This vehicle has (2) 12 Volt constant wires, swap the power connection to the other power connection at the Ignition switch harness of this vehicle and replace Blown fuse out under hood.

Yes, Ultra Start remote starter systems are designed to interface with virtually any vehicle that has a 12-volt electrical system, this include cars, trucks and SUVs. All Ultra Start remote start systems are designed to work with automatic or manual transmission vehicles with gas, diesel or hybrid engines.

Yes, Ultra Start remote starters are designed with safety in-mind. All of our systems will shut down the engine if the hood is opened, the brake pedal is pushed or when the programmed runtime expires. Ultra Start systems can easily be placed into Service Mode. This disables the remote start function if the vehicle needs to be serviced. Click on the following link for more Safety Precautions.

Use the BLUE wire in the 18-Pin or 16-Pin Harness. This wire is used for aftermarket alarms and can be used as a test lead. The wire is labeled AMA Input or Auxiliary Input, and is usually taped off. Touch a momentary ground on the BLUE wire and you can either start or stop the vehicle. When you are finished, tape off the BLUE wire this will tell you that the Remote Starter is functioning and all is needed is a Replacement Remote Control.

Only approved ignition interlock devices can be installed. To see a list of those approved for installation in Kansas click here. If you received an ignition interlock restriction notice, you need to take that letter to the service provider when ready to have the device installed on your vehicle. If you do not have an ignition interlock restriction notice, you need to submit a request to Driver Control Bureau, P.O.

When installing the unit, Antenna placement is critical. If you are using the standard range unit which has the yellow antenna wire make sure this yellow wire is not coiled up or tied in with any other wiring. Bring this wire up into the dash as possible. If at all possible, bring the wire through the plastic of the dash (such as between the dash and the steering column) making sure that this wire is above the window glass area of the driver's door.

Yes, Ultra Start remote starters are available in both automatic and manual transmission models. To safely remote start the vehicle the user must follow a "Reservation Mode" or "Ready Mode" sequence. This sequences is used to ensure that the vehicle has been left in neutral. Click here for more information.

The 791 Bypass needs to be CLEARED; when the Bypass is CLEARED the RED LED will remain "ON". If this does not work, unplug the 791 and you have tripped the FACTORY ANTI-THEFT System to re-set it put the Key in the Ignition Switch turn it to the "ON" Position, OPEN the Drives Door and leave the vehicle set for 15 minutes to reset the Factory Anti-Theft System.

If the remote starter does not activate when the remote start button is pressed, the park lights will flash a diagnostic code. Count the park lights flashes and select the according FAQ question.

Depending on what Options or Accessories you wish to operate, you will use most of the wires on the Main Harness. To see what wires are necessary for Basic Remote Starting, check out the "QUICK INSTALLATION DIAGRAMS" under Installation Manuals on this website for your unit.

The normal install time is anywhere between 2 and 4 hours. Some basic Remote Starter Models have been installed in or around 1 hour if you or the installer doing the job have experience in installing units before.

Press and hold the Brake. Cycle the key rapidly in the key cylinder, off to run, (7) Seven times rapidly within (5) Five seconds. Remove the key from the ignition key cylinder and release the brakes. Unplug the control unit for 1 minute.

Go to http://technet.microsoft.com/en-us/subscriptions/manage/ and sign in to the Passport network. If this is your first time signing in, you must then complete the registration process using your subscriber ID or benefit access number, name, and email address information on file. If you did not provide an email address when you activated your subscription, please contact your local TechNet Subscriber Support.

Answer: If the ignition side seems OK look at other reasons. Have you got fuel? Is the fuel old? Modern petrol loses the volatile portions if left standing for more than a few weeks. (Example.) Try some fresh fuel. Have you done a rebuild? What else have you changed? Valve timing, valve clearance, carburettor, etc.

Reinstall WebRecord Pro. However, before installing, verify that your PC meets the minimum system requirements recommended to install and run WebRecord Pro. After reinstalling, make sure you have closed all other applications before launching.

It could be any of several things. Most likely, it's a problem with the service account (user account you specified during setup for the service to use as its security context). Here's a quick checklist: You may need to grant the service account the right to "Log on as a service." See the Manually Adding System Service Rights page for details. You may need to change the service account to one with full administrative privileges. RUM will not work with an ordinary user account.

To purchase an extra REMOTE CONTROL contact DIRECT WHOLESALE at 1-800-659-0764, have the Installation Manual along with the Model number for your unit when ordering a new Remote Control.

Well probably your hot-key does not work for some reasons. You need to assign and test another hot-key combination. To start program Control Center without hot-key you need to run setup.exe file (from Remote Keylogger install package) with /cc key as below: click Apply button to save new settings Now switch program to visible mode to test new combination. If it work normally, switch program to stealth mode again. Otherwise try to assign new hot-key combination.

The Remote Starter System that you have purchased is a Universal Kit. It will fit most vehicles. In some cases extra Relays are needed to operate features on one Vehicle, but may not be needed to operate features on another. If the Vehicle Information or Color Code Chart on the website does NOT state "BCM Controlled" Trunk release or Dome Light Supervision then a Relay Part 775 must be used.

This would be next to impossible. All remote starters have safety and theft prevention features built in. The ignition key must be inserted before driving, if not the engine will shut off when the brake is pressed. It is recommended to ensure the vehicle is locked at all times while the remote starter is in operation.