The dimensions of our motorcycle license frame are shown below. We know there are a couple of states this does not work for, but we haven't found a good personalized frame option for you folks yet.

Our license plate frames are high quality metal. They are made of zinc oxide and finished in silver (chrome), gold and black. The durability of the finish on the gold frames depends on environmental conditions and exposure and cannot be guaranteed, especially in cold climates where chemicals are often used on the roads. On the roomy side and run very true to size. Adult t-shirts are longer than Ladies T-shirts, broader through the shoulders, and have longer sleeves. See similar questions...

The dimensions of our auto frames are shown below. We've had some people say that the lower part of the frame blocks too much of the registration stickers required by some states. We are looking for another good option for them. In the meantime, if you have screw holes on the bottom on your car, we will mount the personalized strips with the longer end on top if you want. Just call or email if this applies to you. See similar questions...

NONE. The great thing about GEM is that it is powered entirely by electricity. You can avoid long lines at the gas pump as well as high gasoline prices. No. GreenEmotor electric motorcycle does not have an exhaust pipe to emit fumes. It is powered entirely by electricity. See similar questions...

PennDOT offers a person with disability plate that provides parking privileges and they offer a person with disability parking placard. (The placard hangs on the vehicle's rear view mirror and provides the same parking privileges as the person with disability plate.) Unfortunately, they are unable to offer specialty plates with the handicapped insignia on it. A customer can apply for a PA Breast Cancer Coalition plate and apply for a person with disability parking placard. See similar questions...

The answer to that is yes. Oklahoma requires everyonewho rides a two-wheel motorized vehicle to obtain a motorcycle license. See similar questions...

If you plan to ride on the 'roads' then yes you must be a licensed driver and your vehicle must be licensed as well. However, a drivers license is not required to ride 'off-road'. See similar questions...

The inside dimensions of the container shipping company containers are 98" long by 44.6" wide by 47.6" high. Also, if you provide your own crate it may not exceed the following dimensions 98"L x 47"W x 50"H. See similar questions...

Yes- Motorbikes, mopeds and any other licenced vehicle (with an MOT) can participate in the Transfer process. See similar questions...

Yes. As long as the plate is available and not registered to a passenger vehicle or another motorcycle, you may place the order. The fee is $23.00, and the plate will be made in the 'Wave' design.... | more See similar questions...

Unfortunately, no. These plates are issued in sequential order only. They can not be personalized in any manner. These plates are not “pre-manufactured”. They are manufactured as the applications are received…in sequential order. return to top See similar questions...

The PBCC sends applications to PennDOT in batches around the 15th and the 30th of each month. Once PennDOT receives an application it takes about 6 weeks until the license plate arrives in your mailbox. Why? Because these specialty plates are not pre-made. They are made in consecutive order as applications are submitted. Please be patient! return to top See similar questions...

Make sure you are installing the ATV License Plate Kit in the proper area. The proper area should be your grab rail in the back of your quad or the luggage rack. If the clamps are still too small, try removing the rubber grommets that are wrapped around each clamp. If the license plate clamps are still too small, use the wire ties that are included in each package for installation. See similar questions...

The earliest license plates on actual "motorized vehicles" were probably used in France in 1893. There were early registration plates in use on carriages and wagons in the US (as far back as the early 1800's), but I don't know if you could actually call these "license plates", per se. In the United States, the first license plates used on automobiles were seen in New York, in 1901. The N.Y. See similar questions...

The standard Plate measures 2-1/2" wide x 2-1/8" high by .020" thick. This plate is best suited for notebook computers, desktop computers, etc. See similar questions...

Whilst you don’t need a license to hire a motorbike, you can be arrested for driving without one, so be sure to have your home country license if not an international license. Also be aware that you will not be covered by insurance if involved in an accident on a rented motorcycle, despite what you are told. It is important to keep this in mind when choosing to hire and ride around in what are often dangerous conditions for inexperienced riders. See similar questions...

Our ATV License Plate Kit does not make your ATV street legal. Some states do allow ATV's to be used on the road when outfitted with the proper equipment. However, the ATV License Plate Kit is for displaying your off- road registration decal and/or assigned numbers on the back of your ATV. See similar questions...

No, a license plate cannot be given or transferred to someone else. Section 320.0609(1)(a), Florida Statutes, requires that the registration license plate and certificate of registration shall be issued to and remain in the name of the owner of the vehicle registered. However, a personalized license plate may be relinquished to someone else. See RS-27 for more information. See similar questions...

For the BRC you will need either a valid Class M permit or Class M license. You MUST have a valid permit or license for the entire class. See similar questions...