Follow the basic instructions in our wallpaper removal guide for the type of paper being removed. Wall damage may be unavoidable.

No. The DuctStat must remain accessible. You will have to switch the function switch to HEAT for the winter and COOL for the summer. You may also need access for service, cleaning or to replace the front panel fuse. See similar questions...

No. A skilled and experienced waterproofer can install a complete system without disturbing the finished walls. See similar questions...

A : For most residential applications, conventional methods of snow removal are acceptable (ie. shoveling or snowblowing). Care should be taken to make sure the skid plates are set to maintain a clearance between the snowblower and the bricks so as not to scratch the bricks. Please note, the use of heavy snow removal equipment may damage your brick or the installation. Ice melting chemical products which do not contain calcium chloride are recommended for use. See similar questions...

Yes, you can finish the drywall just as you normally would. The only difference is to make sure Quietzone™ Acoustic caulk is applied along the corner of the first layer before applying the second layer of drywall. See similar questions...

Yes, in 99% of cases. In order to remove the Graffiti safely and effectively specialist pressure cleaning equipment and procedures are required. To assess your individual graffiti removal requirements please Contact Us or submit a Free Quote Request. See similar questions...

A:Yes, it's not hard to remove just grab hold of a corner and gently peel away. If the letters stick just warm them for a few seconds with a blow dryer to soften the adhesive backing underneath. See similar questions...

When installing, we recommend using a dry cellulose paste (included with most wallpaper murals) or a strippable, clear, non-staining ready-mixed paste. This will allow you to remove the mural for redecorating without damaging the wall. Don’t forget to shop Wall Decor Shops when you decide to redecorate! See similar questions...

Far and away, I recommend a product called "Goo Gone." Its available at retail outlets like K-Mart. It can be found in the cleaners section or sometimes in the automotive section. It is a citrus product and will not damage the card if used correctly (do not over-apply and allow to soak into the card). Others will tell you to use things like: rubbing alcohol, nail polisher remover etc. These things also work but may leave a dull spot on the card by removing some of the card coating. See similar questions...

DISCLAIMER: AutoAnything does not recommend removing dash trim kit pieces after install and will not be held responsible for any possible damage to your dash. While the dash kit piece is still warm pull on it (we do not recommend using screw drivers or any other metal tools - use your fingers and plastic objects). To get rid of any 3M glue residue, use a soft cloth. You may want to apply Bug and Tar Remover and gently rub surfaces where dash kit was attached. See similar questions...

We recommend using Draw-Tite over the damaged drywall prior to smooth coating with drywall topping compound. This should be primed or sealed prior to painting or re-hanging wallcovering. See similar questions...

Mechanically with drywall / gypsum screws into the polypropylene webs. Frequently an EPS compatible adhesive such as Foam2Foam is used with the screws. Question: How do you hang pictures? Normal to lightweight pictures can typically be hung using a picture hanger with a nail driven anywhere into the sheetrock just like in frame construction. See similar questions...

Unfortunately the answer to this question is YES. Existing paint or coatings on the wall will stop our waterproofing products from working properly. AQUA-STOP penetrates deep into the concrete and it cannot do this if there is a barrier of paint in the way. Although AQUA-BLOCK BB is a coating, it has special ingredients that allow it to form a very strong bond with concrete, brick or stone and this adhesive bond would be severely compromised by an existing coating. See similar questions...

If the material is fixed directly on the wall, the wall may not be in perfect conditions when removing the sheet. Therefore, it will require further treatment for perfect restoration. If the wall is not meant to be visible, and you will not apply a finishing coat of plaster on it either, you can lay on or again, just by using frames. See similar questions...

Yes, you can. For detailed directions, look up the owner's manual or wall-mount kit instructions, because all such models can be easily wall mounted. Such kind of intermittent issues can prove to be very tricky. I would recommend contacting both your dealer and the Sony technical support team in order to avoid problems that may crop up in future. From your description it is tough to understand the possible issue with your TV set. See similar questions...

To remove, heat the lettering with a blow dryer. Once the vinyl is warm, use your fingernail or tweezers to lift one of the corners and gently pull the vinyl lettering off. Note that some darker paints will fade over time due to sun exposure and may cause the area under the lettering to be darker than the surrounduing wall color. See similar questions...

The adhesive we include with each wall mural is a "dry-strippable" adhesive. Your wall will not be damaged. This makes wall murals an excellent choice for decorating apartments and dormitories. See similar questions...

I removed those mirror tiles once, I used a long knife, about 12" long, BE CAREFUL. Then I used a glue remover from local store, like Go Off. I agree with the long knife theory. However, caution must be used. I was not able to remove the mirrors whole and several of the pieces broke. Also, have a plan on what to do with all that glass once removed. That will be you next problem. Usually you can skim coat the wall to a regain it original appearance. See similar questions...

Frame moulding is the term used to describe material that is cut and joined to be assembled into a picture frame. Hand carved picture frames, gold picture frames and metal picture frames are among the thousands of different frame styles available. Wood and metal are the materials most commonly used to make moulding and are offered in a variety of stains, glazes and finishes. See similar questions...

Mouldings are usually sold in 1.8 to 3m (6ft to 9ft) lengths, from specialist art shops, picture framers, or a builders’ merchant. You can purchase these by the length or cut to size if the supplier offers such a service. This is called a ‘chop’ service, and is a good way to get started. A chop service can be mitred to the exact size or square cut so that you do the final mitre cut. See similar questions...