Which size foot do I need ?
frequently asked questionsThe foot length should be kept as short as possible. For a firm load (such as a box) it does not need to be as deep, for a softer load (a sack) the foot must fully support the load.
What size system do I need?
Frequently Asked Questions - Drying & Dehydration | Nyle...The first step is to determine how much lumber you’ll dry in a year. Then figure your average drying time for each of the species you’ll be drying, and you can calculate the size kiln you need from there. For example: you need to dry 500,000 board feet of oak per year. Fresh off the saw, oak takes about 28-30 days to dry, so you’ll be able to do 12 loads in a year. Each load will need to be 42,000 board feet to give you the 500,000 board feet you need for the year.
Do you need to know my shoe or foot size when ordering?
FAQsAll Ultra 2008 Shoe lifts™ will work in any standard footwear, regardless of foot or shoe size of the wearer. This is because, unlike conventional insoles, the lift rests under the heel only, and does not extend the full length of the footwear.
What size AC unit do I need for a 2300 square foot house 2 story?
Ask the Experts - EnergyVortexWE are a large Healthcare organization in North Carolina. We acquired a 300 unit (apartment) Retirement Community in the alst few years. We need to upgrade and replace all of the "through the wall" units that serve each apartment (square footage varies from 480 sq.ft. to 1400 sq.ft. Magic Pak heat pumps (12000 BTU, 18000 BTU/ 24000 BTU- according to size of area) are being suggested for replacement. I am looking for an opinion on these units- good, bad or indifferent.
What size tank do I need?
Frequently Asked Cichlid QuestionsThe general rule of thumb in aquarium keeping is to have no more that one inch of fish per gallon of water. Thus, if you had a twenty gallon tank (with no substrate or rocks to diminish the total water volume), you could have five 4-inch fish. This formula also assumes you will change 25% of the tank volume each week. See What is a water change? Why is it important? for more details. Realistically, however, you will need to consider the following factors when choosing what size tank to purchase:
What size weight distributing do I need?
Frequently Asked QuestionsWeight distributing is based on the amount of loaded tongue weight the trailer has. To purchase the correct size weight distributing hitch (WDH), you will need to first load the trailer as you would tow it down the road and then have the tongue weighed. You can weigh the trailer tongue by using a bathroom scale or taking it to your trailer dealer to have the tongue placed on a tongue scale.
What size speaker do I need?
HSU FAQ - Frequently Asked QuestionsWhile there is no such thing as "too much" power in a sound system, the system should be powerful enough to fill your room. To help you pick the right product, each HSU speaker and subwoofer has a "Loudness Level" index —a rule-of-thumb guide to point you towards the best system for your space.
How do I work out what jewellery size I need?
Body Piercing, Jewellery Frequently Asked Questions | Flux P...Our measurements are given in stem thickness first followed by internal diameter/length eg.: 1.6 x 12mm. Our rings are always measured internally. Straight and curved barbells are always measured between the balls. On curved barbells (eg., belly bars) measure the shortest distance between the balls along the inside of the curve. Inches to millimeters conversion (you my need to round up or down to the nearest whole mm as necessary):
I just bought a pair of custom orthotics why do I need to exercise my foot muscles?
Foot Trainer - Frequently Asked QuestionsOrthotics help to improve bone alignment and biomechanics and can provide protection and comfort, however they do not address the underlying cause. Improving your foot muscles with Foot Trainer exercises addresses the cause and will compliment your orthotics and help prevent re-injury.
What can I do about athletes' foot?
Grapevine Podiatrist, Podiatry, FAQ, Colleyville, SouthlakePerspiration in a dark moist environment is the perfect place for fungal producing athletes' foot. Athletes' foot can spread around locker rooms, spas, pools and other public areas. It is important that you protect your feet in these areas and wear flips flops, crocs etc..
What should I do if I get something stuck in my foot?
The Barefoot FAQNote: The following does not constitute medical advice. It is only the personal experience of some barefooters and no claims are made that these techiniques will work for anybody else. Use them at your own risk.] Get yourself a really good pair of finely tipped, needle-nosed tweezers. Sterilize them and the area of the foot where the object is embedded. Under really good light, try to locate and grab hold of the object. Pull it out. The following was contributed by Louis van Rooyen.
What is Athletes Foot?
Athletes Foot Frequently Asked Questions - Athletes Foot FAQ...Tight-fitting trainers are a common cause of athlete's foot. Athlete's foot is a fungal infection of the foot caused by parasites on the skin called dermatophytes. Dermatophytes can be divided into three groups according to their favourite hosts: Athlete's foot is usually caused by anthropophile fungi. The most common species are Microsporum, Epidermophyton and Trichophyton. These account for 90 per cent of all skin fungal infections, commonly referred to as ringworm.
How many bones are in the foot?
Frequently Asked Questions - Southern Ohio Foot and Ankle As...Each foot contains 26 bones, 33 joints, 107 ligaments, 19 muscles, and several tendons that hold the foot structure together and allow the foot to move in a variety of ways.
Can you do anything about foot odor?
Frequently Asked Questions FAQ's - Avenue U Podiatry PC - Dr...Yes, foot odor is caused when bacteria breaks down the components that make up sweat. Stopping the sweat with topical medications has a dramatic and often quick result.
Why can't I find the small or large size I need in a particular size?
Lids - FAQ'sThe smallest size we carry is 6 5/8. The largest size is 8. We will always carry core products in full size runs -- 6 5/8 through 8. Unfortunately, our vendors do not always make "Limited Edition" styles in full size runs, so they may be unavailable in smaller and/or larger sizes. We are always working with our vendors to expand size ranges offered.
If I need to span 6 foot sections, does a person need to buy type M or type L?
Blacksmithing and Metalworking Q&A : anvilfire Guru page...I am 22 yrs old, I live in Missouri, more closely the bootheel in the town of Dexter. I am seriously looking to start the trade of blacksmithing, Mainly armor and weaponry. I am an avid read so when this idea came to me a 3 years ago I got a hold of every book and studied them. Sadly although I learned much, I find I learn more by hands on teaching. At this moment though I am simply requesting information on what I "really" need to get started.
