I want to put in a new driveway. What do I need to do?
FAQ'sComplete an Entrance Application form, which is available at the County Engineer's office, 1400 West 6th St., Carroll, Iowa. The application form must be signed by the landowner and indicate where the entrance will be built. The landowner will then need to mark the location of the proposed entrance and the Engineer will examine the site to determine the necessary size entrance pipe.
Do I need to get a permit to put in a new driveway?
Road Commission for Montcalm County (Frequently Asked Questi...Normally the answer is yes; however, it is always advisable to contact our office and your township zoning board. Anytime a person or business does any construction work in the road right-of-way (normally 66 feet - 33 feet each direction from the center of the road) the should obtain a permit. The townships pay for the application of chloride on local roads in their township, and each township contracts with the Road Commission to take care of this.
Do I need a permit to expand or put in a new driveway?
RecyclingYes, it requires a Driveway Permit ($50) to determine impervious coverage restrictions for the zoning district you are located in.
Do I need a permit for a new driveway even if I do the work myself?
Eaton County Road Commission FaqYes, a permit from the Road Commission is required anytime work is performed in County road right of way. When you apply for a permit you are helping the Road Commission maintain safety for both yourself and the traveling public. Most traffic accidents occur at intersections or where vehicles are entering or leaving the roadway.
Can it be done over my existing driveway, or do I need to replace my driveway?
ISLAND PAVING :: Streetprint :: Residential: FAQS :..Provided the substrate is in good condition, StreetPrint? can be applied as an overlay to existing concrete, asphalt, or stone base. If the existing driveway is asphalt, in good condition, the pavement can be reheated and StreetPrint? can be applied.
I want to expand my driveway, what do I do?
Public Works FAQ's - City of Sunnyvale, California.You will need to obtain an Encroachment Permit. Please call 408-730-7415 and ask to speak to a City Engineer or you can visit our One Stop Permit center located in City Hall, 456 W. Olive Avenue, Sunnyvale. Back to top
Do I have to put my new numbers on my house and my driveway?
FAQ - Road Naming and Addressing - Permit & Resource Man...Yes. The new address numbers must be posted where your driveway meets the road and must be visible from both directions of travel on that road. You must also put your address numbers on your house in a place where they will be visible from the road or from your primary driveway. The numbers must be reflective, must contrast with their background, and they must be at least four inches tall. Don't forget to change the numbers on your mailbox.
When do I need a driveway permit?
Frequently Asked QuestionsA Driveway Permit is issued when you are doing an asphalt overlay of your drive, or a removal and replacement with either asphalt, concrete or pavers. A permit is not required for seal-coating. A Site Work Permit form can be mailed to you or is available at the Village Hall. The Village requires a copy of your proposal describing the work to be done. If you are changing the shape of the drive, a Plat of Survey is required showing both the existing drive and the proposed drive.
How many pails of sealer do I need for my driveway?
Latex-ite FAQ: It's easy and important to seal and maintain ...COVERAGE - The application rate of driveway sealers and resurfacers is important. If you don't use enough, you've left untreated areas of the driveway. If you use too much, the sealer will never "set up" and it the excess will track into your home. It is recommended that you spread a thin layer of sealer, let it cure, and apply a second coat only if necessary. Coverage rates will vary by sealer and by the condition of your driveway.
How many curb ramps do I need to do my driveway?
Shercom Industries Inc. - Product FAQ'sDepending on how wide your driveway is, you will typically need between 2 and 5 ramps. Two ramps for a single car driveway, and as many as 5 for double or small triple driveway.
What if I need to park on the street as I do not have a driveway?
City of Toronto: Transportation Services - ParkingSome streets in the Scarborough District are candidates for the installation of long duration (maximum 12-hours) parking. The policy regarding installing long duration parking dictates the following: Off-street parking must be non-existent or deficient, based on the number of driveways versus the number of homes and in accordance with zoning requirements for parking. (ie. at least one off-street space per home) Long term parking periods will apply to one side of the street only.
Do I need to check with DOT for my driveway?
Town FAQ's - Town of Warren Municipal WebSiteYes, if your property will access a State Road, such as Rt. 90, Rt. 97, Rt. 1, Rt. 131 or a State Aid Road, such as Main St. or Wottons Mill Rd.
Does anyone need to be there when you seal our driveway?
Ottawa Driveway Sealing :: Frequently Asked QuestionsNo one needs to be home for us to sealcoat your driveway. We do offer seven days a week sealcoating for your convenience. If you're not home, we'll make arrangements with you for payment collection.
If I am a state employee and want to apply for jobs at home, do I need to create a new account?
FAQ - Frequently Asked QuestionsNo. Please login using your regular NEATS ID and password. All state employees already have an account that was established through the NEATS Timekeeping or Training modules. Creating another account may result in not being properly considered for promotional recruitments. If you are interested in a transfer, the most effective avenue is to contact the hiring agency directly (the Department and Division will be listed on the job announcement) and express your interest.
How should I mount the Sensor/Transmitter if I want to detect vehicles coming up my driveway?
Voice Alert System-6: Frequently Asked QuestionsFor best results when installing to monitor vehicle activity, mount the sensor at 30 to 34 inches above the ground and angle it toward an oncoming car's radiator. Since the sensor uses infrared technology to detect activity, aiming the sensor to the hottest part of the car will insure maximum results.
Can I lay my new paving stones over my existing concrete driveway and patio?
Architectural Block, Architectural Masonry Products, Masonry...Yes, provided you have ample room to allow for the additional 3 inches that will be above the concrete. If this is going into a doorway, you may have a problem with clearance. Also, the concrete should be free of any major cracks. Remember, any movement in the concrete slabs that you are going over will show themselves in the surface of the paving stones.
