No. Typically the service provider controls "burst" traffic, not the router. For example, this is common in Frame Relay environments where a service provider will give a customer 128k of a committed information rate (CIR) that bursts up to 1Mbps. In environments (Frame Relay) where the WAN has a CIR and a burstable traffic rate, the router supports FRTS to shape traffic to adhere to the CIR limits. See similar questions...

The amount of bandwidth required is directly related to the number of participants is the conference, especially the number of participants whose video/audio channel are opened. When a speaker chooses 64 kbps as his video quality, an average of 100 kbps needs to be uploaded. Similarly, receiving one video/audio requires a download of 100 kbps. See similar questions...

To effectively remote control the iBEAM OnSite camera, we recommend at least a 256 kpbs upload speed. iBEAM Handheld systems will work with any speed connection. Your image quality will always stay the same; only the frame rate changes with a slower connection. See similar questions...

IQue uses a Dynamic Bit Rate. IQue's presentations are cross-platform and work in multiple browsers. To maintain this compatibility, IQue's presentations are in two classifications: Dial-up and Broadband. If you have a choice between Dial-up or Broadband and you click on Broadband, IQue's servers automatically will select the best bit rate for your connection. Then every three seconds the server will select a new bit rate based on the result of the previous three seconds. See similar questions...

Each remote network channel consists of a 22 Kbps packet flow in each direction. To prevent overloading the link, voice traffic should consume no more than 33% of the available bandwidth. The following table provides a guideline for the minimum bandwidth for the number of remote channels planned: If the measured link bandwidth is less than the recommended amount, you can expect voice quality problems. See similar questions...

OSPF picks up the highest IP address as a router ID. If there are no interfaces in up/up mode with an IP address, it returns this error message. To correct the problem, configure a loopback interface. See similar questions...

Vetrap tape sticks very nicely to itself. The likelihood of end "flagging" is reduced by relaxing the last 6" and pressing it into the bandage. For racehorses, one or two bands of vinyl tape are often applied to the end of the tape to provide additional security. For other bandaging applications, a strip of adhesive tape can be used for additional security but Vetrap tape is often used without any additional taping. See similar questions...

When the event allows for concessions the applicant must complete all proper permitting applications from the Summit County Health Department. Additional licenses are required for the sale of beer or liquor as well as a Building Permit for the placement of temporary structures. See similar questions...

Maybe, but probably not. 99% of all orders we make and ship throughout the United States do not have any permit information on them. But since it's really a local issue, you should check with your city, county or township office. See similar questions...

Due to differing time-zones from which participants will be working and the online nature of the activity, there are no official participation times throughout the project. However, it is expected that students will be able to spend at least 10 hours per week contributing to the project. As this is an online project, regular participation throughout each week is crucial for successful group dynamics. To visit the community only once or twice a week is not enough. See similar questions...

My Vigor router does not seem to be invoking QoS. I think the problem is that online status reports my connection downstream speed as 1.5Mbps - but my ISP plan has much less bandwidth. See similar questions...

b NIC/Router is not fast enough to drive a WiFi 10Mb+ connection to its full speed, you will get well under 7Mb. If you want to get the full XL service speeds (see Q36 for current speeds) you will have to ensure that your wireless NIC's and/or wireless router are capable of at least 54Mb (802.11g). See similar questions...

The priority and bandwidth commands differ in both functionality and in which applications they typically support. The following table summarizes these differences: For more information, refer to Comparing the bandwidth and priority Commands of a QoS Service Policy. See similar questions...

You are encouraged to take advantage of this service to save yourself some waiting time at certain restaurants. When you call 407-939-3463*, you will get a Priority Seating number. Upon your arrival at your dining location, please present your name and Priority Seating number at the podium. This is not a reservation and your party will be seated at the next available table that will accommodate your party size. See similar questions...

Both NEC and Nortel offer ACD (Automatic Call Distribution) software systems that will allow calls to be held in priority queue. These can be installed as an option for additional costs. Please call you sales rep or our service department for further information. 604-856-9155. Hide Answer See similar questions...

Each level of service comes with a given amount of bandwidth. You may purchase more bandwidth for $5/mo for every 20G extra. You will be contacted if you go over your bandwidth limit, but you will not be charged automatically. If you are only a little over your quota, you will be able to buy bandwidth starting on the next month of service. You may then elect to buy the extra bandwidth, or try another option. See similar questions...

Our bandwidth limits are soft caps. You’ll receive an email notification when a slice reaches 80% of its limit and again should it exceed the limit. If you trickle over because your site is Dugg or Slashdotted, congratulations! Send us a note with an explanation, we’re reasonable people. Overages are .30/GB. If you anticipate excessive bandwidth and would like to plan for this, please let us know. See similar questions...

Our current hosting arrangements provide the site with a large 250GB monthly transfer. If this should prove insufficient, we will upgrade the site to a higher bandwidth. See similar questions...