We need a minimum 50 degree temperature to safely let deck preservative products cure and dry properly.

That depends on our climate. Decks in the direct sunlight tend to fade and dry out; decks in humid and shady areas grow algae and fungus spores. Both problems require attention yearly, or no later than two seasons apart. See similar questions...

There are products which are available upon request to wash and seal in one day. However, we choose a two-day method: Wash on the first day, and sand and seal the second dry day. See similar questions...

This mainly will depend on the weather. On average a Pressure Treated Pine deck can be sealed in approximately 45-60 days from installation. A Cedar or Redwood deck can be sealed within 21 days. If you have a fair amount of rain you will need extra time for drying the wood out. Essentially you are making sure you don't seal in any moisture as this will promote rotting from the inside out. See similar questions...

This primarily comes into play if your deck is well above ground (4' or higher). The answer is no. The reason you are sealing your deck is to prevent the sun from aging the wood and more importantly, to prevent rain from rotting your deck. Since the understructure never receives any real sunlight and gravity dictates that water will not stay on the underside, it is not necessary to seal that. See similar questions...

Yes. If you elect not to seal your deck it will age prematurely and will not last as long as a properly maintained deck. A properly maintained deck in our climate should last 30 years. for what type of sealer, we highly recommend to use cost as an indicator. There are definitely reasons why a gallon of Brand X costs $15.00 while Brand Y costs $40.00. Lower cost doesn't necessarily mean better value but it definitely could mean lower performance. See similar questions...

We recommend you let your deck dry for a minimum of four weeks after construction of your deck before we apply a penetrating sealer. The problem with new wood is that the grains are closed and the wood still contains natural chemicals called tannins and mill glaze. If left to nature, it would take 3-6 months for the grain to open and the natural chemicals to leach out. By using a combination of powerwashing and mill glaze remover, we can speed up this process. See similar questions...

Most sealers need a minimum of 4-8 hours to dry, although this can vary depending on the weather and the condition of your deck. If it rains soon after we apply the sealer, look for water spots. These are lighter discolorations on the wood similar to water marks left on fine furniture. If your deck has water spots, please contact us immediately to have the sealer re-applied. See similar questions...

Commercial roofs can be sealed with an Elastomeric coating applied directly to the concrete cover. Rubber Membranes can Steel Rib systems can also be applied directly. More conventional finishes (such as residential shingles) can be installed over furring strips which are anchored directly to the concrete cover. Always follow the manufacturer's instructions for proper applications. See similar questions...

Sealing and staining your deck or fencing adds vital nutrients to the wood surface, so that it will not deteriorate at an accelerated rate. Wood products take a tremendous beating through seasonal changes, i.e.;. warping, cracking and/or graying (ultraviolet damage). With these elements attacking wood on a day to day basis, you can see the importance of having your deck or fencing treated right away. See similar questions...

To insure the best protection and the best appearance for your deck, it should be maintained on a yearly basis. Decks take a tremendous beating from the weather and will deteriorate rapidly without proper care. We recommend a yearly power-wash and the application of another coat of sealer to keep your deck at its best. See similar questions...

Once manufactured, cold or heat should not affect the product as long as the product is properly wrapped. However, the product should be acclimated to a print room for at least 48 hours before imaging. The raw co-hesive material is another story. If the temperature of the raw co-hesive drops below freezing, the material is destroyed and cannot be used. This is a quality control issue for the forms manufacturer. See similar questions...

For more than 125 years, the ADA has promoted safety and effectiveness of dental products as part of its mission to advance oral health. As early as 1866, an ADA committee prepared a statement on dentifrices (toothpaste) that questioned whether the extravagant claims made on behalf of patent tooth powders and other dental nostrums of the time were just “an imposition on the public”. See similar questions...

The ADA Seal of Acceptance is designed to help consumers make informed decisions about safe and effective consumer products. Market research has shown that the ADA Seal on a product directly affects the purchase decisions of consumers. Each year, the ADA receives hundreds of inquiries from companies about new and existing products. See similar questions...

Commercial roofs can be sealed with an Elastomeric coating applied directly to the concrete cover. Rubber Membranes can Steel Rib systems can also be applied directly. More conventional finishes (such as residential shingles) can be installed over furring strips which are anchored directly to the concrete cover. Always follow the manufacturer's instructions for proper applications. See similar questions...

A Backlash deck consists of up to 12 cards that contain no more than 6 Pre-match and no more than 6 Mid-match cards. They are not part of your hand and do not count as part of your Arsenal. The deck is separate. See similar questions...

Once our experts feel that a site has either met or exceeded our service standards, we then rank each website using a 0-5 seal ranking system, 5 being the highest. Websites that achieve a rank of 5 will be entitled to display our numbered Seal of Approval on their website. See similar questions...

No, it might even feel a tad warmer since we are flying with the wind and you won't feel a wind-chill. See similar questions...