No. Our products do not operate in this manner. Minimal benefit is netted when the product is doubled.

No. By placing two layers together, you will still only have one reflective surface. The only additional R-Value you will achieve is the additional R-Value of the bubble layer itself, which is an R.5.

R-value is an assigned number derived from a specific testing procedure to determine a materials (or building assemblage) "resistance to conductive heat transfer". The higher the R-value, the more resistant a material (or building assemblage) is to conductive heat transfer.

No. Products with R-values reduce rates of "conductive" heat transfer and are tested for this characteristic. Radiant Barriers provide benefit by dramatically reducing "radiant" heat transfer which is just as quantifiable but not related to R-value type performance.

R Value - the measurement of 'insulating ability' of the material. The higher the R Factor number the greater the insulation value. U Value - the measurement of 'heat loss' through the material. The lower the U Value the less heat is escaping.

A NRG Block is six to ten times higher in R-Value than a common block, which ranges from 1.5 to 2.5 depending upon the aggregate used.

Other blocks using inserts or hollow core blocks with poured insulation range between 5 and 6 for a 9 and 10" block.

R-value is a standardized measurement of thermal efficiency. The higher the R-value, the greater the insulating properties. Overhead Door manufactures insulated doors with a broad range of R-values designed to meet your needs. Our Thermacore® doors offer our highest R-values - up to 17.5.

The best analogy is to the way cartoons used to be animated. Each component of a scene would be painted on a transparent film, and then each film would be stacked or layered over the other to produce the complete composition. In this way, you could easily animate a person walking because his legs could be animated independantly of his body, for example. Similarly, complex images can be broken down to layers within GIMP and each layer can be processed independentlly of every other.

The R-Value is formulated using an inch of thickness as a measure. Due to the fact that Nansulate is made to go on in a thin layer - less than an inch thick - an accurate R-Value cannot be calculated for it. Nansulate works by acting as a barrier to heat transfer. It does not only insulate by trapping air, as other insulations do. Nansulate’s effectiveness can be seen in this energy savings demonstration, which shows how it can effectively insulate and slow down heat transfer.

That's a good question, but unfortunately the answer is not so simple, Window thermal performance is measured as a U-Value which Is the reciprocal of the R-Value ( R-Value = 1/U-Value. For example. R 2 = U .50, or 1/.50 = 2) A bit of background: the R-Value measures the resistance to heat loss or gain, while the U-Value measures the transmittance of heat through a material. The higher the number in R-Value the better the resistance, so the better the insulating value.

R-value and U-value are reciprocal to one another. The term U-value is measured by the amount of heat that escapes a surface-a wall, ceiling, or window. R-Value is measured by insulation value. How many glass layers there are in a window to the type of gas that is between the panes of glass, are some of the basis of this measurement. The higher the R-value, the better insulated are walls and ceilings. The lower the U-value, the better job a window does in keeping out heat and cold.