Ethernet hubs can be purchased at your local computer store. AT&T does not provide installation support for Ethernet hubs.

Yes. SELECT customers may have up to four computers connected simultaneously. However, CLASSIC customers may only have one computer connected to the network at a time. Yes, with Choice OnLine you can surf the Net and simultaneously make phone calls or watch TV. To use a fax machine or dial-up modem while surfing the Net, you must have a normal phone line available. Your computer will not allow you to use our Choice OnLine service and dial-up to another Internet service simultaneously.

The router allows you to make a connection between your network and ADSL, so that more than one computer in your LAN can access the Internet. Certain models may give you further options such as security (firewall). A hub is the point of connection for the router and the computer to connect to the network. A switch acts like a hub but allocates an independent bandwidth to each user. This means the data transfer speed will not be decreased by additional users.

A switch has chips to store MAC addresses of the connected clients. Hubs do not. Therefore a switch can send packets directly to the intended computer based upon the header of the packets. Hub is different, when hub receives packets, it will broadcast packets to all the clients that are connected and that costs traffic. A switch is more efficient than a hub.

The HP Advancestack 100Base-T Hub-8txe and the ProCurve Networking by HP 100Base-T Hub 8 can only be directly connected to another Class II 100Base-T hub or to a switch. To connect them to a 10Base-T hub, either use a switch in between, or connect them to the ProCurve Networking by HP 10/100 Hub 12 or 12m or ProCurve Networking by HP 10/100 Hub 24 or 24m which are both Class II hubs that autosense the speed of each port to be either 10Mbps or 100Mbps.

Any electronics store that sells computers will sell hubs, switches, and routers. Best Buy, CompUSA, Circuit City, Radio Shack, Fry's - any of these is fine. If you go in and ask for a "networking hub", a "networking switch", or a "cable/DSL router", the pimply-faced saleskid will show you where they are. (I was a pimply-faced saleskid once, so I'm allowed to joke.)

Answer: Cat5 Ethernet cables can be used for a maximum of 100 meters between any Audia device and the Ethernet switch. Ethernet switches are also available with fiber optic ports which can extend the distance up to 2 km.

No, because Ethernet switches and hubs need Ethernet data. They would also add a lot of latency (or delay) to a Pro16 system. For parallel (or "star") connections, use the A-16D or A-16D Pro A-Net Distributor. Links:

No. An EthIR Beam receives infrared frames from an infrared device and delivers these to the EthIR Switch. The EthIR Switch then translates these infrared frames to Ethernet frames (and vice-versa) forwarding and receiving frames to and from an Ethernet network. An Ethernet hub cannot translate infrared frames. That is the purpose of the EthIR Switch.

Read the section called "Connecting your Xbox..." for details on hubs, switches, routers, and when to use each one.

Yes, any router/hub/switch will work with our system. Please call Sierra Advantage support for router settings.

Yes, you can, but Infostations won’t be able to provide support for it. So if it breaks, or doesn’t work, for troubleshooting purposes you may be asked to remove any self-installed networking equipment and plug a single computer into the wireless antenna. (return to top)

A switch can send packets directly to the computer that's connected to LAN. A router is a combination of a switch and a Network Address Translator (NAT). The NAT function in the router allows sharing a single IP address provided by the ISP with PCs connected directly to the router/switch or switch connected to the router. Basically if you are not planning to share a broadband connection in your network, than an Ethernet switch is efficient enough.

The tests performed are ‘screening’ tests and are different from diagnostic tests. The screen cannot detect all inborn errors of metabolism. The test may fail to identify some babies with these disorders, and some babies may test positive who may not actually have the disorder. Sometimes babies who are born prematurely, who are underweight at birth, or who may have received a blood transfusion can test positive, but not have the disorder.

Halleck Undergraduate Bistro, also known as The HUB, is located adjacent to the Cafeteria in Halleck Student Center. The HUB offers students a relaxing atmosphere in which they can enjoy a variety of sandwiches, salads, beverages, snacks, "Sub Connection" subs, "Freshens" frozen fruit smoothies and ice creams, and "Pretzel Logic" gourmet soft pretzels.

Not all API features and functionalities are available in OEM4-G2L due to its physical limitation. The OEM4-G2L does not have a 100-pin expansion slot and special features such as I2C, Compact Flash File System, and extra GPIOs are not available.

Search here for fast answers to your questions. You can navigate by clicking on our key topics below. If you don't find an answer to your question, email one of our Options Professionals at options@theocc.com and you may find your question and answer featured here!