Yes. Inserts are available in natural vent and direct vent units. Flue liners are used to exhaust flue gases. We can assist and advise you which insert and vent application is required.

Yes. Gas inserts are available in chimney vent and direct vent models and both are installed with aluminum liners running up the chimney. We are able to assist you in choosing which model and size would be needed after the measurements of the fireplaces have been determined.

All of our wood and oil fireplaces require a chimney, either a masonry or A vent, stainless steel chimney and in the case of our oil stoves, L vent is also acceptable. The diameter of the chimney must match the size of the fireplace flue collar to effectively vent the products of combustion. Consequently, an existing chimney may need to be lined with a stainless steel liner to meet venting requirements of a specific fireplace.

Direct Vent Gas Fireplaces eliminate the need for a conventional chimney. These fireplaces vent directly though a wall or out the roof. Unvented Gas logs utilize new berner technology and high burn temperature to keep the carbon monoxide levels down to an acceptable level.

Although the frequency of your fireplace servicing and maintenance will depend on use and the type of installation, you should have a qualified Mr. Fireplace service technician perform an appliance check-up at the beginning of each heating season.

No! The beauty of Regency Direct Vent technology is that you do not necessarily need to go up through your roof to terminate the venting. All you need is proximity to an outside wall, the distance to which depends on the model you choose. Not only does this make installation more flexible, but it also keeps the costs down. And with our sleek and attractive patented AstroCap horizontal termination cap, you won't be cluttering up the outside of your home either.

Vent free fireplaces are fireplaces that do not require any type of vent system. Instead, they are designed to burn clean and the combustion by-products allowed to flow into the room the fireplace is located in. Stringent requirements ensure that these fireplaces not only burn cleanly, but that they are located in rooms of sufficient size to ensure an adequate supply of fresh air is always available for the combustion process.

There is no chimney or venting required with an InFlame Fireplace. The Sunjel? Premium Ethanol Alcohol Gel burns clean, free of smoke and fumes and into water vapour, eliminating the need for standard exterior venting. Sunjel? Premium is certified by Environment Canada to be burned indoors without a chimney. All InFlame Fireplaces are also ULC Listed (Underwriters' Laboratories of Canada) for 'un-vented use' to Canadian Government Standards. 9.3-M86 AND CAN-ULC-S610-m87. Back to List

Not exactly. Direct vent gas fireplaces need to be vented outside, however, this vent, or "chimney" can be run horizontally through an outside wall. In this sense, it does not require a traditional chimney that extends vertically above your roof line. You should be careful however not to confuse direct vent with unvented gas hearth products.

How can I make final plans for my Mendota installation? I will need information for the building inspector, plumber, contractor etc.

No, this unit will not exhaust properly vented into a chimney. It must have its own three or four inch pell vent piping throughout its entire installation.

No. The inserts are designed to have adequate space on the sides for air exchange. Correct measurement of the existing masonry fireplace is important. The insert should never be forced into a space that is too small.

A - Only sealed direct vent fireplaces can be vented horizontally out a wall. The only exception would be an open fireplace with a power vented system, which is usually noisy and not recommended in residential installations. Q - I have a wood-burning brick and masonry fireplace that faces one direction. We would like to open it up so that is see-through and put in a gas insert.

These type of fireplaces do not have a sealed combustion chamber and relies on the buoyancy of hot gases to vent effectively. They must be installed either with an existing chimney that meets the local building code standards or they can be installed using a B vent which is a vent pipe that must be installed to the same parameters of a masonry chimney but can be enclosed in combustible material. They draw air (oxygen) necessary for combustion from the area surrounding the fireplace.

We bought one of your stoves 2 years ago and love it. However, the thermocoupler is faulting and needs replacement. We have misplaced our owners manual. Where can we find a new part or can I order one from you direct. Model #C9740LP serial # 002365. I just purchased C9947N and installed it Tues. evening (the 15th) from Quality Farm And Fleet, in which is going out of business. I have a considerable amount of carbon monoxide. Everything meets standards in the manual.

All vent-free appliances, whether natural or propane, produce water. The accumulation can range from 3/4 to 1pint of moisture per hour in the room. Under normal conditions, this does not cause a problem. However, if you have a problem, you will need to provide an outlet for this moisture. This can be accomplished by providing adequate ventilation or using a dehumidifier to help control the moisture. Yes/No.