It is recommended that a wood- burning fireplace be cleaned after one cord of wood has been burned since the last time the fireplace was cleaned. According to NFPA (National Fire Protection Association) Code 211 an inspection is recommended annually.

EPA Regulations are government regulations of wood burning appliances mandating that products sold after July 1, 1992, emit no more than 4.1 grams of particulate matter per hour for catalytic-equipped units and no more than 7.5 grams for non-catalytic-equipped units. When starting a fire, use plenty of crumpled newspaper and kindling. As a guide, fill the firebox completely with loosely crumpled newspaper and hold it down with at least ten pieces of finely-split dry kindling.

Please make sure the flue is open before starting fire. NEVER remove hot ashes or partially burned loges. Please leave the ashes in the fireplace even if you are sure they are cold. It's easier to build a fire with a bed of ashes. If it becomes absolutely necessary to remove the cold ashes, use a metal container only. (Anything flammable, such as a paper bag or cardboard box, even if you are positive the ashes are cold, is extremely dangerous.

Unfortunately, no. You will need a wood pellet stove but if you don’t already have one, the savings you will realize in heating your home will more than pay for the stove. Some companies do offer converters which may be placed in fireplace inserts. Please check with your local hardware store or on the web to see if this option will work for you.

While they produce some radiant heat, most wood burning fireplaces are primarily decorative. Even heat circulating models still pull a tremendous amount of air from the home. There are several wood burning models that are efficient and clean burning. We also have several wood burning stoves and inserts that are very efficient. Click here to find a dealer near you that can help you with your decision.

No. If the fireplace is designed for use only with gas, this is a very bad idea. The fireplace is not designed to withstand a wood fire. And the gas jets are not meant to come in contact with ash. This is a real fire hazard. It's possible your fireplace was originally a wood burning fireplace and has been converted to gas. In that case, it can be converted back. But you shouldn't burn would in it until that's happened.

If you use your fireplace frequently, you should have it cleaned after 1 cord of wood & inspected annually.

If you have a fully operational fireplace, whether masonry or pre-fab, it would normally be as simple as removing the gas logs & capping the gas line or installing a gas log lighter. But with today's new appliances, direct vent & ventless units would not be set up for solid fuel (wood) & could not be converted to wood burning.

Dry, seasoned wood is best. The type of tree is not as important as moisture content. Wood must be allowed to dry for a minimum of 12 months, under cover, after being split and stacked. Popular firewood in the Northwest are: maple, alder, Douglas fir, spruce, apple and cherry. Another good fuel source is pressed fire logs, manufactured by pressurizing sawdust, as opposed to wax-based decorative logs, which have limited heating value.

Use seasoned hard wood. "Seasoned" wood is wood that has been dried out for at least half a year, preferably a year. It's opposite, green wood, will produce a cooler, smokier fire that's bad for your chimney. Hard woods are woods like oak, maple, beech, and ash. They burn hotter than pine, spruce, birch, or redwood. Do NOT use wood that has been painted or had finish applied. This could release toxic fumes into your home.

Carefully open the damper and, using a flashlight, look up the flue for signs of a build-up along the walls. Goggles are suggested for this. If the build-up is ?" or more, a cleaning is needed.

Yes, but placement is key. Again the fan needs to draw cooler air from behind to operate and the surface on which the Ecofan is placed should never exceed 340ºC (650ºF).

Burning of wood is required to meet certain EPA emission standards that a coal burning appliance does not handle. It is not a safety issue, in fact, until 1990 we sold the coal burning appliances of today as wood or coal. But, when the EPA Clean Air Act of 1990 was enacted we had to start marketing them has coal only. The wood models either had to have a catalytic combuster added or adjust the firebox to meet a 35:1 air to fuel ratio.

Yes, wood burning fireplace is one of the most inefficient ways to heat a room. Here’s why: Hot air rises, so the majority of the air warmed by the fire goes straight up the chimney. Only a small percentage of warm air will find its way into the room. The warm air leaving the room is replaced by cold air infiltrating from outdoors and other areas of the home.

Vent-free gas log sets can be installed in most masonry fireplaces, as long as the set's clearance and ventilation requirements are met. For installation in prefabricated fireplaces or fireboxes, follow the fireplace manufacturer's recommendations, as well as meeting the set's clearance and ventilation requirements. Refer to the log set's owner's manual to determine clearances and unconfined space requirements.

Unplug small appliances when not in use. Avoid accumulation of combustibles like paper. Do not use extension cords for permanent applications.

If you are using the wood flooring plans that we have provided, we recommend that you create a rock or sand hearth to put your stove on. To install your stove on the hearth, follow manufacturer’s instructions and local building codes. Each dome is equipped with a metal stove flashing. The piping will run from your stove through the flashing and above your dome. All of the piping that is used in association with the stove should be double walled pipe.

Factory built fireplaces or stoves capable of burning wood or wood pellets may be installed in manufactured homes provided they comply with the following State of Nevada requirements: quot;The fireplace or stove is approved or listed for use in a manufactured home or mobile home" quot;A fireplace or stove does not take the place of the normal heating unit or furnace of the manufactured home or mobile home.

Yes, a permit is required to install a wood or pellet burning stove. Currently, we charge $25.00 for fireplaces, wood or pellet stoves. (See 1997 UMC 112.1)

Yes, there are a number of resolutions with exceptional success rates based on your chimney type and its configuration. Chimney deodorizers may act only as a temporary solution.