Coffee should be brewed at about 195-200 degrees Fahrenheit, just under the boiling point. Anything higher leads to a bitter taste. Boiling coffee also cooks off its delicate essences, robbing coffee of its nuances. The cost of some manufactured products is lower in the US than in Canada due to extra customs, duties, taxes, shipping and warranty expenses that Canadians face. If it's any consolation, no one matches our prices in Canada and, as a rule, no one in the U.S.

The hammering sound is usually an indication of CAVITATION. Cavitation is caused when the suction side tubing ID is too small to allow adequate flow of fluid to the pump. CAVITATION can cause problems such as hammering, flow variation, bubble formation, loss of prime and eventually pump damage. See similar questions...

We used to be Taylor Freezer. With the development of cooking equipment in the mid-80's, our business name was changed to Taylor. See similar questions...

Yes you can. Synchronization of our sound effects in this manner is permitted under the terms and conditions of the Sound Ideas End User License Agreement. Sound Ideas' sound effects are sold as royalty free products. This means that you do not need to pay any additional money to Sound Ideas if a production is going to be broadcast or performed publicly. If your broadcast production makes use of our royalty free music, you must file a Cue Sheet with your local Performing Rights society. See similar questions...

Yes we can! A clicking hard drive usually means that your drive has internal mechanical parts that have failed. In order to recover mechanically failed drives, a clean environment is needed. Flashback Data's recovery lab is equipped with a Class 10 clean environment. The class number refers to the maximum number of airborne particles greater than or equal to one-half of a micron that would be allowed in one cubic foot of clean environment air. See similar questions...

Putting a glow novelty product in your home freezer will slow down the chemical reaction, but it will not stop it. Hopefully, you will get an extra night of fun and glow! See similar questions...

The sun method involves floating flowerheads in a clear glass bowl filled with natural spring water. This is left in bright sunlight for three hours, then the flowerheads are removed and the energized water is mixed half and half with brandy. The boiling method involves putting flowering twigs into a pan of spring water and boiling them for half an hour. The pan is then left to cool, the plant matter removed, and again the water is mixed half and half with brandy. See similar questions...

Boiling tools is an accepted time tested technique among field medics, but it's far from acceptable as anything other than a "no other options" type solution. You will get partial sterilization if you boil for an hour, but there are many, many microbes that you will not kill. This might be an acceptable way to clean tools and jewelry that have been used on either no one or only on you, but this is definitely not an acceptable way to clean tools that have come in contact with anyone else. See similar questions...

It is dehydration or drying that occurs on the surface of a frozen product if it is improperly wrapped. The food is safe to eat but poorer quality. To prevent freezer burn, the package must be free of air and sealed airtight. Freezing does not improve the quality of the product. Frozen food is only as good as the quality of the fresh food. So, select only high quality products at optimum maturity and freshness. See similar questions...

If the Food has been defrosted we do not recommend re-freezing. Refrigerate defrosted food and eat in a few days. If the food is frozen you can put it in the freezer. See similar questions...

Yes, the higher the sugar concentration of the sap, the less water that needs to be removed to make syrup. Each time you double the sap sugar concentration, you cut in half the amount of water that needs to be removed and the boiling time. For example, sap with 4% sugar requires half the boiling time of sap with 2% sugar to produce syrup. (You need 21 ? gallons of 4% sap and 43 gallons of 2% sap to produce a gallon of syrup.) See similar questions...

Anytime your detector goes off, it is important to pay attention. If the detector is sounding a loud alarm because it senses the presence of smoke, check your home thoroughly. If you smell smoke or are unable to locate a fire, call 911. If you don't smell smoke, the detector may be reacting to the presence of dust, steam, or a small insect. Dust and bugs can be removed by a vacuum cleaner. If the detector is just chirping, it probaly means that the battery is low. See similar questions...

If your engine is new do not be concerned. The parts are inspected during manufacturing and during assembly. Your engine has also been test run just prior to shipping. Everything is OK. Now, what is the reason for the clicking? Jett rods have about .003-. 004 (.07-. 1mm) rod-to-crankshaft clearance. This is approximately twice that of an O.S. This is why you see the extra motion. See similar questions...

Any time your smoke detector goes off, it's important to pay attention. If it's sounding its loud alarm because it senses the presence of smoke, check your home thoroughly. If you smell smoke and are unable to locate a fire, call 9-1-1 and we'll send an engine to make sure that a fire isn't smoldering in a hidden area and it won't cost anything. If you don't smell smoke, the detector may be reacting to the presence of dust, steam, or a small insect or spider. See similar questions...

If your monitor is experiencing this issue please contact Customer Service for further assistance at 888.8.ASK.SVA. See similar questions...

The drive has an internal problem which is commonly known as "lost servo". Shut down your computer, remove the drive and send it to a professional data recovery company. Powering the drive off and on can only do more damage. See similar questions...

Make sure you are using the appropriate Fanimation speed control. If you are doing so, and the fan is still humming, you may have a faulty control and replacing the control may solve the problem. If you are using another type of control that does not have set speeds (low, medium, high), that is probably the cause of the noise. See similar questions...

Your chameleon is able to see its reflection and thinks there is another chameleon in its enclosure. (this is common with glass enclosures), It is very important to attempt to isolate the variable that is causing your chameleon distress, as stress significantly shortens a chameleon's lifespan. I suggest isolating one variable at a time and then observing your chameleon to see how it reacts, so you are aware of the element that was troubling it, as opposed to randomly changing everything. See similar questions...

Please firstly make sure the sound in the DVD are normal. Then there are two ways may resolve the problem. Increase the volume in "Input Settings" window. If the ripping volume is too low and you raise it when playback, you may hear the noise. Try to select other audio channels if the DVD has. The order is LPCM 2ch, AC3 2ch, LPCM, AC3. LPCM 2ch is the best choice which can ensure a good sound quality. See similar questions...