Once applied, refrain from washing the vehicle for 24 hours. Washing after that time presents no problem, and no special care need be taken for the film. However, the use of high pressure hoses may lift the film, so please avoid using them near the film. We recommend that you clean the film at least once a week, and wax the film 4 times a year.

If desired, film can be removed at any time by picking up a corner of the film and pulling the film off the vehicle surface at a 180-degree angle. If the film has been present a long time, or if the film and vehicle are cold, a heat gun or hair dryer may be used to soften the adhesive, allowing easier removal. If any adhesive remains on the vehicle after removal of the film, it can be removed by using 3M General Purpose Adhesive Cleaner, according to the package directions.

Paint protection film is a transparent polyurethane film that adheres to the painted surface of vulnerable areas on your vehicle. It can be removed without any damage to your paint. Our film is made by 3M and it is one of the most advanced protective coating products you can apply to your vehicle. Our new premium film, made by 3M's aerospace division is far superior than anything on the market today. There are some companies online offering "paint protection kits" for $19.

Once applied, refrain from washing/wetting/cleaning your bike for 24 hours. After this period, no special care need be taken for the film. Use same care and non-abrasive products used for the rest of your bicycle.

Yes. The film will cover vinyl stickers but there are two things to bear in mind. First, the sticker may come off when the film is removed, and second, vinyl stickers are much thinner than the PPF and there will be a small air gap around the sticker. This may not be desirable. There is no problem with graphics that have been clear-coated.

Yes. We recommend that you regularly apply wax (4 times a year) to the film to keep it from getting stained by dirty water and chemicals. When waxing the vehicle, some wax may build up along the film edges. This can easily be removed when dry with a soft cloth. Do not use any waxes containing dyes or waxes that are not recommended for urethanes. Abrasive polishes and/or rubbing compounds are not to be used.

A.It is possible, but the application would be difficult and expensive. This product is really intended for the most vulnerable areas of the vehicle.

The back of the Paint Protection Film is covered with a light adhesive, activated by spraying the surface with the Applicator Solution. (25% Isopropyl Alcohol, 75% Water)

The Paint Protection Film's 8 mil thickness make the film virtually invisible. What does this mean? When viewed from a short distance (approx.3 ft), the film is almost impossible to spot. The film's edges are only visible when viewed from a short distance

Film can usually be repositioned as long as the adhesive side of the film is still wet. It is important to avoid excessive handling of the film during application.

MTM Scotchgard Paint Protection Film can protect the hood, painted bumpers, painted grills, painted mirrors and those expensive-to-replace headlight covers.

Yes, it can be pulled off by using a steep angle. However, it will not come off easily. Also, you cannot reinstall that piece after you have removed it. Rather, a new piece must be installed.

We recommend that any repainted surfaces on your vehicle be professionally painted and fully cured before applying paint protection film. If you have touched up scratches or chips with a tube of "touch-up" paint and then apply paint protection film over it, the film will protect that area until it is removed. If the paint protection film is removed, it is possible that the area around the non-professional touch-up paint could peel off.