SANI-TRED products are not just coatings, they are permanently flexible, ultra-adhesives which deep penetrate and bond to all basements surfaces. The adhesive bonds made with SANI-TRED products between unlike materials such as; All such bonded joints will break, during destructive testing, at other than the bonded joint itself.

If you do not intend to finish your basement walls, meaning covering them permanently with stud walls and sheeting, then it is not always necessary to remove all old existing paint before SANI-TRED installation, as long as good common sense understanding of the importance of the removal of the peeling painted areas are understood and accomplished. It is common to have100% waterproofing success by removing only 50% of the old paint. See similar questions...

There are many options for finishing a project. My standard finish includes dyes, wiping stains, sealers and lacquer. Dyes and stains used together produce a much deeper color (and darker if preferred) without "muddying" the finish. Grain patterns remain visible and can be highlighted if desired. I generally mix my own dyes and stains to attain a color that I am trying to match. Glazes highlight the pores and grain patterns. See similar questions...

A permit is not required for the installation of interior wall finishes or the construction/alteration of non-load bearing walls/elements. However, if there is new plumbing for a basement washroom then a plumbing permit is required. See similar questions...

Most projects take about 6-8 weeks from start to finish. However, factors such as the size of your space and your choices in finished materials can affect the length of time to complete your project. See similar questions...

Sure! Since StablWall sits tight against the wall, there is no precautions, building out, or complications that you have to watch out for. It can be drilled through (to install studs or furring strips) without any danger of weakening it, since it is bonded directly to the wall. See similar questions...

We have all the information you need for finishing our beams on our website at FauxWoodBeams.com/beams_installation.php. We recommend using an acrylic deck stain. An acrylic deck stain dries in about an hour or two as compared to a gel stain that about 24 hours to dry. Also a good deck stain will have a UV protector in it to prevent the finish from fading. Oil base stains do not work well with our products. See similar questions...

The Basement Watchdog batteries have been designed specifically to work with the Basement Watchdog backup systems. They are the only batteries that accommodate the fluid sensor, a very important feature for maintaining battery performance. They are constructed to provide longer pumping times than most other batteries, and to last longer in a standby mode...usually 5 to 7 years. See similar questions...

Ultra Finish uses only the finest products to insure longevity, durability and quality. We only use products from major manufacturers such as Benjamin Moore, Porter and Sherman Williams. We will assess and customize each job individually in order to provide your home or project with the best suitable products. See similar questions...

Malm's wax can be used on these surfaces in most cases. However, some surfaces may be very absorbent and you should test in a small area first. You can use our polish on fiberglass and chrome with excellent results. When using our polishes, lighten up your hand pressure on the last 10 to 20 strokes. This will give a better gloss and more control when trying to prevent those tiny scratches. See similar questions...

The 3M automotive tape does its job very well, and removal of peel-and-stick trim products may cause damage to auto paint if you are not careful. While installation of our Chrome grill inserts does not cause damage, removal may, in some cases. The plastic clips hold tightly, and may possibly cause paint chips when being removed. Some models have 3M tape to supplement the clips, and the same precautions noted above must be taken when removing the tape. See similar questions...

Property owners often insist that something is done to try to prevent water from entering the basement in both new and remodeling construction projects. Most local building codes require that "an exterior coating" be applied to the foundation walls before backfilling. This does not prevent basement leaking, it only satisfies the local building code and contractor requirements who are not educated on how to waterproof basements on the inside using SANI-TRED products. See similar questions...

to 6' 8" if interconnected hard wire smoke detector is installed on both sides of girder and at top of stairway See similar questions...

All races share the same finish in beautiful Chumash Park. Look for the large red arch. All races finish on the grass. For spectators, the last tenth of a mile is highly visible from many locations in the park. See similar questions...

Yes. The majority of our homes are built over full basements. Depending on the topography of the land, either a full basement or a crawl space can be used since our pre-cut log homes are constructed upon "conventional" sub floors with ease. See similar questions...

Most of our products come with a black powder coat finish. They are sandblasted and cleaned before powder coating. Each product lists (on the individual product page) the finishes available. Most products can also be special ordered in other powder coat colors or non-powdercoated. Please check the individual product you are interested in. See similar questions...

sharable link ] No your trade determines what your assembly ability is. If you are a blacksmith you can put weapons that are primarily metal together. it stands right now, the first series of work order quests for ship building revolve around interdependance rather than group work. [The work does not have to be simultaneous - Aradune Mithara]. So that capability in the future for group crafting, should we desire to move in that direction is there, but we probably won't launch with it. See similar questions...

We offer a natural oil finish with two coats of linseed oil. A harder, pre-catalized lacquer finish is also available in satin, semi-gloss or gloss. Lastly, Polyurethane and Marine Varnish are also available. See similar questions...