InFlame Fireplaces have a heat output of up to 9000BTUs/hr depending on the fireplace. This is guaranteed to bring ample warmth to any room in your home. A typical electric fireplace offers from 1500 to 5000 BTUs/hr (approximately.) so our entry level 6000 BTU/hr max. output fireplace will provide you with a great heat supplement.

There is minor assembly required but no installation. Sunjel? Fireplaces do not require natural gas, electrical or propane services, so they are completely freestanding allowing them to be placed virtually anywhere in a room . When you move, remember! You can take your Sunjel? Fireplace with you!

No. All Sunjel? Fireplaces are equipped with a manual shut-off allowing you to shut-down and re-light the fireplace at your convenience. Back to List

AXTRO® is capable of heating areas above 260 square meters (buildings constructed to regulation 10/91) with any number or type of radiator installed.

Solution: Gradually close the air control mechanism in order to keep the flue temperature within the comfort zone, between 250 and 475oF (150 to 250oC). If you do not have a chimney thermometer and would like to get one, visit your local Osburn dealer. Solution: Replace the gasket using a genuine OSBURN adhesive and gasket kit. Please consult our accessories sections. Solution: Put less wood into the fireplace. The fireplace will not produce as much heat and will not heat as long.

Solution: Use smaller pieces of wood and place them to allow proper air circulation between the logs. The same weight of wood cut in many small pieces will produce more heat than fewer, larger logs. Only add big logs when you have a good bed of red embers. Logs with a diameter exceeding 6 inches (153 mm) should always be split. Avoid stacking logs to the top of the fireplace. Solution #1: In many cases, a weak draft is simply due to insufficient heat in the exhaust system.

There are a few precautions to take before implementing this TV application. First, take a thermometer and tape it to the wall above the mantel (where the plasma TV will be placed). Then and build a fire, let it roar while. Check the thermometer. If the temperature is above 90 degrees then the area is receiving too much heat - either escaping from the front of the fireplace and rising up the face, or radiating through the chimney to warm the outside wall.

Yes. Aside from the fact that all of our fireplaces radiate heat from their fronts, there is still heat that can be withdrawn from the fireplace. Using the blower increases the airflow thereby maximizing the heat being conducted from the back side of the fireplace. Adding a fan is easily done if 110 power is hooked up to the electrical box inside the unit. If power is not already at the fireplace, it still may be possible but may be more costly.

More so. A Bellfires? will provide ample heat without the grills and fans. The special refractory material of the Rosin Design radiates a comfortable warmth into the room. This type of system has been used in Europe for over 65 years.

The product can not be installed in any area where its temperature could exceed 120?F. Solid wood moldings or trim may be used to buffer the product in these areas.

Operating gas logs in a fireplace can be similar to burning wood in the fireplace. Yes you will receive some heat, but it is impossible to predict how much. Gas logs retrofitted to existing fireplaces are primarily for aesthetic benefit. They look great, provide a large yellow-orange flame and are not particularly efficient. If heat is your primary motive for retrofitting your fireplace you should consider a gas fireplace insert. Either way, you'll have something easy to use and maintain.

You will need to consult the operating guide for your particular fireplace model. If you use another manufacturer's gas logs, you need to maintain the clearances they specify. You can only install vented gas logs in our wood burning fireplaces. No. Installing vent-free (room vented) gas logs into our fireplaces presents a potential safety hazard as these fireplaces have not been tested or listed by UL or AGA for these applications.

Sunjel? Premium is a renewable resource derived from 100% natural sugar-cane or corn. The alcohol that results from the fermenting process of sugar-cane or corn is called Ethanol Alcohol. Ethanol Alcohol is the cleanest and safest burning alcohol gel on the market today. It cannot self-ignite and can be easily stored at room temperature in a closet or cupboard. Sunjel? Premium has been tested and complies with all Canadian Government Standards.

Sunjel? fireplaces are virtually maintenance free and require a simple wipe down with a damp cloth every 3 to 4 months. The Sunjel? refill bottles are recyclable and can be disposed of in your local recycle bin. Back to List

Heat stroke is the most serious heat-related illness. It occurs when the body becomes unable to control its temperature: the body’s temperature rises rapidly, the sweating mechanism fails, and the body is unable to cool down. Body temperature may rise to 106°F or higher within 10 to 15 minutes. Heat stroke can cause death or permanent disability if emergency treatment is not provided.

There is an excellent wood stove with a not-so-excellent chimney. The problem was that the chimney had a good sized crack in it, which we repaired with aluminum foil! The wood supply is excellent too—lots of driftwood. Another problem is that a million wasps come out inside the house as soon as you light the stove and warm the house a bit.

The Sunjel? Premium burns for 2 to 3 hours depending on a number of variables. Humidity levels of your home and altitude are both contributing factors that may affect burn time. InFlame guarantees a minimum burn time of 2 hours regardless of the conditions of your home. The national average shows that the majority of Sunjel? Premium users receive a 2 1/2 hour burn time.