On a GT you can run a single 7/16 spacer and a 15x3.5 in front skinny. The Cobra is a lot more involved. You need to run 2 spacers and put longer studs on for the skinnies to clear the calipers. There have been some questions regarding this mod being legal and safe for certain racing groups but it does allow you to keep your Cobra brakes and run skinnies.

When checking tire size it's not necessary to measure anything. The diameter of your existing hubcap or rim is not your wheel/rim size, and will not give you the correct dimension. All tires have a "size series" printed on them that contains the wheel/rim size. This series of numbers usually begins with a P. - (example: P175/70/R15) In the tire "size series" the two digit number following the R denotes your wheel/rim size. (In the example the wheel/rim size is 15")

These are maximum recommended tire sizes for a given rim width. Now before the arguments start, these recommendations come from the TIRE manufacturers, NOT motorcycle manufacturers.

Yes, on all wall and floor tiles. Correct spacing allows movement of the building walls and floors without the tiles cracking or blowing.

The first step is to determine how much lumber you’ll dry in a year. Then figure your average drying time for each of the species you’ll be drying, and you can calculate the size kiln you need from there. For example: you need to dry 500,000 board feet of oak per year. Fresh off the saw, oak takes about 28-30 days to dry, so you’ll be able to do 12 loads in a year. Each load will need to be 42,000 board feet to give you the 500,000 board feet you need for the year.

Separators are tiny blue rubber bands placed between the teeth to make room to fit molar bands needed for some appliances. [Back to top]

A RIM, otherwise known as a Remote Integrated Multiplexer , is a device that Telstra uses to provision telephone services in areas where there is no existing copper, or the existing copper in the ground cannot support the demand for services in the area. Virtually all new housing estates have telephone services supplied by a RIM. Large office buildings, shopping centres, apartment complexes and the like are all "prime candidates" to be served by RIMs.

No, you do not need to use tile spacers to install the tiles. The chamfered edge provides an elegant look when installed "tile to tile". The 45-degree chamfered edge provides a natural caulking channel when the tiles are butted together. The XT-200 mastic allows sufficient time to adjust the spacing "by eye" for difficult areas. *Tile spacers can be used if you require large grout lines.

ThermoBloks should be installed with gaskets, which is why most kits contain extra gaskets for the spacers. Users may elect to apply a "sensor safe" gasket sealant such as Permatex #1 instead. The 1/4" (6.35 mm) addition to the runner length will indeed shift the torque curve to the left slightly, about 50 RPM. This has actually been proven to be a benefit as it helps to restore some of the torque lost due to the addition of larger intakes and exhausts.

The general rule of thumb in aquarium keeping is to have no more that one inch of fish per gallon of water. Thus, if you had a twenty gallon tank (with no substrate or rocks to diminish the total water volume), you could have five 4-inch fish. This formula also assumes you will change 25% of the tank volume each week. See What is a water change? Why is it important? for more details. Realistically, however, you will need to consider the following factors when choosing what size tank to purchase:

Weight distributing is based on the amount of loaded tongue weight the trailer has. To purchase the correct size weight distributing hitch (WDH), you will need to first load the trailer as you would tow it down the road and then have the tongue weighed. You can weigh the trailer tongue by using a bathroom scale or taking it to your trailer dealer to have the tongue placed on a tongue scale.

While there is no such thing as "too much" power in a sound system, the system should be powerful enough to fill your room. To help you pick the right product, each HSU speaker and subwoofer has a "Loudness Level" index —a rule-of-thumb guide to point you towards the best system for your space.

Our measurements are given in stem thickness first followed by internal diameter/length eg.: 1.6 x 12mm. Our rings are always measured internally. Straight and curved barbells are always measured between the balls. On curved barbells (eg., belly bars) measure the shortest distance between the balls along the inside of the curve. Inches to millimeters conversion (you my need to round up or down to the nearest whole mm as necessary):

Tiles can be laid with readily available plastic spacers, thereby achieving a uniform gap, and the same can be grouted with suitable grouting compounds.

This is a common question made by people that don't fully understand the operation of the system. The throttle body spacer is not meant to keep the throttle body cool, but is meant to keep the intake manifold insulated from the heat of the throttle body. Remember that most throttle bodies are heated by engine coolant to keep ice from forming in cold climates. This heat transfers from the throttle body to the intake so that the intake is now effectively heated from both ends.

Answer: Yes. You should request special pricing when you have a variety of similar items. We have made groups of items that had the same OD & same ID but the lengths were different. In that case, we calculated all of the parts as one quantity and added a small 'change-over' fee for the length changes. The result was that the customer saved money and we won the order. Answer: Aluminum has proven to be the most economical way to make spacers most of the time for a variety of reasons.

The smallest size we carry is 6 5/8. The largest size is 8. We will always carry core products in full size runs -- 6 5/8 through 8. Unfortunately, our vendors do not always make "Limited Edition" styles in full size runs, so they may be unavailable in smaller and/or larger sizes. We are always working with our vendors to expand size ranges offered.

No, the North and South Rim Drives plus the White House Trail are self-guided activities you can do without a guide or backcountry permit. The rim drives and trail are open all year long.