This is not affected if you switch. Some suppliers may offer you their own central heating cover, it is your choice, keeping with British Gas (for example) is fine. TOP

Essentially you do not need to change any of your existing controls. However, after you have had your SUNWARM for a week or so you might want to adjust your heating control to your comfort level. See similar questions...

Most systems utilize a desuperheater to transfer a small amount of excess heat in the system to a standard electric Domestic Hot Water, (DHW) tank. Annually a desuperheater can provide 50% to 60% of the hot water requirements for a family of 4 or 5. Demand hot water heating, (a.k.a. 100% hot water heating or a triple function machine), requires that a second condenser be built into the unit for hot water heating. See similar questions...

No. Although most modern boilers have a high limit thermostat, residual heat can be conducted by the heat exchanger. Unless the boiler manufacturer states otherwise, a minimum of 1 metre run of pipe from the boiler casing should be copper. This recommendation includes the cold water mains supply to a combi boiler. See similar questions...

Yes. A GSHP can be a combination heating/cooling and hot water heating system. You can change from one mode to another with a simple flick on your indoor thermostat. Using a desuperheater, some GSHPs can save you up to 50% on your water-heating bill by preheating tank water. See similar questions...

To make a double boiler or hot water bath to melt ingredients, fill a large saucepan 1/4 full with water and bring it to a full boil. Lower the temperature so that the water is boiling but not fully. Measure the ingredients to be melted into a heat proof measuring cup (such as one made by Pyrex or Corning) and place the cup into the boiling water. The heat from the boiling water will gently melt the ingredients in the measuring cup. Follow the recipe as usual. See similar questions...

I have a problem with too much dust/grit in or around my property. I don't know where it's coming from. See similar questions...

Most combination boilers (combi) are designed to take in cold, not preheated water and are thus not compatible with a solar water heating system. There are a few combi's on the market that will accept pre-heated water and you should check with the manufacturer whether this is the case if you have a combi, or are installing a new one and wish to have solar as well. See similar questions...

By installing an air elimination system external of the boiler to remove air form the water system, this is installed on the main supply pipe as the water leaves the boiler. See similar questions...

Yes, under normal circumstances. An additional storage tank will be required to be installed to pre-heat the cold water prior to entering the existing tank. See similar questions...

Yes you can. All you need to do is provide a Radiantec mixing valve to step down the temperature of the water to the radiant circuits. You mix hot water from the boiler with return water from the floor to provide a lower temperature. See similar questions...

A combination or combi boiler is designed to heat your water 'on demand' - when you turn the hot tap on, the boiler fires up and heats the water as it passes through. A conventional or storage system heats fires up for a given period every day and heats the water in a copper storage tank. This makes for a quick fill of the bath, but the downside is that the supply is finite and that no matter how well the tank is lagged, it will lose some heat. See similar questions...

The underfloor heating pump is used to pump water around the underfloor heating network. When the thermostatic head is satisfied with the water temperature, the head will shut off and stop taking water from the boiler. The pump then keeps the water pumping around the heating system. this expanable content box is made using a free javascript from flooble | get free javascript games and effects See similar questions...

The hot water that comes from the 600 ft. well is about 160? F. If the water were allowed to come to the surface, the temperature would be 135?. See similar questions...

The Commission must approve in advance any restoration, alteration, reconstruction, demolition, or new construction affecting any designated property, including buildings in historic districts. You need Landmarks Commission approval before you begin work on the exterior, if your proposed project requires a permit from the Department of Buildings. See similar questions...

In most cases, you will need to install a chimney liner if your chimney has an over-sized or deteriorated terra cotta (clay) liner. You must always install a liner if you have an unlined masonry chimney. Both the National Fuel Gas Code (NFPA 54) and the national Installation of Oil-Burning Equipment code (NFPA 31) compel installations of the chimney liner in these circumstances. boilers have increased in efficiency, the temperature of the flues gases has declined. See similar questions...

Base-exchange softeners replace calcium and magnesium ions with sodium. This has a tendency to increase the corrosiveness of the water because when sodium carbonate is heated it decomposes to carbon dioxide and caustic soda. Use normal 'mains' water which has not been processed through the water softener, together with System Inhibitor. See similar questions...

First check to ensure there is electricity to the unit. If not cooling, there is a thermostat on the back grill. Turn slightly to the right and listen for the compressor to start. If the cooler has a hot side, check the back to be sure the on/off switch is on. See similar questions...

The installation of a new system does involve new pipe work being fitted and heating controls being installed. We aim to ensure that disruption in your home is kept to a minimum, we will keep you updated on our progress at all times. See similar questions...