer you to a club in your area as well. In major metropolitan areas there are usually several, so you often have several places and groups of people to choose from. These 2 contacts will be invaluable to you in gaining first hand knowledge and support. The next step is to visit the local field and watch people fly. See similar questions...

No. Our people are middle of the road in price and are competent and reliable. We also have a dedicated all-around maintenance sub-contractor who is capable in a wide range of home repairs including air-conditioning, light plumbing and electrical. Our main "go to" guys charge $35 to $40 per hour. Our other vendors range in price from $35 per hour to $75, and sometimes more for conditions such as an after-hours emergency sewer backup. See similar questions...

Outside of Moscow you'll be able to get your VD, have your money and documents stolen and otherwise make your Russian trip memorable for mere 5 bucks. They usually stand alongside highways. In Moscow you'll accomplish the same for about $100. Those who come here for cheap debauchery will also save a bundle by being denied the priviledge of being my clients. Russia is not a good place to for that sort of tourism. Social tolerance is low, and consequences may be severe. See similar questions...

Yes. The biodiesel in Bioheat® fuel goes completely into solution with heating oil and once it is blended it does not come out of solution and will not separate. Bioheat® fuel contains biodiesel. Biodiesel provides a cleaning effect and does have a tendency to dissolve or loosen some sediment that can be deposited in tanks and fuel systems from years of conventional diesel fuel or home heating oil use. This cleaning effect is dependent upon the blend concentration of biodiesel. See similar questions...

Yes. Many homes with radiant heating also have a central heating system such as a furnace or boiler, it can act as your main heating source, especially if you are building a new home. You can use the same heating source for your: In the floor, underfloor, Slimline baseboard and domestic hot water if the heating source meets the BTU output required. See similar questions...

Cold is the absence of heat. In summer, heat from the building is transferred into the fluid used in the loop (by means of a compressor) and, as this fluid circulates, the heat is rejected (discharged) into the ground around the loop pipe. By transferring heat out of the building, this provides cooling and dehumidification. See similar questions...

Staple ASTRO-TAB in the joist cavity under your radiant flooring system to reduce hot spots, prevent downward heat loss, and decrease boiler loads. Install TUFF-STUFF under your concrete hydronic floor system to achieve a moisture barrier and thermal break that meets manufacturer requirements. See similar questions...

While the university telecommunications system enables you to make international calls, the most cost effective method is by calling card. Special card rates vary from country to country. When you arrive, ask students from your country which cards they use. Try www.nobelcom.com or www.uniontelecard.com See similar questions...

Most water heaters are only in service for 2-3 hours per day and they often have enough capacity to do extra work. If the BTU heating output of the water heater is equal to or greater than the heating load, you can probably use it to heat as well. Look at the label on the heater for the BTU output. See similar questions...

There are a lot of misconceptions about fuel octane. Octane rating indicates one thing: resistance to detonation. Higher octane fuel does NOT run "cooler", and vice versa, provided the fuel has a high enough octane to prevent detonation ("pinging"), which is when the fuel ignites before the spark plug fires (this can and will cause an engine to run inefficiently and thus hot, but is extremely hard on the engine in other ways). This should not be an issue in a properly tuned paramotor engine. See similar questions...

Balloon burners use propane similar to your gas grill out back. The only difference is that we use the liquid rather than the gas. See similar questions...

You will burn approximately 7-10 gallons of fuel each hour you run, if cruising at 3200 rpm. (Higher rpm's per motor burn substantially more fuel with little or no increase of speed) Fuel Capacity varies depending on the boat rented, and usage also depends on weather, weight on board, number of tag alongs being towed, and individual engine differences. See similar questions...