No, usually. High speeds do not necessarily make a better broadcast. Your goal should be to achieve the highest speed at which the modem operation will be stable. Since slower connect rates are more tolerant of errors, some judgement is required to hit the right spot. In fact, the Answer Guy is partial to speeds of 28.8 kb/s and lower, as all V.34+ modems seem to be more stable at those rates. In addition, at any speed 24.

For 28.8 or 33.6 modems, normal connect rates will be between 21.6 and 28.8. Keep in mind that the connect rate reported at logon is just a snapshot of that moment and your actual rates will fluctuate up and down during the time you are connected.

The modem you are using is not v.90 compatible. If your modem is a kflex or x2 modem, it will only connect at speeds of up to 33.6kbps. You have not installed a v.90 compatible modem driver in your operating system. Consult your modem's documentation, manufacturer, or web site for further details. You are using a phone line, which is not 56k compatible.

Successive re-sizing and firing of a case result in eventual weakening of the brass, increasing the probability of case failure. The partially unsupported chamber in the Glock exacerbates this problem. quot;Hard crimping" or overseating of bullets, particularly in the .40 S&W, can cause dramatic increases in pressure almost to the same degree as a propellant overcharge.

Have you already upgraded to V.90 compatibility? If not, please do this first, as this usually fixes most problems. There may be several reasons that your modem may be unable to connect at it's maximum published speed. For example, using a 56K modem does not guarantee connection rates of 56Kbps! In fact, all 56K modems support a range of connect rates, mainly between 30K and 54K.

When transmitted over a modem, there are ten bits per byte (eight data bits plus a start bit and a stop bit). So if one modem seems ten times faster than another, it's because different units are being used.

If both these conditions are true, then FireWall-1 treats connections via the modems the same ways it treats connections via Ethernet, token ring, etc.

Wave Rider's modems are fully K56 V90 compatible. We can therefore handle any modem speeds up to 56K although it is recommended that the minimum speed required for a good connection to the Internet is 14.4K.

Reports compiled by Speir from various independent laboratories are inconclusive as to one single cause for the catastrophic failures. There do, however, appear to be several contributing factors which collectively may induce catastrophic case failures: Firing out of battery. Most Glocks will do this to some degree, especially those improperly maintained. Significantly overpressure rounds.

Due to a combination of factors, namely the high amount of downloads each day, and the availablity of high speed internet connections, it has become necessary to impose an artificial limit on the download speeds for normal users. Also at peak times its not unknown for the download server to have its connection 'flooded' because of the amount of users downloading at once.

Coined by firearms journalist Dean Speir, kB! is shorthand for "kaBOOM!," which is the written representation of what happens when one has a catastrophic explosive event in one's Glock. (See also Sidebar Addendum.)

DSL is typically an asymetric offering, with higher download speeds than upload speeds. Typical download speeds are 512kbps - 1.54Mbps and typical upload speeds are 128kbps - 512kbps. Cable modems are also asymetric, with similar upload speeds to that of DSL. The download speeds are often higher, ranging up to 3Mbps in many cases. It really depends on what the local DSL & Cable providers are selling, however.

Connection speeds are measured in units of "bits per second", usually Kb/s (Kilo bits Per Second) or Mb/s (Mega bits Per Second). This 512Kb/s means 512 Kilo bits Per Second, 1Mb/s means One Mega bit Per Second and 2Mb/s means Two Mega bits Per Second. In contrast, data transfer (and computer data in general) is measured in units of Bytes. One Byte contains 8 bits.

kB!s do, of course, occur in other guns, but no one appears to be keeping accurate statistics for most of them. Many 1911-style handguns have partially unsupported case mouths, and numerous case separations have occurred in these guns. Early .38 Super barrels were particularly susceptible, and the critical observer may have noticed the predilection among USPSA .38 Super competitors for full beards in an attempt to cloak the vestiages of what came to be known as "super face.

A 56K-modem can support one (or more) protocol for 56K connections: V.90, K56 flex or X2. Which protocol is supported by your modem can be retrieved in a number of ways: On the modem itself, the instruction manual, the packaging, the receipt, or from the supplier. If the commands AT13 and AT16 are send to the modem, the modem responds with a code, type or serial number, which indicates the protocol.

Answer: At this time, FlashNet does not offer this service. The answers to "why not?" vary depending on who you ask. Basically though, if we were to begin offering this service now, it would have to be purchased as a base rate plus hourly charge account, and the connection may not be as stable as a local call. We will attempt to avoid having our customers pay an hourly charge for access.

The CellSocket will work with certain devices that use DTMF to transmit information such as various makes of security alarm systems. You will not be able use the CellSocket for Data including modems, fax machines, credit card readers or satellite receivers. The fault does not lie in the product, but with modern digital cellular networks. Digital cellular networks use compression algorithms that will not allow modem or fax tones to pass through the network.

This can be repaired. It is important not to ignore this defect, because by restoring this circuit to normal operation your receiver's ability to download PPV information to the program provider will be restored. Usually the cause of this symptom is either power supply or system control related, and this can usually be repaired.