Use wall mounts to fasten the rails of the fence to a column. Wall mounts are small aluminum castings which go over the end of a rail and have holes to attach them to a flat surface. there are two types of wall mounts. The standard ones attach straight onto the column, while our adjuatable ones will allow you to come off the column at up to a 45° angle.

Yes, we have wall mount castings that slide onto the fence sections to allow mounting to any vertical surface. The wall mount brackets attach to the surface with two screws. See similar questions...

Yes, we have wall mount castings that allow the fence sections to connect to any flat surface. These fit over the ends of the rails and attach to the flat surface with two screws. We also have adjustable wall mounts if you need to come off the flat surface at an angle up to 45 degrees. (See photos at left.) See similar questions...

To fasten posts to a concrete slab, we always recommend that you core drill the concrete. If this is not feasible, then you may be able to use our deck mounts. These two-piece aluminum castings fit inside the bottom of a post and secure to the post though the expansion of the two pieces by tightening a bolt. Since deck mounts fit inside posts, fence styles with bottom rails may not work properly since the rails will be in the way. See similar questions...

The recommended procedure for restoring a wrought iron fence with this problem is to either sand blast or wire brush the fence to remove the rust. Once the rust is removed, you should apply a zinc enriched primer, cover it with one or two coats of finish preferably with a rust inhibitor. Just like your car, you can enhance the life span of an iron fence by simply cleaning and polishing the fence with a good automotive wax. BACK TO TOP See similar questions...

To attach fence panels to existing walls, columns or posts, you need to use rail end flanges (rail ends). These are screwed to the mounting surface and the rail end is inserted. If you are installing a UAB-200 pool fence, you must cut the top "ear" off the Rail End for the mid-rail as the spacing between the top rail and mid-rail (2") is too small to accommodate two full flanges. See similar questions...

With peel and stick neoprene automotive-type adhesive tape, or if you wish we will affix a magnetic strip at no extra charge. However, we cannot guarantee how well the magnetic strip will adhere in your application. From personal experience it won't survive an automatic car wash. See similar questions...

We will need to know the following information: How far out from your house is the eave? Are your overhangs supported with 2 x 4 or 2 x 6's rafters? How far apart are the 2 x? rafters? Your awning includes the required "flashing" to enable you to provide a seal at either mounting location. If at all possible, it is better to mount to the wall for larger or heavier Live Loads. Please consult with us as to your best type of installation (eave/wall?). See similar questions...

Only awnings "constructed of light-weight metallic material which does not exceed 1 pound per square foot dead load" may be attached to a manufactured home. For further information, contact the State of Nevada's Manufactured Housing Division. (See NAC 480.475) See similar questions...

There are many factors that affect the life of a fence, including, local climate, soil conditions, and the materials used to name a few. You can expect a properly installed fence will last a long time as long as it is appropriately maintained. Your fence professional should be able to help you decide which type of fence will serve your needs best. BACK TO TOP See similar questions...

No alterations to the exterior of any buildings are permitted without written board approval, and the charter of the board is to maintain the original design and appearance of the community. Permission is regularly granted to build privacy fences around the back yards of patio homes, as long as the fence design is consistent with existing fences, and the boundaries do not exceed the basic footprint of the house. See similar questions...

A column includes the total number of betting events chosen by a player, which must all be predicted correctly for the column to be a winner. A ticket may include more than one column. See similar questions...

No. What you do with your shed after we finish is up to you. But because we are classified as a "shed manufacturer," we can only build them as individual detached buildings. (return to top) See similar questions...

Check the "Autosize report dialog columns" box in Options and you will be able to resize the dialog columns for easy readability. See similar questions...