No it really doesn't matter what colour the water is, as stated it is a combination of many different factors that will cause colour changes to occur during a Q2 session.

No, it really doesn't matter what color the water is, as stated it is a combination of many different factors that will cause color changes to occur during a Q2 session.

Once you begin using the Q2 Water Energy System you may notice changes in the color and the deposits left in the water after use. The first thing you need to understand is what the Q2 Water Energy System is designed to do. The unit is specifically designed to act on water because your body is primarily made of water (up to 85%) and it is this action that makes the Q2 Water Energy System Unit so effective when you use it.

Such a simple sounding question, with such a complicated answer! This thread holds the record for longest thread on the forum. Make sure you have a couple of spare days if you want to read all of it!

One of the most common water treatment problems found in well water is iron. The WATERMAX is the system to treat/remove iron. Iron can be found in 3 different forms: Ferrous iron (dissolved) - Although not visible it is the most common type of iron. When oxygen is mixed with ferrous iron it stains sinks, toilets and clothes in the laundry, especially when bleach is added. To reduce levels of ferrous iron, either softening, aeration or a combination of both is needed.

The colour change in the water can be attributed to a multitude of variances including, the water quality you are using, your health status, and the weather conditions, just to name a few.

Salt, water, metal (the array), and sweat combine to cause the change in colour. This is a normal process. The colour will vary according to the chemistry found in the water. Sweat has a colour itself due to the toxins/chemicals present. This is seen in “ring around the collar,” the waste products that are perspired out and become imbedded in the collar of your shirt! It is interesting to see the different colours the water changes with different people.

The problem of brown water (a discoloration caused by tiny rust particles) arises from some of the village's water main pipes in the ground, and to a lesser extent from the plumbing in older homes. The nearer to the end of a dead-end water main that a home is, the more brown the water may be from sitting motionless overnight. These unfortunate dead-ends were created decades ago, when rapid, less enlightened development led to some sub-par building practices.

Yes. Leon and a cabal of supporters bought the 'official London.pm colour' at YAPC::Europe in 2002. Since there's not really anywhere for it to manifest itself other than this site, london.pm.org is now bright orange, with brown bits.

I want to dig on my property and I would like someone to locate all underground utility lines (water, gas, hydro).

If you have high colour in your water it is most likely a concentration of tannins. High tannin levels are found in most surface water supplies and some groundwater or simply in waters where large quantities of vegetation have decayed. Unfortunately tannins cannot simply be removed from water by a physical means of filtration. Tannins can be described as a colloidal suspension as it carries a negative charge and therefore will not simply fall out of solution like turbidity does.

Although the pH of your sparge water is not going to make or break your mash, for maximum sparge efficiency, the pH of sparge water should be 5.8 to 6.0

water before and after with the TDS meter. Start with 400 ppm (10% plus or minus), measures the number of solids at the end of the session. YES. The warmer the water, the greater possible change in the color of the water, but not above 106°-.

Most thunderstorms occur in the late afternoon. By this time of day, the sun is setting. The orange hue is caused by the same process that causes the vivid colors at sunsets. Shorter wavelengths of light (blue) are scattered quickly, leaving only the yellow-orange-red end of the spectrum.

Does it matter where you get your glasses or who you see for other health-related issues? Certainly. See someone that is highly trained so that he/she can offer you sufficient skill to meet your hearing needs. Also, see someone that you are comfortable with. Are they out to help you and meet your hearing needs or are they always out to “sell you something?” Hearing aids are extremely labor intensive. Hearing aids will not restore normal hearing functions and are subject to breakage.