You need to look at the board. Near the Slot1 connector there is a chip with around 30 pins or so. Some of these chips can provide 1.3V-3.5V, while others can only provide 1.8V-3.5V. Attention, dual-cpu boards have two voltage regulator chips, and it is possible that one is of the new type and the other not! This list is not complete. Asus has used quite a lot of different voltage regulator chips on its boards, so it's possible there are even more that Asus used I'm not aware of.

A voltage regulator, aka a charge controller, is a device in a photovoltaic system which prevents over charging (aka 'cooking') batteries. Depending upon the sophistication of the unit, it may also prevent over-discharge of the batteries and reverse charging of the cells. See similar questions...

A voltage regulator functions as a voltage converter as well as a voltage stabilizer. A voltage stabilizer will stabilize the electricity to a fixed current. VC model transformers come with a European-to-American plug adapter. You can find additional types of plug adapters on our site. See similar questions...

The voltage regulator controls or regulates the alternator's output. Think of it as the brains of the charging system. It senses how much voltage is needed by your vehicle, then modifies the field current within the alternator so it puts out just the right amount of current. Too little current can allow the battery to run down while too much can damage it and other electrical and electronic components. See similar questions...

The HT71XX provides a +/-5% voltage tolerance while the HT71XX-1 offers an enhanced +/-3% voltage tolerance. See similar questions...

The HT73XX series of voltage regulators offer voltages in the following categories: 1.8V, 2.5V, 2.7V, 3.0V, 3.3V, 3.5V and 5.0V voltage levels. See similar questions...

The HT71XX-1 (HT71XX) series of voltage regulators is offered in voltage ranges of 3.0V, 3.3V, 3.6V, 4.4V and 5.0V. See similar questions...

No, the Vcc voltage supplied to VccA and VccB of PI74AVC164245 can not be reversed, please comply with the Vcc requirement specified in datasheet. Compared to a passive switch voltage translator, a logic voltage level shifter can drive longer trace with higher capacitive load at higher frequency, due to its active driving output. It is also capable of translating a voltage level from both high to low, and low to high. See similar questions...

The Children's Health Insurance Program, or CHIP is a state health insurance plan for children. Depending on income and family size, working Utah families who do not have other health insurance may qualify for CHIP. See similar questions...

The old version of the HT75XX has both TO92 and SOT89 packages. The new version of the HT75XX-1 offers TO92, SOT89 and an additional SOT25 package type. See similar questions...

In far and away the majority of R/C Rx applications a 6v NiMH pack provides the same faster servo speed and increased servo output power a 6v Nicad would without any of the twitches or jitters long associated with Nicad 6v systems. Nicads display a relatively high ‘surface voltage spike’ fresh off of a peak charge, and that’s what’s producing those un-nerving servo jitters. See similar questions...

Answer: The 5-V regulator's capability is limited by the maximum sustained power dissipation of the package. Soldering the MC33794 exposed backside pad to copper cladding on the mounting side of a PCB for heatsinking purposes allows the maximum available current to be drawn-limited by the temperature rise. Do not exceed the part's thermal rating. See similar questions...

These letters once refered to battery classes for circuits. (You'll notice that tube texts generally show batteries as power sources for the various DC voltages - they meant it!) A batteries were for the heaters (filaments). B batteries were for plates and other (relatively) high voltage supplies such as screen grids. C batteries were for control grid bias supplies. The B voltage is positive (B+). The C voltage is generally negative (C-). See similar questions...

All of the above wires carry relatively little current. A #14 wire (check the package at the parts store) will be plenty heavy for these wires. Ground - There should be a #14 wire from this connection to one of the mounting screws on the base of the voltage regulator. You will need to make the following connections in addition to the above. See similar questions...

Even though a parent does not have to give information about their own immigration status or social security number, parents do still have to give information about their family's income and assets. Parents may also be asked to provide documents to prove the family's income and assets. Yes. Parents can apply for CHIP or Children's Medicaid for their children without affecting their chances or their children's chances of getting a green card. See similar questions...

The equipment used that permits the diver to breath the air from the air cylinder. The regulator also provides the connection of the SPG and the BCD to the air cylinder. The quality and performance of a regulator is measured by how easy it breathes. See similar questions...

Remember the voltage is 220 Volts in Europe. You will need a voltage converter and adapter plugs for all electrical appliances. Check with the labels on your electronics items, many will be dual voltage- laptop computers, video chargers, etc... Back to top See similar questions...

Using a standard r/c battery meter with a 300mah load you will get 5.5 volts on a 4.8v (4 cell) pack. And about 6.9 volts on a 6v (5 cell) pack. The radio battery will read 10.8v See similar questions...