Unfortunately, no. You will need a wood pellet stove but if you don’t already have one, the savings you will realize in heating your home will more than pay for the stove. Some companies do offer converters which may be placed in fireplace inserts. Please check with your local hardware store or on the web to see if this option will work for you.

Please make sure the flue is open before starting fire. NEVER remove hot ashes or partially burned loges. Please leave the ashes in the fireplace even if you are sure they are cold. It's easier to build a fire with a bed of ashes. If it becomes absolutely necessary to remove the cold ashes, use a metal container only. (Anything flammable, such as a paper bag or cardboard box, even if you are positive the ashes are cold, is extremely dangerous.

Carefully open the damper and, using a flashlight, look up the flue for signs of a build-up along the walls. Goggles are suggested for this. If the build-up is ?" or more, a cleaning is needed.

Yes, but placement is key. Again the fan needs to draw cooler air from behind to operate and the surface on which the Ecofan is placed should never exceed 340ºC (650ºF).

If you are using the wood flooring plans that we have provided, we recommend that you create a rock or sand hearth to put your stove on. To install your stove on the hearth, follow manufacturer’s instructions and local building codes. Each dome is equipped with a metal stove flashing. The piping will run from your stove through the flashing and above your dome. All of the piping that is used in association with the stove should be double walled pipe.

Installation of our hearth products must be done in strict accordance with local or national building codes, and the unit's installation manual. We recommend that our products be installed by a factory-trained Mr. Fireplace installer.

Yes you absolutely can from a technical standpoint. The building can have anything normal installed into it. Legally, we cannot answer that. You would need to check with your local fire department etc.Many places now require the Ultra low emission wood stoves and some areas no longer allow wood stoves. We cannot comment on that because we don't know your area, but yes a wood stove can be installed.

Night and Day! Blaze King classic models feature a bimetal coil thermostat This simple thermostat evens out the uneven nature of burning wood. Blaze King owners typically only adjust their thermostats once or twice and day. Nearly all other wood stoves have a damper to regulate air-flow and require more frequent adjusting. Also, Blaze King wood stoves are very deep. Not just front to back but real depth.

Yes. We recommend annual service of your fireplace by a qualified serviceperson. This will ensure that your appliance is functioning properly. Your decision really comes down to how much a priority heating efficiency is for you. If you want a lot of heat from your fireplace, you should consider a direct vent gas insert. From a cost standpoint, an insert will cost approximately five times the cost of a nice gas log set.

No. Gas fireplaces are designed to burn gas only. Burning wood would damage the fireplace and could be very dangerous.

While they produce some radiant heat, most wood burning fireplaces are primarily decorative. Even heat circulating models still pull a tremendous amount of air from the home. There are several wood burning models that are efficient and clean burning. We also have several wood burning stoves and inserts that are very efficient. Click here to find a dealer near you that can help you with your decision.

Almost every gas stove, gas insert and gas fireplace we sell is rated as a heater. They operate at efficiencies ranging from 30 to 70%. As a result, they often can heat an area as effectively as a woodstove or wood insert. Just like woodstoves, they come in many sizes and output ratings. It is important to size properly for your application.

You need to determine which model of Blaze King you own first. Since there have been dozens of models made over the years, determining which model you own by general description is usually not possible. At the time all stove are manufactured, a metal or foil decal is applied to the rear of the stove. (Right hand side on inserts). This label contains all the information pertaining to the model and serial number.

A single wall black or close clearance double wall black to the point you would break surface of a wall or ceiling. Then you must continue with a 2100 degree chimney pipe to the point where you would be 2-foot above the peak or ten feet away from the roof line.

Blowers are optional on most heat circulating (grilles on top and bottom of fireplace) units, and some hearth products the blower is standard. Adding a blower is easily accomplished if power (110 VAC) was provided to the electrical junction box of the fireplace at the time of initial installation. If power was not provided, a fan option is still possible, but installation is complicated and therefore more costly.

No. If the fireplace is designed for use only with gas, this is a very bad idea. The fireplace is not designed to withstand a wood fire. And the gas jets are not meant to come in contact with ash. This is a real fire hazard. It's possible your fireplace was originally a wood burning fireplace and has been converted to gas. In that case, it can be converted back. But you shouldn't burn would in it until that's happened.

Yes, you can install a wood fireplace in a mobile home. However, the fireplace you install must have been specifically approved for mobile home applications (Canada & USA). The fireplace must also be hooked-up to a fresh air intake that enables combustion air to come from outside the house. Osburn freestanding stoves model 1000, 1100, 1600, 1800, 2200, and 2400 are approved for installation in a mobile home. You need to purchase a fresh air kit, which can be found in the accessories section.

If you use your fireplace frequently, you should have it cleaned after 1 cord of wood & inspected annually.

If you have a fully operational fireplace, whether masonry or pre-fab, it would normally be as simple as removing the gas logs & capping the gas line or installing a gas log lighter. But with today's new appliances, direct vent & ventless units would not be set up for solid fuel (wood) & could not be converted to wood burning.

Nope, the fireplaces are gas and on a thermostat. They serve as the main heat source for the cabins in the winter so they are not operational in the summer. Our fireplaces are so efficient that the heat they produce just from keeping the pilot light on would be unpleasant in the summer time. (We do have A/C and back-up electric heat as well!) The grill is gas and propane is provided.