There is no required length of a cable for an Amplifier to be active, a standard cable comes with the purchase. Please consider each model has different length of cable.

The maximum length for a USB cable is 5 meters (197 inches). The power transferred through a USB cable that is greater than 5 meters in length will start to decrease, and the device may not function properly.

A We find that it is very important ... especially with high performance top-loaded antennas. Your safest bet is to use 18 feet (5.5 meters) coaxial leads on all of your CB installations.

The maximum length of a 1-wire cable is dependent on several issues such as the type of cabling. Thirty meters is possible with modular phone cabling,...

Any length can be used. This antenna is impedance matched to 50 ohms to allow you to use any length required.

Approximately 30 feet of shielded VGA cable, then you may need a distribution amp. Sometimes you can push this distance. Try the cable first, then order the amp if you need it. Some projector models have a Power off feature. If turned on, the projector will power down after some minutes of inactivity. This feature is to prolong lamp life. If this is painful, go to the power menu and deselect the power off option.

Length is not a restrictive factor. We have successfully treated submarine cables that stretched across Lake Erie that were 19,200 feet long.

Easy Engine v1.4 is designed for optimal performance with OS Windows 95, 98, 98SE, ME, NT4.0, 2000 and XP. Easy Engine is designed for optimum performance with DNA Engine and Tetrad software version 3.0B or higher. Using Easy Engine with other software versions (lower than 3.0B) restricts Easy Engine from some operations and features. These restrictions and limitations are applicable to "Explorer" and "Incubate" functions. "Monitor" functions operate normally.

Extending the main panel to the floor would create a large, potentially radiating surface area, if excited into vibration. I would recommend to extend the back spine and side panels, instead. The three legs would need to be cross-braced and solidly tied into a base. Suspending the panels from the ceiling is probably the optimum solution if hooks can be safely fastened to carry the panel weight. Rope and panel mass form a mechanical low-pass filter between driver cone movement and ceiling.

Yes. First make sure there will be enough room in the shoe to accept both the heel lift and the insole. Tape or glue the heel lift to the bottom of the insole.

Pro16 A-Net cables can be 500ft/150m between devices with Cat-5e. Pro64 A-Net cables can be 400ft/120m between devices.

The slot spacing on the M/B is fixed to 0.8" apart. For convenience and to allow tolerance on the cable, Adex typically uses 1" per slot spacing to determine the needed cable length. For example, if a cable needs to reach from slot 6 to slot 4, then the cable length would be 2". This applies to the single ended flexible risers, as well as the wide cable used on the combo risers.

Well its all a bit of witchcraft and nonsense to me but our engineer has given me the following advice.... Try to get customers to cut their aerial cables to these optimum lengths.

When filling in your billing and shipping information in our shopping cart you will come across a text box called “Comments or Special Instructions”. You can either tell us what width your laptop is and we will send you the appropriate cable length, or you can request a specific cable length (20”, or 26?”). If you make no special request for a different cable, your Jotto Desk will be shipped to you with the standard 22” cables.

The cable length was limited by a cable delay spec of 26ns to allow for reflections to settle at the transmitter before the next bit was sent. Since USB uses source termination and voltage-mode drivers, this has to be the case, otherwise reflections can pile up and blow the driver. This does not mean the line voltage has fully settled by the end of the bit; with worst-case undertermination.

m. however, if you cascade 5 hubs with 5m USB cables, this will allow you to connect a device 30m away.

Cable Lengths on Hunza fittings are generally 1 metre long additional length cable attached to these fittings would need to be at an additional cost.

Generally it is not recommended, though it depends on the cable and the frequency you are using. In general the longer the cable between the antenna and receiver the greater the loss of signal strength.

In general, it is best to purchase the shortest length of cable possible. However, please be aware that our Home Audio Cables are fairly stiff, and cannot be simply bent at right angles. This means that the Home Audio Cables must be significantly longer than the distance between jacks. For details on sizing cables, see the appropriate product sizing and installation guide (located on the relevant product page).