The most common cause of power steering system leaks is age and/or high mileage. After time, power steering seals and o-rings tend to dry out and shrink causing leaks. Rislone Power Steering Stabilizer with Stop Leak works to revitalizes these seals and makes them soft and pliable again.

The seal restorer additive restores seal size, flexibility and elasticity lost due to heat, age and high mileage. The seal polymer works by building a polymeric film around the seal or o-ring and also filling in any grooves worn in the shaft.

Gearbox (Re-circulating-Ball): Most Rear-Wheel & 4-Wheel Drive. The gearbox contains a grooved metal shaft called a worm gear. This gear is threaded into a metal block with ball bearings between the threads to reduce friction. The block turns a pitman arm which is connected by the tie rods to each front wheel. Rack & Pinion: Most Front-Wheel & All-Wheel Drive. The steering shaft connects to a pinion gear inside the metal housing.

After time, power steering seals tend to dry out and shrink. Bar's Leaks Power Steering Stop Leak revitalizes these seals and makes them soft and pliable again.

Yes, Bar's Leaks is one of the only Power Steering Stop Leaks that is compatible with all petroleum based, mineral oil, and synthetic fluids. This includes all domestic, import and heavy duty power steering applications.

Yes, Bar's Leaks Power Steering Stop Leak contains special friction modifiers to help reduce bearing, piston and valve noises.

Yes, Rislone Power Steering Stabilizer contains special friction modifiers to stop bearing, piston and valve noises inside the pump.

Depending on the severity of the leak the first thing you may notice is spotting, where you will find fluid spots, located on the driveway or garage. While looking under the vehicle around the area where the rack & pinion or gearbox is located; or the front of the engine where the belt is located, you will find fluid dripping. The next thing that happens is the steering wheel becomes harder to turn or does not turn smoothly.

Steering racks usually fail gradually. They operate under very high pressures, particularly when you do sharp turns, such as when parallel parking. That pressure gradually weakens the valves and seals in the rack, over time. Typical symptoms includes visible leaks and "morning sickness", where the steering is hard and sluggish to turn first thing in the morning, but improves after the car warms up.

Yes, Rislone Power Steering Stabilizer with Stop Leak is compatible with all petroleum based, mineral oil, and synthetic power steering fluids. This includes all domestic, import and heavy duty power steering applications.

Yes, usually damage to your power steering pump will happen within relatively few miles if you continue to drive with little or no fluid in your power steering reservoir.

Whilst modifications to the pinion valve are sometimes possible, it is both difficult and expensive to do.

Yes. The cars are designed to turn left, and hence they are very heavily weight jacked to turn left. The pressure on the steering is enormous - and to attempt to run without power steering would be very hard on the driver. When the cars are sitting still it is easier to turn the actual wheels on the ground than it is to turn the steering wheel.

If you have a very minor leak, you may not be able to add the entire bottle. The product works great for topping off the power steering fluid level any time you need to add fluid.

Just read up in the manual and all VW's use ATF II up till april 89. After april 89 use the special Petrosin hydraulic fluid CHF This is an old problem that may have numerous causes. Mostly A2 Golfs/GTIs/Jettas/GLIs (8v & 16V) are affected. First make sure everything "obvious" is ok: vacuum (hoses, pipes, intake), electrical connections, tuned up right, spark plugs, distributor, good tank of gas, etc. These are by far the most likely causes of this annoying problem.

The simple fix, as someone mentioned on here, is to tighten the power steering belt. I had the problem with mine during this winter and performed this procedure. It alleviated the problem. There was no stiffness in the wheel and squealing. Go under the car and locate the power steering tensioner pulley.

Many vehicles can have power steering fitted but it does depend on the exact year and model of the vehicle and is usually fairly costly.

Changing the fluid in your power steering system will extend the life of your power steering pump and rack. We recommend having a Power Steering flush performed. Which will change almost all of the old fluid. When the P/S fluid gets dirty, it can no longer lubricate as it was designed.