The equipment used that permits the diver to breath the air from the air cylinder. The regulator also provides the connection of the SPG and the BCD to the air cylinder. The quality and performance of a regulator is measured by how easy it breathes.

If you're using T-Tape, soaker dripline or Aquapore you will need a regulator. Read the individual product descriptions for pressure recommendations. If you're using pressure compensating emitters, Shrubblers® or misters and have normal pressure you may not need a regulator. If you are using sprayers, you may want to use a pressure regulator to bring the water pressure into the rated range of the sprayer, since they will generally put out more water at higher pressures.

The setup for a simple drip system coming off a hose bib or faucet is as follows: Timer (optional), filter, pressure regulator, female hose beginning (Easy Loc or Compression), mainline tubing, end.

A voltage regulator, aka a charge controller, is a device in a photovoltaic system which prevents over charging (aka 'cooking') batteries. Depending upon the sophistication of the unit, it may also prevent over-discharge of the batteries and reverse charging of the cells.

A regulator is an organisation that controls or supervises an industry or practice by way of rules or regulations. The Electricity Commission regulates the operation of the electricity industry and its wholesale and retail markets in accordance with the Electricity Act and government energy policy. The creation of effective electricity regulations and rules is a core function of the Commission.

Unless you are using less than two solar panels a regulator will be required to prevent the battery from being over charged. Modern regulators are extremely intelligent and can ensure that your battery is receiving the appropriate amount of charge to maximise its life. BP Solar has a range of regulators to suit differing applications.

The National Pension Commission is charged with the regulation and supervision of the pension schemes as well as the powers to formulate, direct and oversee the overall policy on pension matters in Nigeria.

Diaphragms leak a small amount due to migration of gas through the diaphragm material. Casing vents (where provided) should remain open to gas to escape.

In any newly liberalised market, the incumbent telecommunications provider has an enormous advantage over new entrants: it initially has all the customers and owns the entire infrastructure. The company, left unchecked, has the incentive and, in most instances, the ability to drive new entrants out of the marketplace. Under such circumstances, the development and sustainability of competition is seriously impeded, if not impossible.

The propane tank is connected directly to the regulator instead of hose. Connect a hose between the regulator and tank, which will allow the cold propane to heat up a little.

About once a month, soak the Weight in detergent solution for some time, then clean it with a piece of cloth to remove all the dirt and food particles. Pour hot water to remove traces of detergent and use it again.

Answer: The on-chip regulator provides the sensor with the necessary self-contained 5-V supply. It also offers the designer a means to power external circuitry. This approach eases the design complexity and PCB size concerns.

Answer: A 5-V regulator was chosen because it remains a popular operating voltage for a wide range of MCUs and components, and because it's the chosen internal voltage for the MC33794 design. A 5-V supply rail has the advantage of outputting a larger detected electric field voltage for digitization by an off-board A/D converter.

For safety reasons non-relieving regulators are recommended for use with liquids only and with adequate means of downstream relief.

The emitters on your drip irrigation system have very small openings for the water to pass through. The filter prevents sediment from clogging your emitters, ensuring your plants will get the correct amount of water. A pressure regulator keeps the irrigation system at the manufacturer's recommended pressure (usually between 20 and 40 pounds per square inch). Not installing a pressure regulator may cause fittings and lines to fail, creating wasteful breaks and leaks in your system.