The super absorbent polymer is a non-toxic material in a fine granular form within the pad. This polymer actually absorbs many times its weight in liquid and basically turns the liquid into a gel form. The addition of the polymer allows the pads to hold at least 3 times as much liquid, as they did without it.

Punctuation marks such as : // / , ' etc. are not counted.) We only count actual letters or numbers. If you need all upper case letters, please limit the number of letters to 19, not including punctuation. See similar questions...

It could cost more to adapt a design than to begin from scratch for a small (or large) school, specific or unique programs, or special site restrictions. See similar questions...

If you're considering replacing your traditional telephone service with VoIP, there are some possible differences: Some VoIP services don't work during power outages and the service provider may not offer backup power. Not all VoIP services connect directly to emergency services through 9-1-1. For additional information, see www.voip911.gov. See similar questions...

Do not fire polymer clay to these temperature - it will give off toxic fumes. The same applies to styrofoam, plastics. Organic materials, such as leaves, seedpods, are fine, but should be thoroughly dried (to avoid little explosions as the water in them boils). Sometimes, this results in your studio smelling like you had a campfire in it. See similar questions...

Researchers are still in the process of trying to fully understand the nature of these antibodies. However, published studies have recently reported that fibromyalgia patients with a higher level of anti-polymer antibodies in their blood have more severe fibromyalgia symptoms than patients with lower antibody levels. This makes the APA Assay a valuable fibromyalgia test even though the circumstances surrounding antibody production are not yet completely understood. See similar questions...

Polymer degradation is the opposite of crosslinking. When the electron from an E-beam hits a molecule, it can break the molecular bonds. This is useful in a number of areas. Electron beam is used to treat Teflon (PTFE: Poly Tetra Fluoro Ethylene). Teflon is commonly used as a lubricant in inks; this requires the Teflon to be ground into a very fine powder. The E-beam is required to break the bonds within the long strings of the Teflon molecule in order to allow the grinding. See similar questions...