All Twisted Pair products from Altinex can either use any common CAT-5, CAT-5E or CAT6 cable. This makes the connection of AV products over an existing network easy and cost effective. Altinex twist pair products, MultiTasker based or Stand alone, have build in equalization that allows correction of a video signal for long cable runs. To ensure the best results and the longest distance possible Altinex offers no-skew twisted pair cable which does not require any equalization.

Nowadays, EURIDIS is the only international standard working with twisted pair cables for the remote reading of residential meters. The basic solution uses a field bus for communication. Nevertheless, because it may be difficult in some cases to install the two-wire EURIDIS cable, new AMR technologies have been designed over the last few years. See similar questions...

UTP cable will give the best quality video over long distances because it has less capacitance per unit length. However, STP may be a better choice in electrically noisy environments. See similar questions...

To connect 100vg hubs with twisted pair cable, you must use the uplink and downlink ports on the 100vg hubs. The hub that is connected to the server is called the "root level" hub. Hubs connected to the root level hub are called the "second tier" hubs, and hubs connected to the second tier hubs are called the "third tier" hubs, etc. To connect a root level hub to a second tier hub, you connect a cable from a downlink port on the root level hub to an uplink port on the second tier hub. See similar questions...

No. Since 100vg technology uses all 8 wires "straight-through" for high speed transmission, crossover cables cannot be used. Uplink and downlink ports exist on 100vg hubs to allow the hubs to be connected using "straight-through" cables. See similar questions...

Category 5 cable is preferred to be using with twisted-pair Ethernet in structured wiring environments. This will ensure correct operation of all ports at 10Mbps, 100Mbps or 1000Mbps. Note that for Gigabit Ethernet, all 4 pairs of the twisted-pair cable are used for transmission and receiving signals. See similar questions...

Yes, Use category 6 twisted pair wire, the range would be longer and have highly interference immunity. See similar questions...

M bps runs at Cat. 5 twisted-pair cable will cause some cross-talk signal. If the 3rd and 6th wire of RJ-45 connector are not belong at the same twisted pair. That will cause problem with longer distance as above 40 meters. User should check the wiring before install the 100Mbps network. See similar questions...

A standard CAT5 / CAT5e or CAT6 cable is made for computer network signal transmission where each twisted pair could be of different lengths. Using standard twisted pair cable could cause a color shift known as "skew." We recommend the Altinex No-skew Twisted Pair Cables, CB3150PV or CB5600PL, to minimize color shift (skew) on long cable runs. See similar questions...

Twisted-pair Ethernet (10BASE-T, 100BASE-T, or 1000BASE-T) uses an RJ-45 connector, which is an eight-pin modular connector. When looking at an RJ-45 wall jack (female), contact 1 is on the left and contact 8 is to the right. When looking at the RJ-45 connector on the end of a cable (male) with the tab on the bottom and the contacts on the top, contact 8 is on the left and contact 1 is to the right. See similar questions...

Yes, FORESIGHT Video Transceivers could use ordinary telephone wire to transmit and the range up to 300 meters. But the interference would occur easily, therefore we do not recommend this solution unless special environment requested. See similar questions...

Most flights are accomplished with single engine, four-place aircraft; however, we also have pilots who fly twin engine and turbo-prop planes. To complete a typical Angel Flight mission, the plane does not have to be large or fast, nor does it need to be pressurized. See similar questions...

It is a modular and highly adaptable AV system, which integrates all AV and control components in one place, with a single power connection and a single point of control access. The concept is similar to that of a customizable PC. Select an enclosure, select the AV and control components, select the control software and then build the system. It depends on the size of the project. See similar questions...

CAT-5e cable is not rated for outdoor use, however it can generally be used without a problem. If possible, run the cable through some kind of conduit to prevent moisture or an attractive site for lightning to strike. You should be able to find gray PVC conduit suitable for cable at any hardware store. Remember, 100 Meters is your max distance, without some kind of hub, bridge or amplification. See similar questions...

Find the software to your ethernet card. Install the driver software for your ethernet card. Then follow the directions to obtain access to the HMS newtork. See similar questions...

You don’t have to be an engineer to succeed in EMIL! Our participants come from liberal arts, engineering and sciences backgrounds. Their responsibilities span the organization to include: Supply Chain Strategy, Operations, Logistics, Sales & Marketing, Material Handling, Manufacturing, Distribution, IT & Project Management. See Admissions for specific participant admissions requirements. See similar questions...

Vertical suspensions are usually done with four to six hooks (with extra hooks for the arms in the case of a crucifix suspension), and horizontal suspensions are generally done with eight to twelve hooks, but are not uncommonly done with as many as 24 hooks. The amount of hooks used per suspension depends on two factors, the experience level of suspendee experience and weight of the suspendee. See similar questions...

A UTP cable consists of 4 pairs of twisted-pair cable, in which one pair of wiring is used to transmit data and one pair is used to receive data. To resist the disturbance, each pair send both "positive" and "negative" signals simultaneously, denoted as TX+ and TX-, as depicted below: See similar questions...

Use UTP (unshielded twisted pair) CAT 5 24 AWG (or over) to have the best transmission quality performance. To use STP (shielded twisted pair) cable, the shielded would cause internal signal interference, so the transmission range would be shorter ( 1.5KM--- >0.8KM) than UTP cable. Un-twisted wire not to be recommended, which easy have interference and range would be shorter. See similar questions...

Coaxial cabling transmission over 200 meters (RG59), the video signal would loss and have bad video image. Using FORESIGHT passive video transceiver range could up to 300 meters (Color), 600 meters (B/W), even 1KM, 2.4KM to work with active transceiver. To use FORESIGHT TDP414V/TTP414V 4 channel transceiver/cable hub, only need one single CAT 5 cable to transmit 4 video signals for cable saving and fast installation. See similar questions...