The insulation value is R19 (R13 with 2x4 walls) which may save a few bucks on your utility bills. The problem is that it costs more to build so your house payment goes up as well.

Yes. This is a simple change that in most cases can be done by your builder during construction. If you require the actual blueprints changed, please contact us and we can provide you with a quote. See similar questions...

We specify 2x4 walls however, The dimensioning method used allows the use of 2x6 walls without having to change many of the numbers if any at all. See similar questions...

Exterior: we call for 1x tongue and groove planking (plywood can also be used; however, it's more labor intensive as well as creates considerable waste of material), with either wood [cedar] shakes or shingles, or asphalt or fiberglass-impregnated asphalt shingles. However, a metal (aluminum alloy) roof can also be installed [over the sheathing base of the planks or plywood]. Interior: we call for drywall (a.k.a. gypsum board, sheetrock, or plaster board); however, t&g planks can also be used. See similar questions...

All cementitious or mineral constructing products should be protected from moisture during construction and before finishing. Ytong AAC is a cementitious material, but also a thermal insulating building material. Therefore, Ytong AAC must be protected against moisture to preserve the high thermal property of the material. See similar questions...

All first and second floor exterior walls are 2 x 4 wood studs. 2 x 6 studs may be used on exterior walls but adjustments may need to be made to interior areas to accommodate the thicker walls. Exterior walls in two story areas are typically 2 x 6 wood studs. All stud sizes are dictated by the building codes to meet the structural load requirements or the insulation requirements in colder climates, adjustments may be necessary to meet your local requirements. See similar questions...

In many cases manufacturers have built with 2 x 4 side walls or 2 x 6 side walls on 24” centers. However, all of our Karsten Homes are constructed with #2 & better kiln-dried lumber with 2 x 6 on 16” centers on all side and end exterior walls. Many manufacturers cut construction costs by installing vinyl-coated wallboard as thin as 3/8” on walls constructed with studs on 24” centers. This type of wall will “give” when bumped. See similar questions...

Yes, we offer a relatively thin block that mounts to existing timber, fibro, cement or brick veneer walls. Do you have futher questions? Then please visit the CONTACT US page for information about your closest Timbercrete Franchise. See similar questions...

Quietzone™ Acoustic Wall Framing has been designed for interior walls only. No acoustical testing has been done on exterior wall applications. However, theoretically the product could be used for exterior wall applications. See similar questions...

Just as a potential buyer wants to see the interior and exterior of the property before determining a purchase price, the assessors want to see the interior and exterior of the property to make an accurate determination about the market value of the property. The interior information of a property is essential in determining the estimate of market value. Without the actual information, estimates of the interior information have to be made. See similar questions...

Yes, of course. You may choose any scenes or rooms to be represented in the virtual tour of each property. Exterior shots are weather permitting. See similar questions...

The sink and shower walls are covered with a moisture resistant wallboard. Inside the shower the finished walls have pre-moulded shelves for toiletries. All surfaces are designed to be easy to clean. It's a vitreous china low-flow (1.6 gallon) standard toilet with a great track record. We can also install a 'high mount' toilet which is easier on the knees. See similar questions...

Yes, you may choose any scenes or rooms to be shown in the virtual tour of each property based on the respective package orders. See similar questions...

No. Before the police have a right to "stop and frisk" a suspect they must have a reasonable suspicion of criminal activity. Even if you doubt that the officer has such a reasonable suspicion, you should never physically obstruct or resist a police officer's efforts in this regard. Even if you pose no threat to the police, any physical resistance will be interpreted as a threat and the police will then be entitled to use "reasonable force" to subdue you. See similar questions...

Stucco (acrylic or cementitious) is adhered directly to the foam. Wood, plastic or metal cladding is mechanically fastened to the imbedded plastic ties. Stone and brick are attached according to design specifications. See similar questions...

Call 578-3186 to report a lighting problem. Please be as specific as possible. Include the number on the pole if possible. Most exterior lighting problems are repaired within two business days. See similar questions...

Alien players always spawn in at a hive and as a Skulk. The skulk has the ability to crawl on walls and ceilings. Just look up a wall and move forward. It takes some practice (and some getting used to), but good players will learn to use it to outflank their enemies and move quickly across the map. Wall-running can be disabled by holding the "crouch" key. This can be useful for dropping to the ground or in conjunction with the leap ability. See similar questions...

According to a BBC science website, some spiders secrete a small amount of the sticky silk they use for their webs onto their feet and use that to move across walls. Other spiders have specially designed feet that allow them to grasp the irregular surface of walls and ceilings. They cannot climb slick surfaces, because their feet have nothing to grasp. See similar questions...

Liz, The feet of insects including cockroaches are made up of a brush like pile which reacts with a surface like myriad weak suction cups. The weak forces involve adding together thousands of such individual adhering pillus ends and result in a strong enough force to suspend the body of a fly, a roach or even larger non-insectal critters such as lizards. To step the cockroach must remove the pilli individually in a wave, like ripping off some cellophane or an adhesive bandage. See similar questions...