No, they are not painted unless otherwise specified. They are finished in a high-quality, U.V. protected colored gelcoat, the same gelcoat used with most fiberglass boats today. However, custom painting is available for all our enclosures.

Yes, they will fit this tower. We now offer Illusion X brackets that install in between our wakeboard tower speaker enclosures and the Illusion X tower. The enclosures and brackets are pre-drilled with the same 3 hole pattern in the Illusion X tower. Two holes are for the supplied mounting bolts and the other hole is for the speaker cable, thereby eliminating the need for an external speaker terminal.

Yes, our 6.5-7” wakeboard tower enclosures will fit many different 6.5” and oversized 6.5” speakers, but not all of them so check the speaker specifications carefully to make sure they will fit with our enclosures. The outside diameter of our enclosures should match up as close as possible to the speaker or speaker grill diameter to get the best possible fit. Remember to check the cutout diameter requirements as well.

Yes, we can customize our enclosures to fit your specific application. We offer our enclosures with or without clamps, terminals, mounting holes, etc. We offer custom paint and even custom gelcoat colors! Some restrictions apply.

We now use a universal polished aluminum mounting clamp that will fit towers from 1 7/8"- 2.5" in diameter using the supplied rubber liners. Additional rubber strips can be used for towers smaller than 1 7/8". Our customers have also used PVC piping cut in half and installed around the tower to make the tower mounting diameter larger in order for the clamps to fit properly.

Yes, they will but we do not offer the enclosures pre-drilled at this time. You would need to use the supplied Illusion X brackets as a template to drill the holes in the enclosures.

Our enclosures are designed to enhance bass response and SPL. This is done in two ways: design and rock solid construction. The round design of our enclosures helps to eliminate standing wave distortion, which can affect bass response and sound quality. By design, our enclosures have fewer seams than wood enclosures, which greatly reduce the chance for air leaks.

If in the course of building a wakeboard tower you improperly attach it to your boat then you could be left dead in the water. If you are feeling down, you can often change your mood instantly just by putting on an inspiring piece of music, or reading a book or poem that gets you motivated. find articles | submit articles | link to us | site map | terms of use | privacy policy | contact us | advertising | partner with us

The China Speaker Tower heals nearby troops and increases their rate of fire. Unupgraded, it heals 2% of a unit's maximum health per second and increases firing rate by 25%. When upgraded with Subliminal Messaging (at the Propaganda Center), it heals 4% of a unit's maximum health per second and increases firing rate by 56.25%.

Speaker sizes and makes vary by model. Individual specifications and makes can be found on the product page for each SWR speaker enclosure or combo.

No and nor do we have a banana boat or jet skis. Our guests overwhelmingly prefer the Pangkil tranquillity as it is.

That's no problem, Fort Fremont Marine offers the camp all the 2006 Hyperlite Pro model boards to use at no cost.

Yes, although painted Formica will no longer serve as an appropriate surface for chopping and other rough use. Formica should be thoroughly washed with powdered detergent, and then primed with XIM - UMA Primer (according to instructions on container). XIM Primer is available through most good independent paint merchants, or can be ordered from Phillips. After allowing the UMA primer to dry for 3 or 4 hours it should be sanded glass-smooth with a very fine paper - 220 or higher.

Sorry, no we do not. We do light modification work (ie...holes and cutouts) to standard enclosures. Please link to our catalog page covering this subject (in Adobe reader PDF format).

Astronaut speakers may be requested through the Astronaut Appearances Office at 281-244-8866. General NASA speakers (scientists, engineers, etc.) may be requested through Community Affairs at 281-483-4754.

After extensive testing, we selected a combination of coatings which will withstand the rigors of our climate and remain beautiful for years. First our falcons are sprayed with a primer coat of Jotun’s Jota Shield Penetrating Primer. After a light sanding and base coating, our artists paint their designs using high quality acrylic paints. The finishing coat for our works of art is a premium clear car coating to protect them from the elements.

You can search by speaker name, topic, price and location. An outline and bio of each speaker is provided and most of the speakers have a short video clip of their presentation style.

If you have already submitted an Application form, you will receive an email acknowledging the receipt of your application. An Open Text representative will contact you within 10 business days to complete the remainder of your application.

even higher level of security is an enclosure. These are used in very high risk locations or to prevent any access to the computer or its drives. A steel enclosure is bolted to a secure surface, the CPU is inserted and connected and the front of the enclosure is locked. Steel enclosures are available in a variety of sizes and configuration; please call us for further information.