Buy a new BOV. Turbo XS BOV's seem to have some of the loudest and meanest BOV's. Here is a site that allows you to listen to different BOV's out there.

Turn up the phone's volume. No, just kidding! Use a free MIDI composer such as Anvil Music Studio. It allows you to adjust volume settings of a MIDI song. Be sure to pick and adjust the correct track (e.g., the melody). Also considering assigning a different instrument to a track. For example, I find that the Electric Piano is louder than the Acoustic Piano. Visit the MIDI sites listed in the Related Links section. Also, use Google or other search engine to search for songs. E.g.

The simple answer to this is 'no'. Headers by nature do not increase the Db range by themselves. The main reason for any exhaust system to increase the sound level is found in the choice of mufflers. Car manufacturers choose to use very restrictive but sound efficient reverse flow mufflers. These mufflers are very effective in reducing noise levels but also are very restrictive in flow. Some after market mufflers are very good in producing a high flow rate while still remaining within the law.

Using the technique described in the SFX section, create a file called 'default.sfx' and save that file in the voice's data directory. Then add the following line to the 'default.sfx' file: The range can be from 0 to infinity, with 1 being the default. The value is a multiplier. "GAIN 2" is twice as loud as default, and "GAIN .5" is half as loud as default. You may have to play with the levels to get it just right, since some voices may pop if the signal becomes too strong.

The Blow-Off valve (BOV) is a pressure relief device on the intake tract to prevent the turbo's compressor from surging from the backed up pressure waves caused by a suddenly closed throttle. BOV's do not control boost levels. The BOV should be installed between the compressor discharge and the throttle body. When the throttle is closed rapidly, the airflow is quickly reduced, causing flow instability and pressure fluctuations.

more than I0 lbs. of nitrous oxide by weight. Over-filling and/or too much heat can cause excessive bottle pressures forcing the safety seal to blow and releasing all the contents out of the bottle.

No. Traps must be installed at all low points. These traps must be properly sized. If there is sensitive equipment on the line, a steam separator could be required. Call Con Edison to work with you.

Battlefield 2142 - Technical Support & FAQs Technical Support and FAQs for Battlefield 2142 and related mods.

The KosherClock does not have a volume control for the default tone or recorded music for your alarm. However if you wish the recorded tone to be louder simply record your prefered music at a louder volume and the clock will play it at the recorded volume. Click Here for a sample pre-recorded niggun for your clock. Enjoy!

This can only be answered if we hear what your mixes are sounding like, and what you desire you final CD to sound like. Even then, compression used on a mix bus can be an essential part of the mix, and just "taking it off", could make things worse. We sometimes suggest that project studios not compress their overall mixes (especially if you are not familiar with what limitations are created by over using two-mix compression).

ANSWER It is very important not to overfill a bottle; i.e., a 10 lb. capacity bottle should not be filled with more than 10 lbs. of nitrous oxide by weight. Over-filling and/or too much heat can cause excessive bottle pressures forcing the safety seal to blow and releasing all the contents out of the bottle.

It is best for one to resist the temptation of installing an aftermarket BOV as our cars were not designed to release excess boost pressure into the atmosphere. Doing so will effect the PROcede's tuning and cause the car to run poorly. The car was designed to recirculate that excess air back into the intake system. Bleeding off the air that was accounted for by the MAF sensor will confuse everything.