Yes, make sure to have access to the equipment area (spa door). This is located on all Bullfrog spas underneath the top-side control. Allow ample room for drainage. Attention: Normal installation is covered under the warranty but removal from a deck is not covered under warranty.

Even on poor soil conditions, your deck will not sink. Oz-Deck foundation system is designed to distribute weight EVENLY across the ground. It is essential that you follow the recommended spacing of Oz-Deck piers. A simple non-technical method to determine if your soil is suitable for Oz-Deck is the shoe print test.

Because HotTubs2Buy’s hot tubs have no metal or wood in them they lend themselves very favorably compared to the competition for sinking in. There are some things that need to be considered. Firstly drainage is vital as you don’t want the hole in which the hot tub is situated filling up with water as there is electronics in the base of the hot tub that could get damaged.

The majority of spas on the market today weigh less than 100 lbs. per square foot when filled with water. Any deck built to code would support 275 lbs. per square foot. That would allow any spa we sell to be placed on it with proper support.

We really don’t. It’s better you have at least a crawl space or a “crouching” space so you can service your spa. The side you will most likely have to look at is the electronic pack. The electronic pack is located underneath the top side controller.

A Backlash deck consists of up to 12 cards that contain no more than 6 Pre-match and no more than 6 Mid-match cards. They are not part of your hand and do not count as part of your Arsenal. The deck is separate.

Just contact us and reserve an appointment. You do not need to bring anything with you; we supply robes, towels, & slippers. All you have to do is show up. Although we will try to accommodate anyone who walks in for an appointment, we recommend reserving time. This will insure we have availability for the services you are looking for. Furthermore, if you have special concerns we will have the time to make sure you are booked with appropriate therapists.

Cartridge Filters: Remove the filter cartridge(s) and either clean or replace. To clean cartridge(s), first use a filter cleaner as per label directions. After rinsing the filter cartridge(s), completely submerge the cartridge(s) in a 1/10 solution of sodium hypochlorite (liquid bleach) and water for two hours. Inspect and clean the filter housing. Set the filters aside for installation after the spa decontamination is complete.

The floor sink must be accessible for cleaning, but you should speak to your local plumbing inspector for height requirements above the finished floor to ensure it is installed in accordance with the Uniform Plumbing Code. Check with the Uniform Plumbing Code and your local building department for specific rules and regulations.

The brown stain is from too much iron in your water. It is closely related to simple rust you see on metal, which is iron oxide. Probably the source of the water you use is ground water, and the water has filtered through rocks containing iron-rich minerals on the way to the well.

technology improves, companies are always coming out with a new heat sink or Fan that has the edge over the competition. Some of the most commonly used heat sinks among Overclockers included those made by Thermaltake, Swiftech, and Thermalright. Check out the Overclockers Club review section for reviews on various heat sinks to see what is right for you. If standard air cooling isn?t getting the job done, or has become too loud for you. There are a few more options that can help cool a hot CPU.

It is so simple! You can use your Spa Escape Flip Cards that come in your BeautiCase! Just follow them for the easiest way every to make money and have fun doing it! At a Spa Escape, you will pamper your guest(s) by using top of the line spa products to relax and de-stress them from head to toe!

Titanic was designed with a series of transverse bulkheads, separating her into 16 "water-tight" compartments. Unfortunately, these bulkheads, while extending above the water-line, were not capped with water-tight decks. Her designers considered a breach between two compartments a worse case scenario, and in fact designed her to float with any four compartments flooded.

Yes, all boats can sink (Titanic). Even so, it is very rare that a yacht will come into trouble when it undergoes rigorous inspections twice a year and has a qualified crew.

Absolutely, but measurements need to be taken to make sure they match each other. Please consult the local fabricator.

We have a model LS2C/C or LS2/C which has no rear risers and works great for any china sink that can be wall mounted.

A current sink is an ampere meter which has practically no internal resistance. Therefore, current sinks also are called "zero - ohm - ammeters" (abbr. ZRA). Current sinks are valuable if e.g. galvanic currents are to be measured without producing a voltage drop across the ammeter. So, they are capable to measure extremely small currents down below the pA - range.

It is recommmended that you lubricate underneath the running belt every 150 miles or every 3 to 6 months, even when it is not in use. Click here to view detailed instruction about how to lubricate the deck of your treadmill. Back to top

Yes and No! A multi-deck game has an inherent 0.5% - 0.6% disadvantage over a single deck game with the same rules. Much of this difference is due to the effect of removal of cards (i.e., removing one card in single deck has a big effect, whereas its removal in a shoe game is negligible). On the other hand, it is much easier to find good rules and conditions in shoe games.